Ergotech Group 100-D16-B02 flat panel desk mount
Contents
1. ERGOTECH GROUP INC 8 Westchester Plaza ERGOTECH Elmsford NY 10523 914 347 3800 Installation Instructions Product 100 D16 B02 Dual Horizontal Desk Stand 1 Check to see that small hex set screw at rear of base is backed out enough to allow pole to seat down completely Insert pole into base Tighten set screw 2 Loosen ratchet type handle on pole clamp with horizontal bar ratchet handle must be on the right side of the pole Slide clamp and assembly over pole and tighten handle Allen ke 3 Attach quick release pivots to back of each monitor with screws provided Be sure that silver release button is toward the top of the monitor 4 Place each monitor on the horizontal bar by tipping back approximately 45 degrees and then down until the silver release button engages groove and clicks down into place To adjust monitors Laterally Place hand on bottom of monitor and lift slightly to support weight Monitor will slide along bar Left Right and Up Down Grasp monitor with both hands and adjust to desired position To tension the vertical adjustment to the weight of monitor Tighten the 5mm bolt on the right side of the pivot with the hex wrench provided LI B Li Li B B Li TOT HLC La Tanke UIC V eight trom the TAOTI tor WILI oO 1e hal 10 on Uc DOtton AHN tip back vl ghtly Wr ile www ergotechgroup com
Download Pdf Manuals
Related Search