Chief SLB184 projector accessory
Contents
1. P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 2 12 07 INSTALLATION INSTRUCTIONS Continued A CAUTION When screwing the adjustable feet into the four storage holes make sure not to screw then in to far or you could damage your projector by hitting the plastic shell of the projector These feet should not be tight these holes are only to store the feet so they can be use again at a future time NOTE Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the All Points Security Kit CHIEF2. INSTALLATION INSTRUCTIONS SLB 184 and SLM 184 Interface Brackets SLB and SLM series Interface brackets are designed for use with Chief RPA RPM and Smart Lift series projector mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative by calling 1 800 582 6480 WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 4 Screw Philips Pan Head Machine M5 x 25mm 6 10 24 Thumb Nuts 4 Washer M5 1 All Points Security Kit Front of Projector Front of Projector 2 l p P o holes for e holesitor SLB 184 A foot SLM 184 KE adjustable foot storage Only used when installing SLB Interface brackets Installation WARNING OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUPIMENT DO NOT over tighten screws when installing interface brackets NOTE Step 1 is only required when installing an SLB Interface bracket If an SLM bracket is being installed proceed to step 2 1 Screw six thumb screws onto six 10 24 x 5 8 Philips pan head screws DO NOT fully tighten thumb screws at this time 2 Turn projector up
3. side down on a flat surface 3 Remove four adjustable feet in the bottom of projector 4 Place interface bracket onto the bottom of the projector so the center hole is closer to the front of the projector well lining up the four holes in the bracket with the four threaded inserts in the bottom of the projector 5 Using the four M5 X 25mm mounting screws and M5 washers start them into the mounting holes by hand and secure all four fasteners at this time CAUTION When attaching the mount be careful not to over tighten mounting screws 6 Find the four M5 threaded holes provided in the bracket and thread one adjustable foot into each hole provided one to two turns CSAV Inc and its affiliated corporations and subsidiaries collectively CSAV intend to make this manual accurate and complete However CSAV makes no claim that the infor mation contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind CSAV makes no representation of warranty expressed or implied regarding the information contained herein CSAV assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document ms e 2006 Chief Manufacturing 8401 Eagle Creek Parkway Savage MN 55378 8802 000251 iC CH I E F
Download Pdf Manuals
Related Search