Remington 43165.560.110
Contents
1. and then to the mains Allow 16 hours for a full charge on the HC5400 and 4 5 hours on the HC5600 and HC5800 3t USB Connect your USB cable to the USB port on your power source Connect the USB cable to your appliance Note charging may take longer when charging via USB CORDED USE Connect the charging adaptor to the product then to the mains When the cord is connected to the mains a digital display will be displayed on the appliance HC5800 CAUTION Extended mains only use will result in the reduction of the battery life 49 WARNING The appliance can not be operated in corded mode while connected to a PC via the USB port 3 CORDLESS USE When the unit is switched on and fully charged the product can be used in cordless mode for up to 60 minutes for the HC5400 and up to 120 minutes for the HC5600 amp HC5800 HOW TO USE BEFORE STARTING THE CUT Inspect the clipper making sure that it is free from hair and dirt Seat the person so that their head is approximately at your eye level Before cutting always comb the hair so it is tangle free and dry 3 TO ATTACH A COMB Hold the comb with its teeth upward Slide it onto and along the clipper blade until the front of the comb firmly sits against the clipper blade 3 TO REMOVE THE COMB Holding the clipper with the blades facing away from you firmly push the comb upward and away from the blades 3 INSTRUCTIONS FOR HAIR CU2. ELI e E 0000080 2999999900099 9 e 6060000000 x t x b x e 00600 00000000000000 e 7600000 D J WY eeeccccceeececcct eee J x HC5800 HC5600 HC5400 FEMINGTON Thank you for choosing Remington Our products are designed to meet the highest standard of quality functionality and design We hope you enjoy using your new Remington product Please read the instructions for use carefully and keep in a safe place for future reference Claim your extra 1 year warranty by registering your product online Simply go to www productregister co uk remington IMPORTANT SAFEGUARDS 1 WARNING TO REDUCE THE RISK OF BURNS ELECTROCUTION FIRE OR INJURY TO PERSONS 2 Usethis appliance only for its intended use as described in this manual Do not use attachments not recommended by Remington 3 Do not use this product if it is not working correctly if it has been dropped or damaged or dropped in water An appliance should never be left unattended when plugged in to a power outlet except when charging Keep the power plug and cord away from heated surfaces Make sure the power plug and cord do not get wet Do not plug or unplug the appliance with wet hands Do not use the
3. TTING Note For even cutting allow the comb attachment blade to cut its way through the hair Do not force it through quickly If you are cutting for the first time start with the maximum comb attachment a STEP 1 of the neck Set the comb to 3mm or 6mm Hold the clipper with the blade teeth pointing upwards Begin starting at the centre of the head at the base of the neck Slowly lift the clipper working upwards and outwards through the hair trimming just a little at a time STEP 2 Back of the head With the comb set at 12mm or 18mm cut the hair at the back of the head STEP 3 Side of the head Set the comb to 3mm or 6mm trim sideburns Then change the setting to 9mm and continue to cut the top of the head STEP 4 Top of the head Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on top of the head against the direction in which the hair normally grows For longer hair on top use the longer length comb attachment 24 42mm to achieve the desired style Always work from the back of the head STEP 5 The finishing touches Use the clipper without an attachment comb for close trimming around the base and sides of the neck To produce a clean straight line at the sideburns reverse the hair clipper Place the reversed clipper at right angles to the head tips of the blades lightly touching the skin and then work downwards SHORT TAPERED STYLES FLAT TOPS
4. ade Mark of Spectrum Brands Inc or one of its subsidiaries Spectrum Brands UK Ltd Fir Street Failsworth Manchester M35 0HS www remington co uk O 2013 SBI
5. amp SHORT CUTS Starting with the longest guide comb attached 24 42mm cut from the back of the neck to the crown Hold the guide comb flat against the head and slowly move the clipper through the hair Use the same procedure from the lower side to the upper side of the head Then cut the hair against the direction in which it grows and level with the sides To give a flat top look the hair on top of the head must be cut over the top of a flat comb Use a closer guide comb to taper the hair down to the neckline as desired 3 DUAL BOOST SYSTEM HC5600 There are 3 settings for the Dual Boost system Off On Boost If the clipper is set to on it will run at regular power If the clipper is set to boost it will provide maximum power AUTO BOOST SYSTEM HC5800 There are 3 settings for the Auto Boost system Off Auto Boost If the Clipper is set to Auto it will run at regular power under low load conditions When more power is needed the clipper will automatically sense this and provide maximum boost To activate the Boost setting depress the power button for 2 seconds The clipper will then constantly run at maximum power lt gt CARE FOR YOUR HAIRCLIPPER Your clipper is fitted with high quality blades To ensure long lasting performance of your clipper clean the blades and unit regularly Always keep the attachment guide comb on the trimmer blade e 3 AFTER EACH USE Ensure the clipper is switched off and disc
6. e 2 screws Note that if the blades are not correctly aligned then cutting efficiency will be impaired Place a few drops of cutter or sewing machine oil onto the blades Wipe off excess oil ul CLEANING CAUTIONS Ensure the appliance is switched off and unplug from the main outlet before cleaning Only the attachment guide combs and trimmer blade may be removed from the product for cleaning Cleaning should be done with a soft brush such as the brush supplied with the product Do not rinse under water Do not use harsh or corrosive cleaners on the units or their blades amp ENVIRONMENTAL PROTECTION To avoid environmental and health problems due to hazardous substances in electrical and electronic goods appliances marked with this symbol must not be disposed of with unsorted municipal waste but recovered reused or recycled 6 BATTERY REMOVAL The battery must be removed from the appliance before it is scrapped The appliance must be disconnected from the supply mains when removing the battery Ensure that the clipper is discharged of all power and disconnected from the mains Remove the screw cover from back housing Using a small screwdriver remove 1 screw from the bottom of the clipper Pry the front panel from the front housing and expose the inner housing Using a small screwdriver remove 4 screws from inner housing Pry the cover of inner housing and expose the PCB and batteries Cut or break the wire stamps on the bo
7. onnected from the mains before cleaning Brush the accumulated hair from the blades Do not submerge the clipper in water To clean unit wipe with damp cloth and dry immediately x WASHABLE CLEANING The QUICK WASH SYSTEM is designed to maximise the efficiency of washable cleaning Push the button that is located on the front of the hair clipper The blades will slide out and the blade set can be easily cleaned under the tap Once the blades are cleaned the blades are locked into place by pushing the blade set towards the hair clipper head and will snap into place Do not run the entire unit under the tap only the blade set is meant to be submerged in water Note Ensure the clipper is turned off when cleaning FEMINGTON 51 5 At regular intervals the blade set should be removed and cleaned Remove the 2 screws retaining the fixed blade with a screwdriver Do not remove blade set Brush out hairs from between the blades with soft cleaning brush Do not remove the lubricating grease from the blades It is not necessary to remove the small moving blade from the unit If the moving blade has been removed this can be re fitted by slotting the coated blade holder over the pin in the centre of the interior product head The groove on the coated blade just below the teeth rests on a metal plate at the opposite side to the screw holes The fixed blade is fitted with the raised profile pointing outwards and fixed with th
8. or GETTING STARTED CHARGING YOUR HAIRCLIPPER Before using your hairclipper for the first time charge for 16 20 hours Ensure the product is switched off Connect the charging adaptor to the product and then to the mains If the product is not going to be used for an extended period time 2 3 months unplug it from the mains and store Fully recharge your product when you would like to use it again Allow 16 hours for a full charge on the HC5400 and 4 5 hours on the HC5600 and HC5800 To preserve the life of your batteries let them run out every 6 months then recharge for 16 20 hours This appliance should be charged by approved safety isolating adaptors PA 3215E for HC5400 EU version or PA 3215U for HC5400 UK version with the output capacity of 3 2V dc 1500mA and should be charged by approved safety isolating adaptors PA 4515E for HC5600 HC5800 EU version or PA 4515U for HC5600 HC5800 UK version with the output capacity of 4 5V dc 1500mA QUICK CHARGE HC5600 amp HC5800 Quick charge time 1 hour 2 hours Runtime _ Sminutes 15minutes 30minutes 40 minutes 3 CHARGING VIA CHARGING STAND HC5800 Ensure the product is switched off Connect the charging adaptor to the charging stand and then to the mains Allow 4 5 hours for a full charge CHARGING VIA STANDARD ELECTRICAL SOCKET Ensure the product is switched off Connect the charging adaptor to the product
9. product with a damaged cord A replacement can be obtained via our International Service Centres 9 Do not twist or kink the cable and don t wrap it around the appliance 10 Store the product at a temperature between 15 C and 35 C 11 Only use the parts supplied with the appliance 12 The appliance including its cord must not be used played with cleaned or maintained by persons under eight years old and should at all times be kept out of their reach 13 Use cleaning or maintenance of the appliance by children over eight or by anyone with a lack of knowledge experience or with reduced physical sensory or mental capabilities should only be undertaken after receiving appropriate instruction and under the adequate supervision of a responsible adult to ensure that they do so safely and that the hazards involved are understood and avoided 14 Don t put the appliance in liquid don t use it near water in a bath tub basin or any other vessel and don t use it outdoors 15 Suitable for cleaning under an open water tap CON Ov Ui lt gt KEY FEATURES 1 On Off Switch 2 Blade set 3 2 attachment guide combs 3 21mm and 24 42mm 3mm adjustment 4 Adjustable stubble comb HC5800 Adjustable stubble comb 1 13mm 2mm adjustment 5 1 5mm Stubble comb 5600 6 Quick wash release button 7 Charging indicator light 8 LED display HC5800 9 Micro USB port 10 Micro USB cable 11 Charging stand HC5800 12 Adapt
10. th end of the batteries and remove the batteries The battery is to be disposed of safely SERVICE AND GUARANTEE Defects affecting product functionality appearing within the guarantee period will be corrected by replacement or repair at our option provided the product is used and maintained in accordance with the instructions Defects from repair by an unauthorized dealer are not covered Consumables are excluded Your statutory rights are not affected If you call the Service Centre please have the Model No to hand as we won t be able to help you without it The Model No can be found on the rating plate of the appliance Replacement parts and accessories are available to buy at www remington co uk parts accessories ab SERVICE CENTRE United Kingdom ZA Tel 0800 212 438 free call mainland UK 44 161 947 3111 call outside the UK Spectrum Brands UK Ltd e Fir Street Failsworth Manchester M35 065 UK www remington co uk Ireland 142 951 40 Remington Consumer Products Unit B12 Ballymount Corporate Park Ballymount Dublin 12 www remington co uk 2 REGISTER ONLINE FOR 10 000 prize draw EXTRA year guarantee FREE rewards gallery Visit www productregister co uk remington You must register within 28 days of purchase SENN e Model No HC5800 HC5600 HC5400 13 UK HC5800 HC5600 HC5400 T22 0001003 Version 01 13 Remington is a Registered Tr
Download Pdf Manuals
Related Search