Scosche NN1670B car kit
Contents
1. place Note if hardware is not supplied with aftermarket stereo reuse hardware from factory stereo DOUBLE DIN ISO MOUNT 1 Align 7199 right amp 7200 left brackets to appropriate sides of aftermarket double din stereo Use reference indicator lines A B amp C to match desired alignment on both sides 2 Mount brackets using hardware supplied a VARIOUS REAR with aftermarket amp SUPPORTS stereo and bolt secure in place Note If hardware is not supplied with aftermarket stereo reuse hardware from factory stereo 7199 RIGHT BRACKET X NOTE Z REAR SUPPORT 4 Y AVAILABLE SEPARATELY REAR SUPPORT OF THE STEREO ADDS TO THE INSTALLATION S STRUCTURAL INTEGRITY2. SCOSCHeE IN DASH STEREO INSTALLATION KIT FOR 2011 NISSAN ROGUE NN1670B 7200 LEFT BRACKET 7199 RIGHT BRACKET INTRODUCTION PRELIMINARY This premium installation kit is for 2011 Nissan Rogue vehicles Included are all the parts you need to mount your car stereo or CD player into your vehicle s dash Refer to the individual instruction in this manual to remove your vehicle s factory radio and assemble the kit CAUTION DISCONNECT YOUR VEHICLE S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP PREVENT ELECTRICAL DAMAGE WE RECOMMEND THE USE OF A VOLT OHM METER OVER A TEST LIGHT TO CHECK WIRING A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE S COMPUTER AND OR DIAGNOSTIC SYSTEMS AVOID ALL FACTORY AIRBAG WIRING AIRBAGS CAN ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY OR DEATH NOTES See your vehicle s instructions for any special tools your installation might require Read all instructions accompanying your car stereo for proper wiring and mounting instructions FACTORY WI G CODES For Factory Wiring Codes go to WWWw Scosche cars com CAR STEREO CONNECTORS PROVIDE EASY CONNECTION OF YOUR CAR STEREO TO FACTORY WIRING HARNESS NNO4B NAA2B 2007 up Nissan 2007 up Nissan Versa wy 4 J Versa Antenna Adapter LIABILITY DISCLAIMER This instruction booklet is based on carefully documented data and research of automobile dash disassembly wire harness codes and i
3. nformation pertaining to installation of this kit NN1670B in 2011 Nissan Rogue vehicles Scosche Industries Inc can not be held responsible for discrepancies inconsistencies that may occur due to the automobile manufacturing changes or options or damage that may occur in the automobile during the installation of components while using this booklet If you have any further questions call our toll free technical help line at 1 800 621 3695x3 2011 SCOSCHE INDUSTRIES INC SI NN1670B 3000003 7 11 FACTORY STEREO REMOVAL 2011 NISSAN ROGUE 1 With panel removal tool unclip top center speaker panel above upper vents 2 Extract 4 Phillips screws from center speaker area 3 With panel removal tool unclip upper vent panel 4 With panel removal tool unclip Lower A C control panel 5 Extract 4 Phillips screws from radio 6 Unplug and remove radio MOUNTING THE STEREO DIN ISO MOUNT 1 Align 7199 right amp 7200 left brackets to appropriate sides of 6796 pocket with the bottom A B amp C slots The front peg of Pw pocket should rest as far forward f in the slot as possible A 2 Secure pocket using supplied 7200 screws in the post above the ee markings 3 Align aftermarket single din stereo with top hole pattern of kit Use reference indicator lines A B amp C to match desired alignment on both sides 4 Mount brackets using hardware supplied with aftermarket stereo and bolt secure in
Download Pdf Manuals
Related Search