Home

Elica Galaxy Island

1. Press T2 button during operation at speed 1 the hood sets to OFF Speed increase Press T3 button and the hood sets from OFF to speed 1 Press the button hood ON to increase the speed of the motor from 1 to 4 intensive The respective LED goes on for each speed Speed 1 LED 1 Speed 2 LED 2 Speed 3 LED 3 Intensive speed LED 4 flashing The intensive speed is timed Standard timing is 5 at the end of which the hood sets to speed 2 To deactivate the function before time is up press T2 button the hood sets to speed 3 Speed timing Speed timing is activated by pressing T4 button when timing is up the hood switches off Timing is divided as follows Speed 1 20 minutes LED 1 flashing Speed 2 15 minutes LED 2 flashing Speed 3 10 minutes LED 3 flashing Speed 4 5 minutes LED 4 flashing 1234 T3 T4 During timed operation press T2 button and the hood quits the timed mode and decreases the speed Press T3 button and the hood quits the timed mode and increases the speed Press T4 button and the hood quits the timed mode maintaining the set speed Grease filter signal After 40 hours of operation LED 1 flashes When such signal appears the grease filter installed needs to be washed To reset the signal keep T4 button pressed for 5 The hood gives out a BEEP and LED 1 stops flashing Charcoal filter signal After 160 hours of operation LED 2 flashes When such signal appears the charco
2. plica EN Instruction on mounting and use an m ae NZ Aa gt S of gt x 5 2 m 27 EN Instruction on mounting and use Closely follow the instructions set out in this manual All responsibility for any eventual inconveniences damages or fires caused by not complying with the instructions in this manual is declined The hood is conceived for the suction of cooking fumes and steam and is destined only for domestic use The hood can look different to that illustrated in the drawings in this booklet The instructions for use maintenance and installation however remain the same Itis important to conserve this booklet for consultation at any moment In the case of sale cession or move make sure it is together with the product Read the instructions carefully there is important information about installation use and safety I Donot carry out electrical or mechanical variations on the product or on the discharge conduits Note the elements marked with the symbol are optional accessories supplied only with some models or elements to purchase not supplied N Caution WARNING Do not connect the appliance to the mains until the installation is fully complete Before any cleaning or maintenance operation disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply Always wea
3. Disposal must be carried out in accordance with local environmental regulations for waste disposal For further detailed information regarding the process collection and recycling of this product please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product Additional Installation Specifications Use only the fixing screws supplied with the product for installation Use the correct length screws which are identified in the Installation Guide WARNING Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards Use The hood is designed to be used either for exhausting or filter version aul Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood Attention The exhausting pipe is not supplied and must be purchased apart Diameter of the exhausting pipe must be equal to that of the connection ring In the horizontal runs the exhausting pipe must be slightly slanted about 10 and directed upwards to vent the air easily from the room to the outside Attention If the hood is supplied with active charcoal filter then it must be removed Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet connection flange
4. Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise Any responsibility in the matter is therefore declined a duct of the minimum indispensible length a duct with as few elbows as possible maximum elbow angle 90 Avoid drastic changes in the duct cross section Use a duct as smooth as possible inside The duct must be made of certified material oy Filter version One active charcoal filter is needed for this and can be obtained from your usual retailer The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid The models with no suction motor only operate in ducting mode and must be connected to an external suction device not supplied The connecting instructions are supplied with the peripheral suction unit Installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers If the instructions for installation for the gas hob specify a greater distance this must be adhered to 14 N Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood If provided with a plug connect the hood to a soc
5. parts of the hood may became hot when used with cooking appliance With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities The hood must be regularly cleaned on both the inside and outside AT LEAST ONCE A MONTH This must be completed in accordance with the maintenance instructions provided in this manual Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks We will not accept any responsibility for any faults damage or fires caused to the appliance as a result of the non observance of the instructions included in this manual This appliance is marked according to the European directive 2002 96 EC on Waste Electrical and Electronic Equipment WEEE By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of this product The symbol on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment
6. al filter installed must be 15 replaced To reset the signal keep T4 button pressed for 5 The hood gives out a BEEP and LED 2 stops flashing In case of contemporaneous signalling of both filters LEDs 1 and 2 flash alternatively To reset carry out the procedure described above for 2 times The first time it resets the charcoal filter signal the second time it resets the grease filter signal The charcoal filter signal is not active in the standard mode In case the hood is used in filter version it is necessary to enable the charcoal filter signal Activating charcoal filter signal Set the hood to OFF and press T4 button for 5 Once the button has been pressed the LEDs related to the filter signals currently active light up The hood gives out a BEEP and LED 2 flashes for 2 LEDs 1 and 2 remain on for about 2 before the hood goes back to OFF Deactivating charcoal filter signal Set the hood to OFF and press T4 button for 5 Once the button has been pressed the LEDs related to the filter signals currently active light up The hood gives out a BEEP and LED 2 switches off LED 1 remain on for about 2 before the hood goes back to OFF Maintenance ATTENTION Before performing any maintenance operation isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse Or if the appliance has been connected through a plug and socket then the plug must be remove
7. d from the socket Cleaning The cooker hood should be cleaned regularly at least with the same frequency with which you carry out maintenance of the fat filters internally and externally Clean using the cloth dampened with neutral liquid detergent Do not use abrasive products DO NOT USE ALCOHOL WARNING Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks Therefore we recommend observing these instructions The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations Grease filter Fig 27 32 Traps cooking grease particles This must be cleaned once a month or when the filter saturation indication system if envisaged on the model in possession indicates this necessity using non aggressive detergents either by hand or in the dishwasher which must be setto a low temperature and a short cycle When washed in a dishwasher the grease filter may discolour slightly but this does not affect its filtering capacity To remove the grease filter pull the spring release handle 16 Charcoal filter filter version only Fig 31 It absorbs unpleasant odours caused by cooking The activated charcoal filter can be one of these types Washable activated charcoal filter e NON washable activated charcoal filter Washable act
8. easier access to rear wall ceiling Otherwise put a thick protective covering over countertop cooktop or range to protect from damage and debris Select a flat surface for assembling the unit Cover that surface with a protective covering and place all canopy hood parts and hardware in it e In addition check whether near the installation area of the hood in the area accessible also with the hood mounted an electric socket is available and it is possible to connect a fumes discharge device to the outside only suction version Carry out all the masonry work necessary e g installation of an electric socket and or a hole for the passage of the discharge tube Expansion wall plugs are provided to secure the hood to most types of walls ceilings However a qualified technician must verify suitability of the materials in accordance with the type of wall ceiling The wall ceiling must be strong enough to take the weight of the hood Do not tile grout or silicone this appliance to the wall Surface mounting only Operation Use the high suction speed in cases of concentrated kitchen vapours It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking 2 T1 T2 4 1 Lights ON OFF T2 Speed decrease Press T2 button to decrease the speed from 4 intensive to 1
9. ivated charcoal filter The charcoal filter can be washed once every two months or when the filter saturation indication system if envisaged on the model in possession indicates this necessity using hot water and a suitable detergent or in a dishwasher at 65 C if the dishwasher is used select the full cycle function and leave dishes out Eliminate excess water without damaging the filter then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100 C to dry completely Replace the mattress every 3 years and when the cloth is damaged NON washable activated charcoal filter The saturation of the charcoal filter occurs after more or less prolonged use depending on the type of cooking and the regularity of cleaning of the grease filter In any case it is necessary to replace the cartridge at least every four mounths The charcoal filter may NOT be washed or regenerated Assembly Hook the charcoal filter at the back on the metal tongue of the hood first then on the front with the two knobs Disassembly Remove the charcoal filter by turning the knobs fixing it to the hood by 90 Replacing lamps Fig 33 Disconnect the hood from the electricity Warning Prior to touching the light bulbs ensure they are cooled down 1 Using a flat head screwdriver or equivalent tool carefully pry loose the light cover 2 Remove the damaged light and replace with a new 12 Volt 20 Watt Ma
10. ket in compliance with current regulations and positioned in an accessible area after installation If it not fitted with a plug direct mains connection or if the plug is not located in an accessible area after installation apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over current category in accordance with installation instructions Warning Before re connecting the hood circuit to the mains supply and checking the efficient function always check that the mains cable is correctly assembled The hood is provided with a special power cable if the cable is damaged request a new one from Technical Service Mounting This type of cooker hood must be fixed to the ceiling Very heavy product hood handling and installation must be carried out by at least two persons Before beginning installation e Check that the product purchased is of a suitable size for the chosen installation area e Remove the charcoal filter s if supplied see also relative paragraph This these is are to be mounted only if you want lo use the hood in the filtering version e Check for transport reasons that there is no other supplied material inside the hood e g packets with screws guarantees etc eventually removing them and keeping them e f possible disconnect and move freestanding or slide in range from cabinet opening to provide
11. r work gloves for all installation and maintenance operations The appliance is not intended for use by children or persons with impaired physical sensorial or mental faculties or if lacking in experience or knowledge unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety This appliance is designed to be operated by adults children should be monitored to ensure that they do not play with the appliance This appliance is designed to be operated by adults Children should not be allowed to tamper with the controls or play with the appliance Never use the hood without effectively mounted grating The hood must NEVER be used as a support surface unless specifically indicated The premises where the appliance is installed must be sufficiently ventilated when the kitchen hood is used together with other gas combustion devices or other fuels The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels The flaming of foods beneath the hood itself is severely prohibited The use of exposed flames is detrimental to the filters and may cause a fire risk and must therefore be avoided in all circumstances Any frying must be done with care in order to make sure that the oil does not overheat and ignite 13 Accessible
12. ximum halogen light made for a G 4 base SUITABLE FOR USE IN OPEN LUMINAIRES Follow package directions and do not touch new light with bare hands 3 Reinstall the light cover it will snap shut If the lights do not work make sure that the lamps are fitted properly into their housings before you call for technical assistance

Elica Galaxy Island

Contents

Download Pdf Manuals

Related Search

Related Contents