AUDAC WX502
Contents
1. Wall Speaker WX502 PROFESSIONAL AUDIO EQUIPMENT Wall Speaker WX502 User Manual amp Installation Guide Warning e Only use the correct amplifier output voltage and impedance Exceeding these limits could cause fire or other failures Avoid explosions do not use the speaker around gasoline thinner or other combustibles e Only install the speaker in locations that can structurally support the weight of the speaker Not doing so may result in the speaker falling down e Do not use any other method than specified to mount the speaker If extreme force is applied to the speaker the speaker could fall down e Attach a safety wire to the speaker when it s mounted high above the ground Failure in doing so could cause the speaker to fall down for any reason e Avoid mounting the speaker in locations exposed to constant vibrations The mounting points can be damaged by excessive vibrations potentially causing the speaker to fall down Caution e Avoid electric shocks switch off the amplifier power when connecting the speaker e Avoid installing the speaker in locations exposed to solvents acids smoke and heaters as excessive exposure to these factors could result in speaker failure fire or electric shocks e Do not operate the speaker for an extended period of time at distorted sound This could cause irreparable damage to the speaker e Do not stand or sit on nor hang down from the speaker as this may cause failure2. of the speaker Installing the WX502 Mounting the loudspeaker The loudspeaker can be mounted both horizontally and vertically by means of the supplied mounting bracket For mounting the loudspeaker on the desired mounting location the mounting bracket should be removed from the loudspeaker This can be done by loosening the screws on either side of the loudspeaker After this is done the mounting holes should be indicated For a stable mounting of the loudspeaker it should always be fastened by two screws The position of the mounting holes depends of the mounting position horizontally or vertically with a spacing of 162 mm in between After this the bracket can be mounted on the desired location Always use the proper fasteners depending of the mounting surface Once the bracket is mounted on the desired location the loudspeaker can be fixed to the bracket Connecting the loudspeaker Two connection terminals are provided on the rear side to connect the loudspeaker to the amplifier output Always connect the black connection terminal to the COM output of the amplifier and the red connection terminal to the positive terminal of the amplifier output Mind the polarity markings when wiring the loudspeaker cables Power settings On the rear side of the WX502 loudspeaker a recessed adjuster screw is provided Using this adjuster screw the power impedance of the loudspeaker can be set in 3 adjustable steps of impedance for 100V 40 Wa
3. tt 20 Watt 10 Watt and 1 step for 8 Ohm standard low impedance applications 1 8 Ohm 50 Watt 2 40 Watt 250 Ohm 3 20 Watt 500 Ohm 4 10 Watt 1000 Ohm When the loudspeaker is connected to 70 7V facilities the power indicated in the table above will be reduced to half the power and when connected to 50V facilities the power will be reduced to a quarter When the desired power tap is selected the loudspeaker is ready to be used Additional information WX502 Technical specifications RMS Power Max Power Nominal Impedance Line transformer power tappings Sound pressure 1W 1m Sound pressure max W 1 m 8 Ohm Sound pressure max W 1 m 100V Freguency response 3 dB Freguency response 10 dB Cross over freguency Horizontal coverage Vertical coverage Drivers Dimensions W x H x D Weight Construction Accessories included Colours 50 W 100 W 8 Ohm 250 Ohm 40 W 500 Ohm 20 W 1000 Ohm 10 W 87 dB 104 dB 102 dB 90 Hz 18 kHz 70 Hz 18 kHz 2500 Hz 110 110 1 HE 5 LF 212 x 147 x 136 mm 2 52 kg ABS Wall bracket Black White Silver
Download Pdf Manuals
Related Search