Bogen 109-2151 speaker mount
Contents
1. PIEZ SLING NTERARNATIONAL 109 2151 AMT Rigging Kit Installation Instruction Manual For Apogee AMT 12 and AMT 15 Loudspeakers Copyright 2010 Bogen Communications Inc Specifications subject to change 54 2190 03B 1008 109 2151 AMT Rigging Kit Components 1 AMT SERIES BOTTOM BAR 3 8M FORGED SHOULDER RIGGING EYEBOLTS SS QO ESS Or 2 FLAT WASHERS 2 LOCK WASHERS 4 EYEBOLT SHIMS 1 8M LOCK NUT ae aap Se HEAD SCREWS NOTE YOU MUST READ AND UNDERSTAND THIS MANUAL IN ITS ENTIRETY BEFORE ATTEMPTING TO HANG ANY SPEAKERS 1 Attaching the Bottom Bar Assembly to an AMT Loudspeaker INTO BOTTOM D INTO BOTTOM FORWARD REAR FLY EORGED FLY POINT POINT SHOULDER RIGGING EYEBOLT Connect the Bottom Bar Assembly WASHER WASHER BOTTOM BAR SOCKET H HEAD SCREW LOCK NUT gt LOWER SECTION SIDE VIEW SOCKET SCREW OPENINGS BOTTOM BAR ASSEMBLY BOTTOM BAR ASSEMBLY Attach the Bottom Bar Assembly to the When attached properly the completed underside of an AMT Series Speaker Bottom Bar Assembly should appear as shown here attached to the AMT Speaker as shown here NOTE Be sure that all hardware has been tightened securely DO NOT over tighten 2 Installing Rigging TOP VIEW Eyebolts into an AMT Loudspeaker Install two Rigging Eyebolts into th2. be limited to the price of the product In no event shall Apogee be liable for special incidental or consequential damages including but not limited to loss of profits loss of data or loss of use damages arising out of the manufacture sale or supplying of products even if Apogee has been advised of the possibility of such damages or losses Some States do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from State to State Products that are out of warranty will also be repaired by the Apogee Sound Factory Service Department same address as above or call 201 934 8500 The parts and labor involved in these repairs are warranted for 90 days when repaired by the Apogee Sound Factory Service Department All shipping charges in addition to parts and labor charges will be at the owner s expense All returns require a Return Authorization number 7 22 2008 SILNI INTERNATICNAL 50 Spring Street Ramsey NJ 07446 USA Tel 201 995 2001 www apogee sound com
3. e two ORENINGS Eyebolt openings located on the top of the AMT speaker and tighten securely IMPORTANT Use shims as needed to achieve proper alignment of the rigging eyebolts See below INCORRECT RIGGING EYEBOLTS ALIGNED PROPERLY RIGGING EYEBOLTS NOT ALIGNED PROPERLY 22 5 422 5 BOTTOM mang s 4 ASSEMBLY NA RIGGING KIN EYEBOLT USE 1 OR 2 SHIMS TO POSITION EYEBOLTS SHIMS WITHIN 22 5 OF SPEAKER CENTERLINE gt S AS INDICATED BOTTOM BAR ASSEMBLY NOTE Be sure that all hardware has been tightened securely DO NOT over tighten 3 Hanging the Speaker The configuration of the rigging cables or chains can be done in various ways depending on the situation This manual does not cover the rigging configurations however the information on the BACK PAGE is extremely important and must be adhered to when flying the speakers YOU ARE HANGING HEAVY ITEMS OVER PEOPLE S HEADS THIS IS SERIOUS BUSINESS YOU MUST ACCURATELY FOLLOW THE INSTRUCTIONS FOR ALL THE PARTS INVOLVED IN THE INSTALLATION FAILURE TO DO SO CAN CAUSE SERIOUS INJURY OR DEATH TO OTHERS AND EXPOSE YOUR COMPANY AND YOU TO LEGAL ACTION 3 Hanging the Speaker cons THE INFORMATION ON THIS PAGE IS EXTREMELY IMPORTANT AND MUST BE ADHERED TO WHEN FLYING THE SPEAKERS SUSPENSION CABLES not included TILT CABLE not included 1 Use redundant suspension systems Always u
4. se a minimum of 2 suspension cables or chains and make sure one is secured to each eyebolt on the top of the speaker A and B Using two cables minimum and securing one to each eyebolt provides backup suspension should one cable connection fail Use redundant cable clamps on each cable and strip back any cable cladding in the area of the clamp EYEBOLTS 2 Ensure capacity of suspension cables chains and anchor points Make sure the cables chains and any associated SUSPENDED AMT SPEAKER hardware have a working load rating for AT LEAST DIAGRAM FORIELUSTRANVE PURPOSES ONEK 10 TIMES the speaker weight Make sure the structural anchor points for the cables or chains have a working load rating for AT LEAST 10 RIGGING TIMES the speaker load as well EVEBOIT TOP VIEW ASSEMBLY IN LINE PULL 3 Ensure proper cable pull direction The proper cable pull direction is IN LINE with the loop of the eyebolt 90 The load capacity of the eyebolt decreases rapidly as the pull direction PULL moves closer to being 90 degrees to the loop This is why it is very important to align the eyebolts as shown in Section 2 NOTE If you are using 2 cables on one eyebolt to form a V a 90 degree pull direction is OK since the 2 cables cancel out the 90 degree forces on the eyebolt You must still connect a backup cable for a total of 3 to the other eyebolt on the speaker 4 Double check that all hardware is properly tightened Follow man
5. ufacturer s recommendations for tightening over tightening can be dangerous Limited Warranty Exclusion of Certain Damages Apogee Sound 109 2151 AMT Rigging Kit is warranted to be free from defects in material or workmanship for three 3 years from the date of sale to the original purchaser Any part of the product covered by this warranty that with normal installation and use becomes defective will be repaired or replaced by Apogee at our option provided the product is shipped insured and prepaid to Apogee Sound Factory Service Department 50 Spring Street Ramsey NJ 07446 USA The product will be returned to you freight prepaid This warranty does not extend to any of our products that have been subjected to abuse misuse improper storage neglect accident improper installation or have been modified or repaired or altered in any manner whatsoever or where the serial number or date code has been removed or defaced THE FOREGOING LIMITED WARRANTY IS APOGEE S SOLE AND EXCLUSIVE WARRANTY AND THE PURCHASER S SOLE AND EXCLUSIVE REMEDY APOGEE SOUND MAKES NO OTHER WARRANTIES OF ANY KIND EITHER EXPRESSED OR IMPLIED AND ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FORA PARTICULAR PURPOSE ARE HEREBY DISCLAIMED AND EXCLUDED TO THE MAXIMUM EXTENT ALLOWABLE BY LAW Apogee s liability arising out of the manufacture sale or supplying of products or their use or disposition whether based upon warranty contract tort or otherwise shall
Download Pdf Manuals
Related Search