Liebherr WKEes 553
Contents
1. You may be able to rectify the following faults by checking the possible causes yourself e Appliance does not function Is the appliance switched on Is the plug correctly fitted in the mains socket Is the fuse intact e Loud running noise Is the appliance set up firmly on the floor Does the appliance cause nearby items of furniture or objects to vibrate Please note that noises caused by the refrigerant circuit cannot be avoided e The temperature is not low enough Isthe temperature setting correct see Setting the temperature Does the separately installed thermometer show the correct read ing Is the ventilation system working properly Is the appliance set up too close to a heat source If none of the above causes apply and you cannot rectify the fault yourself contact the nearest customer service de partment stating the type des ignation service number and appliance number as indicated on the type plate XXX 9999 Index 99 X 999 Service A Sa AE R600a g woa Z He 99 999 999 9 The position of the type plate is shown in the section entitled Description of the appliance Shutting your appliance down If your appliance is to be shut down for any length of time switch it off and disconnect the plug or switch off or unscrew the fuse Clean the appliance and leave the door open in order to prevent unpleasant smells The appliance c2. appliance is located in the event of a leak in the refrigerant circuit The quantity of refrigerant used in your ap pliance is indicated on the type plate on the inside of the appliance e Only use the appliance when it is installed e Donot cover ventilation openings or grille gt Electrical connection Only operate the appliance with alternating current AC The permissible voltage and frequency are indicated on the type plate The position of the type plate is shown in the section entitled Description of the appliance The socket must be properly earthed and protected by a fuse The tripping current of the fuse must be between 10 A and 16 A The socket must not be situated behind the appli ance and must be easily accessible Do not connect the appliance using an exten sion cable or extension socket Do not use stand alone inverters conversion ofdirectcurrentto alternating three phase cur rent or energy saving plugs Risk of damage to the electronic control system 10 Installation dimensions mm instailiagina Kitchen unit min 200 cm 4 2 Connect the appliance to the mains H 2 min eoue tachment plate provided onto the appliance with screws M4 x 8 Changing over door hinges 1 Remove the door the front face of the door 2 Rotate door by 180 board screws through the top bracket 3 Reattach the door 1 Secure the stop bracket in
3. m above sea level the glass pane in the door can break due to the reduction in air pressure Broken fragments are sharp edged and can cause serious injury IMPORTANT Remove all transporta tion safety components Saving energy Always ensure good ventilation Do not cover ventilation openings or grille Always keep fan louvres clear Do not place appliance in areas of direct sunlight or next to a stove heater or similar object The energy consumption depends on the installation conditions e g the ambient temperature Keep the time the appliance is open to a minimum GB Climate rating The climate rating indicates the room tem perature at which the appliance may be operatedinorderto achieve fullrefrigeration performance Klasse Class Classe Clase The climate rating is indicated on the type plate The position of the type plate is shown in the section entitled Description of the appliance Climate rating Room temperature SN 10 C to 32 C N 16 C to 32 C ST 16 C to 38 C T 16 C to 43 C SN ST 10 C to 38 C SN T 10 C to 43 C Do notoperate the appliance outside the speci fied room temperature range Setting up e Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m per 8 g of R 600a refriger ant used in the appliance so as to avoid the formation of inflammable gas air mixtures in the room where the
4. the recess with screws 4 Slide the appliance into the recess leaving a 21 mm gap between the body of the unit and 5 Then secure the appliance with 3 5 x 17 chip Operating and control elements The electronic control panel has the new touch capacitance technology Any function can be activated by touching the cor responding icon The exact contact point 4 is between the symbol and its label ee ly Light Up On Off Ventilation Alarm Operating elements Appliance ON OFF Temperature setting buttons Interior light ON OFF Mute alarm Fan ON OFF Temperature display Control elements Interior light ON symbol Alarm symbol Child lock activated symbol Fan ON symbol Switching the appliance on an off Switching on Press the On Off button so that the temperature display lights up flashes Switching off Press the On Off but ton for approx 3 seconds so that the temperature display goes out On Off Setting the temperature To reduce the temperature Press the Down button To increase the temperature Press the Up button While you are entering the tem perature the set temperature will flash on the display You can change the settings in increments of 1 C briefly pressing the button again The electronic controls will switch over automatically about 5 sec onds after the last time you pressed the button and t
5. Operating instructions Pages AA Wine storage cabinet 7081 179 00 WkEes 1112 Disposal notes The appliance contains reusable materials and should be disposed of properly not simply with unsorted household refuse Appliances which are no longer needed must be disposed of in a professional and appropriate way in accordance with the current local regulations and laws When disposing of the appliance ensure thatthe refrigerant circuit is not damaged to prevent uncontrolled escape of the refrigerant it contains data on type plate and oil e Disable the appliance e Pull out the mains plug e Cut through the connection cable Z warnine Danger of suffocation due to packing material and plastic film Do not allow children to play with packaging material Take the packaging material to an official collection point Range of appliance use The appliance is suitable solely for storing wine in a domestic environment or similar This includes for example use instaff kitchenettes bed and breakfast establish ments by guests in cottages hotels motels and other forms of accommodation in catering and similar services in the wholesale trade Use the appliance solely as is customary within a domestic envi ronment All other types of use are inadmissible The appliance is not suitable for storing and cooling medicines blood plasma laboratory preparations or similar substances and products cov ered by
6. ained from your dealer Changing the filter Take the filter by the handle Turn it 90 to the left or right and remove Inserting the filter Insert with the handle in a verti cal position Turn it 90 to the left or right until it clicks into place Equipment Pull out grid shelves The pull out grid shelf allows bottles of wine to be removed more easily KO gt is Tall wine bottles can also be stored crossways on the wooden shelves To ensure stable storage of the bottles click the retaining plates provided onto the middle slat of the wooden shelf es CAUTION Do not store bottles crossways on the interior floor Otherwise bottles may fall out when the appliance door is opened andthis may cause injury or material damage GB Defrosting The appliance defrosts automatically Cleaning Before cleaning always switch off the appliance Pull out the mains plug or switch off or unscrew the fuse e Clean the inside equipment and outer walls with lukewarm water and a little detergent Do not use abrasive or acid cleaners or chemical solvents Do not use steam cleaners because of the risk of injury and damage e Ensure that no cleaning water penetrates into the electrical com ponents or ventilation grille Do not damage or remove the type plate on the inside of the ap pliance It is very important for servicing purposes Malfunctions
7. doors or use them to support anything else e This appliance can be used by children of 8 years old and over and also by persons with restricted physical sensory or mental capacity or lack of experience and knowledge if they are supervised or have been instructed on safe use of the appli ance and understand the resulting risks Children must not be allowed to play with the appliance Cleaning and user maintenance must not be car ried out by children without supervision e Avoid prolonged skin contact with cold surfaces or chilled frozen food This could cause pain numb ness and frostbite In the case of prolonged skin contact protective measures should be taken e g gloves should be worn e Do not consume food which has been stored for too long as it could cause food poisoning e Donotstore explosives or sprays using combusti ble propellants such as butane propane pentane etc inthe appliance Electricalcomponents might cause leaking gas to ignite You may identify such sprays by the printed contents or a flame symbol e Do not use electrical appliances inside the appli ance e The appliance is designed for use in enclosed areas Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions e The LED light strip illuminates the interior of the appliance It is not suitable for lighting a room e When transporting or operating the appliance at an altitude of more than 1500
8. he actual temperature will be displayed The temperature can be set at between 5 C and 20 C GB Fan switch Thereby a climate which corresponds to that of a wine cellar is achieved inside the appliance Corks are prevented from drying out due to an increased level of humidity Switching on Press the Ven tilation button The symbol will light up O x Switching off Press the Ven ened a vonnanon tilation button again The 4 symbol will go out Audible warning signal The audible warning signal helps to protect your wines against excessive temperatures o x A On Off Ventilation Alarm It sounds when the door has been left open for longer than 60 seconds It sounds when the interior gets too warm or too cold The tem perature display will also flash The _ symbol lights up The audible warning device is switched off by pressing the Alarm button The temperature display will continue to flash until the cause of the alarm has been rectified Interior light The interior of the appliance is lit by an LED light strip at the top of the interior container Theinteriorlightwillalways switch on when the appliance door is opened Press the Light button if you want the interior light to be on even when the door is closed The o symbol lights up when the light is switched on The light intensity of the LED light corresponds to laser class 1 1M A Important The light cover may
9. omplies with the relevant safety regulations and EC Directives 2004 108 EC and 2006 95 EC 13
10. only be removed by customer service staff If the cover is removed do not look directly at the light through optical lenses from close distance This can damage your eyes Furthermore the brightness of the lighting can be adjusted Press and hold the Light button and at the same time press the temperature setting buttons to increase or decrease the brightness Down darker Up brighter 11 12 Setup mode The following functions can be activated in setup mode E child lock display brightness E Child lock The child lock is designed to protect the appliance from being switched off accidentally Activating the child lock e Activate setup mode by pressing the lt button for 5 seconds Ventilation The display reads E e Press the 4 button Ventilation 1 The display reads IE e Press the A button again Ventilation The symbol will light up to indicate that the child lock is acti vated e Exit setup mode by pressing the o button Deactivating the child lock e Activate setup mode by pressing the lt button for 5 seconds Ventilation The display reads IZ e Press the 4 button Ventilation The display reads h hol e Press the button again Ventilation The symbol will go out indicating that the child lock is deac tivated e Exit setup mode by pressing the o button H Display brightness Adjusting the display brightness e Activate setu
11. p mode by pressing the lt button for 5 seconds Ventilation e Press the X button until H appears in the display Press the 4 button Ventilation The display reads h 5 e Press the A x buttons and set the brightness between Up own h D minimum and h 5 maximum e When you reach the desired level press the lt button Ventilation l e Exit setup mode by pressing the O button On Off e Close the door The new setting will activate after about 1 minute When commissioning the appliance the adjusted brightness will only be active once the set interior temperature of the appliance has been reached Storing wine If you are storing wine for long periods of time it should be stored at a temperature of between 10 C and 14 C This is the temperature wine cellars are kept at and it is just right to allow wine to mature properly The following drinking temperatures are recommended for the various types of wine Red wines 14 C to 18 C Ros wines 10 C to 12 C White wines 8 C to 12 C Sparkling wines Prosecco 7 C to 9 C Champagne 5 C to 7 C Storage diagram for 750 ml Bordeaux bottles Total 18 bottles Air exchange with activated charcoal filter The way in which wines continue to mature depends onthe ambient conditions The quality of the air is therefore decisive for preserv ing the wine We recommend that you replace the illustrated filter once a year Filters can be obt
12. the 2007 47 EC Medical Devices Directive Any misuse of the appliance may result in damage to or spoilage of stored goods Furthermore the appliance is not suitable for operation in potentially explosive atmospheres Description of the appliance Operating and control elements Activated charcoal filter Pull out shelves Safety instructions and warnings e To prevent injury or damage to the unit the ap pliance should be unpacked and set up by two people eIn the event that the appliance is damaged on delivery contact the supplier immediately before connecting to the mains e To guarantee safe operation ensure that the ap pliance is set up and connected as described in these operating instructions e Disconnect the appliance from the mains if any fault occurs Pull out the plug switch off or remove the fuse e When disconnecting the appliance pull on the plug not on the cable e Any repairs and work on the appliance should only be carried out by the customer service department as unauthorised work could prove highly dangerous for the user The same applies to changing the mains power cable e Do not allow naked flames or ignition sources to enterthe appliance When transporting and clean ing the appliance ensure thatthe refrigerant circuit is not damaged In the event of damage make sure thatthere are no ignition sources nearby and keep the room well ventilated e Do not stand on the plinth drawers or
Download Pdf Manuals
Related Search