Evolve LTM-5
Contents
1. LIM 5 Product Description Specifications 2013 PRODUCT OVERVIEW 3 Way Accessory Switch The Evolve 3 Way Wall Mounted Switch is a component of the Evolve lighting control system and is wired in place of a standard wall switch in any existing environment Inclusion of this Switch on a Z Wave network allows remote ON OFF control and dimming of the loads connected creating virtual 3 way switches It s fully compatible with Z Wave security systems and does not directly control a load rather it Communicates with other load controlling devices or plug in modules This 3 Way Wall Mounted Switch is designed to work with other Evolve enabled devices Evolve nodes of other types can be included in the network and will also act as repeaters to increase the range of the network The Switch also has a replaceable trim ring available in assorted colors As part of a Z Wave network the LTM 5 will also act as a wireless repeater to ensure that commands intended for another device in the network are received This is useful when the device would otherwise be out of the radio range of the wireless controller e SKU LTM 5 e Supported Networks Z Wave Signal Frequency 908 42 MHz e Range Up to 100 feet line of sight between the Wireless Controller and or the closest Evolve Receiver Module e Power 120 VAC e Dimensions 4 5 H x 2 75 W x 1 75 D Weight 0 31 Ibs 2013 PRODUCT OVERVIEW Wiring The LTM 5 does not contro2. TM 5 is then used to create a virtual 3 way circuit where the LTM 5 communicates wirelessly to the load controlling switch to either turn on turn off or change the dim level of the circuit In the pictured example above the left hand side switch has a 120VAC neutral and load wire everything required for either an LSM 15 or LRM 1000 The right hand side switch has 120VAC and 2 wires that travel to the left side switch To add an LTM 5 to the right hand side the electrician would need to tie one of these 2 wires to neutral at the left side switch If the application called for the load bearing switch LSM 15 or LRM 1000 to be located on the right hand side then both a neutral and load wire would be tied together at the left side switch
3. l a circuit directly rather it communicates wirelessly to another associated Evolve device which in turn controls the required circuit As there is no load control from the LTM 5 it only requires 120VAC power and neutral to operate e Black represents the line input 120VAC e White represents the neutral The switch also has a green wire which serves as the ground While there is a yellow wire present it is not needed and should be cut and capped with either electrical tape or a wire nut For operation after the LTM 5 has been successfully programmed e If configured to work in conjunction with an LSM 15 Tap top paddle for ON tap bottom paddle for OFF e If configured to work in conjunction with an LRM 1000 Tap top paddle for ON and the LRM 1000 returns to its last set brightness which does not necessarily mean full brightness tap bottom paddle for OFF 0 brightness push and hold top bottom to control dimming level This device is frequently used when creating virtual 3 way or 4 way circuits Below is an example of proper wiring when converting an existing 3 way circuit into an Evolve 3 way virtual circuit Switch with existing load Switch with existing power On an existing 3 way switch one switch has an existing load control on left and one switch has existing line power on right There are two traveler wires between the switches In an Evolve circuit only one device is required to control the load The L
Download Pdf Manuals
Related Search