Philips HTL1180B
Contents
1. Severe internal burns can occur within two hours of ingestion e If you suspect that a battery has been swallowed or placed inside any part of the body seek immediate medical attention e When you change the batteries always keep all new and used batteries out of reach of children Ensure that the battery compartment is completely secure after you replace the battery e If the battery compartment cannot be completely secured d iscontinue use of the product Keep out of reach of children and contact the manufactu rer This is CLASS I apparatus with double insulation and no protective earth provided Care for your product Use only microfiber cloth to clean the product Care of the environment Disposal of your old product and battery as Your product is designed and manufactured with high quality materials and components which can be recycled and reused R This symbol on a product means that the product is covered by European Directive 2012 19 EU R This symbol means that the product contains batteries covered by European Directive 2013 56 EU which cannot be disposed of with normal household waste Inform yourself about the local separate collection system for electrical and electronic products and batteries Follow local rules and never dispose of the product and batteries with normal household waste Correct disposal of old products and batteries helps prevent nega2. mode indicator e f surround mode is turned on all the LED indicators light up one by one with all the LED indicators on for three seconds Finally the current source indicator stays on e If surround mode is turned off all the LED indicators light up then light off one by one Finally the current source indicator stays on Equalizer Change the high frequency treble and low frequency bass settings of the SoundBar 1 Press TREBLE or BASS to change the treble or bass Treble bass indicator e The more treble bass you change to the more LED indicators light up If you do not press the treble bass button for three seconds the treble bass indicators light off e All the LED indicators blink three times when treble or bass is set to the maximum or minimum value Synchronize video and sound If the audio and video are not synchronized delay the audio to match the video d Press AUDIO SYNC to synchronize the audio with the video e AUDIO SYNC increases the sound delay and AUDIO SYNC decreases the sound delay Sound delay indicator e The more delay you change to the more LED indicators light up If you do not press the sound delay button for three seconds the sound delay indicators light off Note e This feature is only applicable to COAXIAL COAX and OPTICAL OPT sources Night mode For quiet listening night mode decreases the volume of loud sounds when a
3. 22 kHz 24 kHz 32 kHz 44 1 kHz 48 kHz Constant bit rate e P3 8 kbps 320 kbps USB Compatibility Hi Speed USB 2 0 Class support USB Mass Storage Class MSC File system FAT16 and FAT32 Supports MP3 file formats EN 11 7 Troubleshooting Warning e Risk of electric shock Never remove the casing of the product To keep the warranty valid never try to repair the product yourself If you have problems using this product check the following points before you request service If you still have a problem get support at www philips com support Main unit The buttons on the SoundBar do not work Disconnect the SoundBar from the power supply for a few minutes then reconnect Sound No sound from SoundBar speakers Connect the audio cable from your SoundBar to yourTV or other devices e Reset your SoundBar to its factory settings e On the remote control select the correct audio input e Make sure that the SoundBar is not muted Distorted sound or echo e If you play audio from the TV through the SoundBar make sure that the TV is muted DOLBY DIGITAL Dolby and the double D symbol are registered trademarks of Dolby Laboratories 13 PHILIPS Specifications are subject to change without notice 2014 WOOxX Innovations Limited All rights reserved Philips and the Philips Shield Emblem are registered trademarks of Konin
4. Always there to help you Register your product a ae upport at www philips com suppor HTL1180B User manual PHILIPS Contents 1 Important Help and support Safety Care for your product Care of the environment Compliance 4 WWNN NN 2 Your SoundBar 4 Main unit 4 Remote control 5 Connectors 6 3 Connect 6 Placement Connect audio from TV and other devices NODO 4 Use your SoundBar Adjust the volume Choose your sound MP3 player USB storage devices Auto standby Apply factory settings Update software OOO OO CO o o 5 Wall mount 0 6 Product specifications 1 7 Troubleshooting 2 EN 1 Important Read and understand all instructions before you use your product If damage is caused by failure to follow instructions the warranty does not apply Help and support For extensive online support visit www philips com support to e download the user manual and the quick start guide e watch video tutorials available only for selected models e find answers to frequently answered questions FAQs e email us a question e chat with our support representative Follow the instructions on the website to select your language and then enter your product model number Alternatively you can contact Consumer Care in your country Before you contact note down the model number and serial number of your product You can find this information on the bac
5. S Connect to the power supply o O Oo 3 Connect This section helps you connect your SoundBar to a TV and other devices For information about the basic connections of your SoundBar and accessories see the quick start guide Note e For identification and supply ratings refer to the type plate at the back or bottom of the product e Before you make or change any connections make sure that all devices are disconnected from the power outlet Placement Place your Soundbar as shown below Connect audio from TV and other devices Play audio from TV or other devices through your Soundbar Use the best quality connection available on your TV and other devices Option 1 Connect audio through a digital optical cable Best quality audio DIGITAL IN OPTICAL 1 Using a coaxial cable connect the COAXIAL connector on your SoundBar to the COAXIAL DIGITAL OUT connector on the TV or other device e The digital coaxial connector might be labeled DIGITAL AUDIO OUT Option 3 Connect audio through analog audio cables Basic quality audio AUX IN AUDIO IN 1 Using an optical cable connect the OPTICAL connector on your SoundBar to the OPTICAL OUT connector on the TV or other device e The digital optical connector might be labeled SPDIF or SPDIF OUT Option 2 Connect
6. Switch your audio source to the AUX connection e AUDIO IN Switch your audio source to the MP3 connection 3 5mm jack O D e USB Switch your audio source to the USB connection REPEAT Select or turn off repeat mode in USB mode Volume Increase or decrease volume 1 amp Mute or restore volume BASS Increase or decrease bass NIGHT Turn night mode on or off TREBLE Increase or decrease treble SURR Toggle between stereo and virtual surround sound AUDIO SYNC Applicable to COAXIAL COAX and OPTICAL OPT sources only Increase or decrease audio delay Play buttons e DI Play pause or resume play in USB mode I lt Pl Skip to the previous or next track in USB mode EN 5 Connectors This section includes an overview of the connectors available on your SoundBar R Se OPTICAL i O COAXIAL WHITE J 5 F u G10 O i 7 ee AC MAINS 6 Q AUDIO IN D DIGITAL IN OPTICAL Connect to an optical audio output on the TV or a digital device AUX Connect to an analog audio output on the TV or an analog device COAXIAL Connect to a coaxial audio output on the TV or a digital device lt gt Audio input from a USB storage device AUDIO IN Audio input from for example an MP3 player 3 5mm jack AC MAIN
7. ar Screw length diameter Depending on the type of wall mounting your SoundBar make sure that you use screws of a suitable length and diameter 3 0 3 5mm 0 12 0 14 4mm 0 16 gt 25mm 0 98 See the illustration in the quick start guide on how to wall mount the SoundBar 1 Drill two holes on the wall 2 Secure the dowels and screws in the holes 3 Hang the SoundBar on the fastening screws Ss SS 6 Product Main unit spre bd Power supply 100 240 V 50 60 Hz specifications e Power eee ee 25 W Standby power consumption lt 0 5 WV e Speaker impedance 8 ohm full range Note e Speaker drivers 4 x 54 5 mm 2 e Specifications and design are subject to change without Dimensions w xH x D notice 865 x 67 8 x 85 5 mm 34 1 x 2 7 x 3 4 e Weight 1 8 kg 3 96 Ibs Amplifier Remote control batteries RMS total output power 7 TRASAR SY 40W RMS 0 5 dB 10 THD Frequency response 40 Hz 20 kHz 3 dB Signal to noise ratio gt 65 dB CCIR A weighted Total Harmonic Distortion lt 1 nput sensitivity e AUX 2Vrms 100mV e AUDIO IN 1Vrms 100mV Audio S PDIF Digital audio input Coaxial IEC 60958 3 Optical TOSLINK Sampling frequency P3 8 kHz 11 kHz 12 kHz 16 kHz
8. audio through a digital coaxial cable Best quality audio DIGITAL IN COAXIAL IN 1 Using an analog cable connect the AUX connectors on your SoundBar to the AUDIO OUT connectors on the TV or other device EN 7 4 Use your SoundBar This section helps you use the SoundBar to play audio from connected devices Before you start e Make the necessary connections described in the Quick Start Guide or download the User Manual from www philips com support e Switch the SoundBar to the correct source for other devices Adjust the volume 1 Press Volume to increase or decrease a volume level e To mute sound press amp e To restore the sound press amp again or press Volume Volume indicator e The higher volume level you change to the more LED indicators light up If you do not press the volume button for three seconds the volume indicators light off e All the LED indicators blink three times when a volume level is set to the maximum or minimum e When sound is muted the current source indicator blinks Choose your sound This section helps you choose the ideal sound for your video or music Surround sound mode Experience an immersive audio experience with surround sound modes 1 Press SURR to turn surround mode on or off e On Create a surround listening experience e Off Two channel stereo sound Ideal for listening to music Sound
9. k or bottom of your product Safety Risk of electric shock or fire e Before you make or change any connections make sure that all devices are disconnected from the power outlet ever expose the product and accessories o rain or water Never place liquid containers such as vases near the product f liquids are spilt on or into the product disconnect it from the power outlet immediately Contact Consumer Care to have the product checked before use e Never place the product and accessories near naked flames or other heat sources including direct sunlight e Never insert objects into the ventilation slots or other openings on the product e Where the mains plug or an appliance coupler is used as the disconnect device the disconnect device shall remain readily operable Disconnect the product from the power outlet before lightning storms e When you disconnect the power cord always pull the plug never the cable Risk of short circuit or fire e For identification and supply ratings see he type plate at the back or bottom of he product e Before you connect the product to the power outlet ensure that the power voltage matches the value printed on the back or bottom of the product Never connect the product to the power outlet if he voltage is different Risk of injury or damage to this product e For wall mountable products use only the supplied wall mount bracket Secure the wall
10. klijke Philips N V and are used by WOOX Innovations Limited under license from Koninklijke Philips N V eS HTL1180B_12_UM_V1 0
11. mount to a wall that can support the combined weight of the product and the wall mount WOOxX Innovations bears no responsibility for improper wall mounting hat results in accident injury or damage e ever place the product or any objects on power cords or on other electrical equipment e If the product is transported in emperatures below 5 C unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet e Parts of this product can be made of glass Handle with care to avoid injury and damage Risk of overheating ever install this product in a confined space Always leave a space of at least four inches around the product for ventilation Ensure curtains or other objects never cover the ventilation slots on the product Risk of contamination e Do not mix batteries old and new or carbon and alkaine etc e Danger of explosion if batteries are incorrectly replaced Replace only with the same or equivalent type e Remove batteries if they are exhausted or if the remote control is not to be used for a long time Batteries contain chemical substances they should be disposed of properly Risk of swallowing batteries e The product remote control may contain a coin button type battery which can be swallowed Keep the battery out of reach of children at all times If swallowed the battery can cause serious injury or death
12. repeat mode is turned on all he LED indicators blink for three imes then the current source indicator stays on e f repeat mode is turned off all he LED indicators light up then ight off one by one Finally the current source indicator stays on e This product may not be compatible with certain types of USB storage device e Ifyou use a USB extension cable USB HUB or USB multi reader the USB storage device may not be recognized e Digital camera PTP protocols are not supported Do not remove the USB storage device while it is being read e DRM protected music files MP3 are not supported e Support a USB port 5V 1A EN 9 Auto standby When playing media from a connected device this product automatically switches to standby after 15 minutes of button inactivity and no audio play from a connected device Apply factory settings You can reset your SoundBar to the default setting mode 1 in mute mode quickly press AUX two times L gt The factory settings is restored Update software To continually improve the product software upgrade may be offered Visit ww philips com support to check if the latest software version is available 5 Wall mount H vee Improper wall mounting may result in accident injury or damage If you have any query contact Consumer Care in your country Before wall mounting make sure the wall can support the weight of your SoundB
13. tive consequences for the environment and human health Removing the disposable batteries To remove the disposable batteries see battery installation section EN 3 Compliance CE This product complies with the radio interference requirements of the European Community 4 EN 2 Your SoundBar Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your SoundBar at www philips com welcome Main unit This section includes an overview of the main unit STANDBY COAXIAL OPTICAL AUX AUDIOIN USB Switch the SoundBar on or to standby SOURCE Select an input source for the SoundBar Volumet Increase or decrease volume LED indicators e STANDBY Lights up when the SoundBar is in standby e COAXIAL Lights up when you switch to coaxial input source e OPTICAL Lights up when you switch to optical input source e AUX Lights up when you switch to analog input source e AUDIO IN Lights up when you switch to audio input source 3 5mm jack e USB Lights up you switch to USB source Remote control This section includes an overview of the remote control PHILIPS 4 Standby On Switch the SoundBar on or to standby Source buttons e COAX Switch your audio source to the coaxial connection e OPT Switch your audio source to the optical connection e AUX
14. udio is played Night mode is only available for Dolby Digital soundtracks d Press NIGHT to tum night mode on or off Night mode indicator f night mode is turned on all the LED indicators light up one by one with all the LED indicators on for three seconds Finally he current source indicator stays on f night mode is turned off all the LED indicators light up then light off one by one Finally the current source indicator stays on MP3 player Connect your MP3 player to play your audio files or music What you need e An MP3 player e A3 5mm stereo audio cable 1 Using the 3 5mm stereo audio cable connect the MP3 player to the AUDIO IN connector on your SoundBar Press AUDIO IN on the remote control U N Press the buttons on the MP3 player to select and play audio files or music USB storage devices Enjoy audio on a USB storage device such as an MP3 player and USB flash memory etc What you need e A USB storage device that is formatted for FAT file systems and complies with the Mass Storage Class e An MP3 file on a USB storage device 1 Connect a USB storage device to the SoundBar 2 Press USB on the remote control 3 Use the remote control to control play Button Action gt Il Start or pause or resume play la gt i Skip to the previous or next track REPEAT During play press to toggle repeat all tracks and repeat off Repeat play indicator e If
Download Pdf Manuals
Related Search