CoolMax CA-300 power supply unit
Contents
1. 5 5A 50Hz 3 2 DC Output Power distribution configuration Model CA 300 3 3V 18A 5V 16A 12V 18A 12V 0 3A 5Vsp 2 0A 3 3 Protection The power supply itself is designed with short circuit over voltage and over load protection functions described as below 3 3 1 Short Circuit Protection A short circuit on any DC output will cause the power to latch The power supply will withstand a continuous short circuit to the output without damage or overseers to the unit The 5 Vss can be shorted indefinitely and will recover automatically when the short is removed 3 3 2 No Load Operation No hazardous conditions or damage to the supply will occur with all of the DC output connectors disconnected from the load 3 3 3 Over Load Protection When the total load exceed 130 160 of the maximum output current the power supply shall be latched into the state of shutdown 3 4 Physical Environment Operation Conditions The power supply shall be capable of continuous operation and meet all electrical specification without need for adjustment when subjected to the following environ mental conditions Temp Vs Load Condition Humidity 0 30C Full Load Operation 20C 80C 90 Rated Load 10 90 RH t20 80 80 Rated Load Storage 20C 80 5 90 RH No degradation of the power supply shall occur during shipping or storage at the specified condition 3 5 Regulatory Compliance Our power supp2. Model CA 300 1 Function Description This power supply is designed for personal computer There are six DC outputs 5V 5V 12V 12V 3 3V amp 5Vs_ and it provides power to all computer systems and peripherals with maximum protection Here are some of the key features S ATA ready All kinds of protection circuits OVP OPP SCP Fully supports all Intel amp AMD system demands 20 24Pin 4pin connectors available to support both 20Pin and 24Pin socket motherboards Tube tide design to tidy wires Anti corrosive nickel plated chassis 2 How to Setup It is rather simple to install this power supply to your precious computer tower Follow the steps below to finish the setup Stepl Open the computer tower cover put the power supply into the corresponding location of the tower and then use right screws to fix the power supply to tower Step2 Put the Main Power Connector ATX12V Connector S ATA Connector Peripheral Connectors and Floppy Connectors to the corresponding male connectors of main board peripheral devices i e HDD CDROM etc and floppy drivers respectively When you connect the connectors please pay attention to the orientation of them because of the different hole sizes Find the proper orientation and push down firmly making sure that the pins are aligned 3 1 Input Requirements The power supply shall operate as below 115V 100V min 132V max 10A 60Hz 230V 200V min 264V max
3. ly has been certified to comply with multi national Safety and EMI UL CUL CSA TUV FCC CB Caution Unauthorized personnel should not do this to avoid electrical shock 4 1 Do not open the top cover of the power supply case 4 2 Please keep the power supply from humidity 5 Simple Maintenance If power supply cannot work properly before send for repair please check the following items 5 1 Does power cord indeed plug into electrical outlet 5 2 Does Input Voltage set in power supply correspond to the main source in your environment 5 3 Please check the output connectors plugging in proper direction and connecting firmly 5 4 Please turn off the power and turn it on for several times and the interval must be at least 5 seconds 5 5 Having checked above items if the power supply still does not function please send it back to your retailer or distributor for repair
Download Pdf Manuals
Related Search