Home
        DeLonghi HCX3220FTS space heater
         Contents
1.     appliance and that the power supply is able to with stand  the power consumption  Watts  shown on the rating plate      Ifusing more than one appliance at a time  it is important  to ensure that the power supply is able to with stand the  power requirements     Mounting the feet   Turn the appliance upside down on a rug or soft surface in order  to prevent damaging the paint finish    Fix the feet to the appliance with the screws B supplied Nawe   see fig  1      Wall Mounting Installation  The wall mounting kit contains     4 metal brackets  A  A  2 screws 4 8x13 PH  B  Dae  4 screws 4 5x25 PH  C   js    4 plastic anchors 6x30  D  ess    Required tools for assembly and estimated assembly  time   Screwdriver PH 2 x 100  Phillips type    Estimated assembly time  30 minutes    Before installing the unit   make sure of the following    a  The heater is not located directly below a power  outlet    b  The power outlet can be easily reached by the plug  and after installation    c  No electric cables or other pipes could be damaged  during the installation    d  Keep away from curtains or flammable materials     To wall mount  proceed as follows    Turn the appliance upside down on a flat stable surface   Using   a screwdriver  fix the 2 brackets A with the 2 screws B as shown   in Fig  2    For brick walls use a 6 mm concrete drill bit    For plaster board or false  hollow  walls  it is recommended to   use appropriate screws and anchors  not supplied     1  Before drilling t
2.  than 3 years should  be kept away unless continuously  supervised    Children aged from 3 years and less  than 8 years shall only switch on   off the appliance provided that it has  been placed or installed in its intended  normal operating position and they have  been given supervision or instruction  concerning use of the appliance in a  safe way and understand the hazards  involved  Children aged from 3 years  and less than 8 years shall not plug in   regulate and clean the appliance or  perform user maintenance    CAUTION     Some parts of this product  can become very hot and cause burns   Particular attention has to be given  where children and vulnerable people  are present    WARNING  In order to avoid  overheating  never under  any circumstances cover the  appliances during operation  as this  would lead to dangerous overheating   The appliance must not be located  immediately below a fixed socket outlet        be sure that switches and others control  cannot be touched by a person in the  bath or shower    If the power cable has been damaged  it  must be replaced by the manufacturer  or the technical service centre or by a  qualified person so as to avoid all risks   ATTENTION  in order to avoid any danger  caused by an accidental resetting of the  safety system  this appliance must not  be powered through an external timer   Do not use the heater in small rooms  when they are occupied by person not  capable of leaving the room on their  own  unless constant superv
3. Proudly distributed by  De Longhi Australia Pty Limited  P O  BOX 4540  CASULA MALL NSW 2170  Customer Service Ph  1800 126 659  Fax  1800 706932  www delonghi com au  e mail  delonghi delonghi com au    De Longhi New Zealand Limited  25 Carbine Road  MtWellington  Auckland  New Zealand  P O  Box 58 056 Botany  MANUKAU 2163  Customer Service Ph  0508 200 300  Fax  0508 200 301  www delonghi com nz  e mail delonghi delonghi com nz    De Longhi Appliances via Seitz  47 31100 Treviso Italia     11 13       HCX Series       CONVECTOR       DESCRIPTION             Max   Fan indicator light                Thermostat                   Power selector                          Ne  5    RR  RER  vy   RN          Timer  pr Slider                AWRY  RR                                                      When the heater is used with feet do  not use in the vicinity of bathtubs  wash  basins  showers  sinks and swimming  pools      Ifyou intend to fix the heater to the wall    IMPORTANT WARNINGS    Safety warnings    IN Important       This appliance can be used by children       aged from 8 years and above and persons  with reduced physical  sensory or mental  capabilities or lack of experience and  knowledge if they have been given  supervision or instruction concerning  use of the appliance in a safe way  and understand the hazards involved   Children shall not play with the appliance   Cleaning and user maintenance shall not  be made by children without supervision   Children of less
4. he wall  mark the exact points  respecting  the minimum distances as shown in fig  3    2  Drill the wall where previously marked  and insert the  plastic anchors D    3  Fixthe 2 metal brackets A using the two screws C provided    4  Hang the appliance on the bracket    5  Mark out the 2 lower fixing points  Remove the appliance   drill the lower holes and insert the wall anchors D    6  Now  you can hang back the heater on the bracket and    fix the lower part of the appliance with the 2 remaining  screws C     USE    Operation and use   Plug into the mains  turn the thermostat dial to maximum   and turn the appliance on by means of the power selector  see   description  as described below    e Turn the power selector knob to the Min position to select  minimum power    e     Turn the power selector knob to the Med position to select  medium power  only in some models     e Turn the power selector knob to the Max position to select  maximum power    e     Turn the power selector knob to the Max   position  to select maximum power with the fan  the MAX   FAN  indicator light comes on       To turn the appliance off completely  turn the power  selector to the  0  position and the thermostat to the  I   position  then unplug from the mains        Adjusting the thermostat   When the room has reached the required temperature  turn  the thermostat dial slowly anticlockwise until you hear a click  and no further  The thermostat will automatically regulate the  temperature set and 
5. ision is    provided        Please note     Never use the heater to dry laundry    Never place the power cable on top ofthe heater while it is  hot    We recommend that you not place the heater in a draught   because strong draughts of air may adversely affect the  equipment  operational efficiency    Only use the heater in an upright position    The heater must be positioned at least 50cm from furniture  or other objects    The first time you use the appliance  operate it of at least 15  minutes with the thermostat at maximum to eliminate the     new    smell  A little smoke due to the protective substances  applied to the heating element before transport may be  given off    Do not obstruct the hot air outlet grilles or the air intake  grille on the bottom of the appliance    Position the appliance so that the plug and the outlet can  be easily reached even after installation    The appliance is fitted with a tilt switch which turns the  appliance off if it should fall over To restart the appliance   simply place it upright again The appliance is fitted with  a safety device which will switch the appliance off in case  of accidental overheating  To reset  disconnect the plug    from the power socket for a few minutes  remove the cause  of overheating then plug the appliance in again  If this  abnormal situation happens several times  please contact  the costumer sevice     A Danger of burns        The use of an extension lead is not recommended  as  overheating of the exten
6. keep it constant  In spring or autumn or on  mild days  you can save energy by using minimum power     Frost prevention mode   With the thermostat dial in the position and one of the power  levels selected  the appliance maintains room temperature  at about 5  C  preventing freezing with minimal energy  consumption     Fan  This appliance has two fans for faster more even heating  To use  this function  turn the power selector to the Max  amp  position     Models with 24 hour timer   When the appliance is plugged to the mains the timer is always   in turning movement  in order to stay synchronized with the   local time    To operate the appliance without the timer  place the timer   slider in the    OFF position  To operate the appliance at set   times  position the slider in the position    on and proceed as   follows      Check the time on your clock or watch  If it is 10 00 for  example  turn the numbered programmer disk until the  number 10 coincides with the pointer marked on the    programmer      Set the periods of time during which you want the  appliance to operate by pushing the teeth outwards  see  figure   Each tooth  corresponds to a period  of 30 min  At the end of  this procedure  sectors  corresponding to the  operating periods can  be seen      In this way  the  appliance will function  automatically each day at the times set   Important  the  appliance must always be plugged into the socket    e To modify programming  return the teeth to the initial  positio
7. n and set the new operating periods    e To turn the appliance off  turn the power selcector to the   0  position        MAINTENANCE   Before carrying out any maintenance  unplug the heater from  the mains and wait for it to cool off completely  This heater  requires no particular maintenance  It is sufficient to remove  the dust with a soft  dry cloth  Never use abrasive powders or  solvents  If necessary remove concentrated areas of dirt with a  vacuum cleaner        TECHNICAL CHARACTERISTICS  Power supply  Absorbed power       See rating plate    u    
8. sion lead may occur during the  operation of the heater     C Ene appliance complies with the following EC directives      Low Voltage Directive 2006 95 EC and subsequent  amendments      EEC Directive 2004 108 on electromagnetic compatibility   EMC  and subsequent amendments     INTRODUCTION   Thank you for choosing a De Longhi product  Please take a few  moments to read the instructions to avoid risks or damage to the  appliance        Symbols used in these instructions   Important warnings are identified by the symbols below    Itis important to respect the warnings    Failure to respect the warnings could lead to electric shock   serious injury  burns  fire or damage to the appliance     A Important     Failure to observe the warning could result in injury or damage  to the appliance     A Danger of burns      Failure to observe the warning could result in burns or scalds        Please note     This symbol indicates recommendations and important  information for the user     General instructions   Remove the heater from the packaging  Check that neither the  heater nor the power cable has been damaged during transport   Do not operate the heater if damaged  Remove all publicity  material present on the appliance  Your heater is suitable for  either freestanding or wall mounting usage  Do not assemble  the feet if wall mounting     Electrical connection    Before plugging in the appliance  check that your supply  voltage is the same as that shown on the rating plate of the
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
Wall-Mount Bracket    STAMPANTE MULTIFUNZIONE LASER SP1100SF Aficio  Manual - Auxilab  HP StorageWorks Command View EVA user guide - Hewlett  numéro 2  Detector for Combustible Gases User Manual  Chapter 3: Object-Oriented Programming  Manuel d`utilisation de www.lumibox.org  Optimized user interface    Copyright © All rights reserved. 
   Failed to retrieve file