Uncle Milton Remote Control Roach
Contents
1. Installing batteries Tool required Small Phillips head screwdriver 1 Using a Phillips head screwdriver remove the battery cover from the bottom See Fig 1 2 Insert 3 AAA batteries as indicated in the battery compartment and replace cover Power switch Install batteries into controller 1 Using a Phillips head screwdriver remove the battery cover from peted the back of the controller switch See Fig 2 2 Insert 2 AA batteries as indicated in the battery compartment and replace cover Using your RC Roach 1 6 2142 Batteries not included AAA LRO3 x3 Requires 3x 1 5V AAA LRO3 batteries Batteries not included AA LR6 x2 Requires 2 x 1 5V AA LR6 batteries BATTERY SAFETY INFORMATION DO NOT USE rechargeable batteries Do not mix new and old batteries batteries of different types alkaline and standard carbon zinc Do not charge non chargeable batteries Use only batteries of the same or equivalent as recommended Insert batteries as indicated inside the battery compartment Remove batteries during long periods of non use Never short circuit the battery terminals Always remove exhausted batteries from product Dispose of batteries safely Do not dispose of this product in a fire The batteries inside may explode or leak Forward button Turn the power switches to the ON position on both the controller and roach See Fig 1 and Fig 2 Mo2. terference and 2 this device must accept any interference received including interference that may cause undesired operation AN WARNING Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE DO NOT DISCARD Questions Visit unclemilton com MANUFACTURED BY UNCLE MILTON INDUSTRIES INC P O Box 6281 THOUSAND OAKS CA 91359 USA 2011 Uncle Milton Industries Inc all rights reserved andTM designate trademarks of Uncle Milton Industries Inc PRINTED IN CHINA 2142 0250 041 1 V02
3. ve the rat forward or make it turn using the buttons on the controller See Fig 3 Note For best performance use ona smooth flat surface like a Fig 3 hardwood floor Rotate button NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur ina particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment to an outlet on a circuit different from that to which the receiver is connected Consult the manufacturer or an experienced radio TV technician for help FCC ID XCY2027UMI2010 27 Mhz MADE IN CHINA This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful in
Download Pdf Manuals
Related Search