SYBA SD-LP-MCS1P
Contents
1. moschip com All specifications and information are subject to change without prior notice All logos and trademarks referenced are the registered trademark of their respective owners2. SE MANL PM98X5 EN 1 User Manuual INTRODUCTION This PCI multi I O card uses the latest PCI based Peripheral controller chipset from MosChip enabling this card to be installed on any PCI capable PC system Most of the latest motherboards no longer come with serial or parallel port By using this card end user can add serial and parallel ports to their PC system allowing them to connect their serial and parallel devices This product offers superior performance and unmatched data transfer rates It is also ideal for industrial automation applications FEATURES AND SPECIFICATIONS General Easy installation automatically selects IRQ and I O address Supports 32 bit PCI Local Bus Specification Revision 2 1 Supports PCI power management Supports PCI IRQ sharing feature saves valuable resources for other add on cards Supports multiple cards on one PC i Supports Windows 98SE ME NT 2000 XP 32 64 bit Vista 32 64 bit Linux and DOS operating system Serial Port RS 232 Interface Compatible with industrial standard 16C550 UART On chip 16 byte depth FIFO in Transmit amp Receive paths of each port Fast data rate up to 115 2K bits sec on each port Supports Modem Control Signals Supports 5 6 7 8 bit serial format Supports Even Odd No Parity or Force Parity Parallel Port Interface IEEE1284 compatible parallel port Supports SPP PS2 EPP and ECP mode Fast data rate up to 1 5M Bytes se
3. WHQL driver Start Windows Vista Vista will automatically detect the PCI I O card Please choose Locate and install driver software recommended and click Continue then select I don t have the disc Show me other options Click on Browse my computer for driver software advanced and then browse the CD and choose the locations D NetMos NM98x2x2 Vista_64bit Please refer to the Driver Locations section of this manual for the correct driver folder path for your PCI I O card After that click the Next to continue It will display the message of Windows can t verify the publisher of this driver software Please choose Install this driver software anyway to finish the installation If another new hardware found screen comes up then just repeat step 3 6 to install all driver until finish Installing Driver for Windows Vista 32 bit 1 2 Start Windows Vista Vista will automatically detect the PCI I O card Please choose Locate and install driver software recommended and click Continue then select I don t have the disc Show me other options Click on Browse my computer for driver software advanced and then browse the CD and choose the locations D NetMos NM98xxx Vista_32bit Please refer to the Driver Locations section of this manual for the correct driver folder path for your PCI I O card After that click the Next to continue It wil
4. c On chip 16 byte FIFO HARDWARE INSTALLATION Turn off your computer and all devices connected to it Remove the computer s cover Refer to your computer user s manual for more details Locate an unused PCI slot and remove the metal bracket Save the bracket screw for later use Align the card horizontally with respect to the PCI slot and insert it into the slot firmly and evenly Take care not to force it into the slot Once you have properly positioned the card into the slot secure the card with the bracket screw you have saved 5 Replace the computer s cover 6 Turn your computer on You are now ready to install the driver AUN Driver Locations All the drivers for the following PCI I O cards can be located on the Driver CD under these folders path 1 MCS9805 or NM9805 1P NETMOS NM9805 2 MCS9815 or NM9815 2P NETMOS NM9815 3 MCS9820 or NM9820 1S NETMOS NM9835S 4 MCS9835 or NM9835 1S or 2S NETMOS NM9835S 5 MCS9835 or NM9835 2S1P NETMOS NM9835M 6 MCS9845 or NM9845 4S or 6S NETMOS NM9845S Note MosChip Semiconductor Technology acquired NetMOS Technology Inc in 2001 and the chipset part numbers were revised from NM98xx to MCS98xx but the drivers remain the same DRIVER INSTALLATION Installing Driver for Windows Vista 64 bit G During system start up press F8 to select Disable Driver Signature Enforcement You should always select this option when you use non
5. l display the message of Windows can t verify the publisher of this driver software Please choose Install this driver software anyway to finish the installation If another new hardware found screen comes up then just repeat step 2 5 to install all driver until finish Installing Driver for Windows 2000 Server 2003 and XP t 2 6 Start Windows Windows will automatically detect the PCI I O card Please choose Install from a list or specific location Advanced and click on the Next Please choose Search for best driver in these locations and select Include this location in the search and then click on the Browse to browse the CD and choose the locations D NetMOS NM98 gt cxx Win2K_XP_2003 Server Please refer to the Driver Locations section of this manual for the correct driver folder path for your PCI I O card After that click Next to install the driver Notice Do not select on Search removable media It will display the message of Completing the Found New Hardware Wizard Click on Finish to finish the installation If another new hardware found screen comes up then just repeat step 2 5 to install all driver until finish Installing Driver for Windows NT ME 98SE Linux amp DOS Please refer to installation document on the CD for installing these operating systems Updating Drivers All the latest drivers are available for download at this website http www
Download Pdf Manuals
Related Search