SYBA Gigabit Ethernet 34mm ExpressCard
Contents
1. G501975ECPGLAO Gigabit Ethernet ExpressCard User Manual Ver 1 00 All brand names and trademarks are properties of their Respective owners Features and Benefits Fully compliant with ExpressCard Specification 1 0 ExpressCard 34 Form Factor Module Fully compliant with IEEE 802 3 802 3u and 802 3ab 40 100 1000M data rate auto negotiation LEDs indicate the status of data transmission Support Wake On Lan WOL power management optional Feature full duplex mode that doubles that the network connection Support Windows R 2000 XP Server 2003 Vista and Linux Package Contents 1 x Gigabit Ethernet ExpressCard 1x Driver CD 1 x User Manual Note Contents may vary depending on country market System Requirements Windows R 2000 XP Server 2003 Vista Linux ExpressCard enabled system with an available ExpressCard slot CAT5 CAT5E CAT6 UTP STP cable Hardware Installation General instructions for installing the card are provided below Since the design of system may vary refer to your system s reference manual for further information if needed Insert the Gigabit Ethernet ExpressCard into the ExpressCard slot of your system Make sure itis inserted all the way in for a solid connection Driver Installation For Windows R 2000 XP Server 2003 Once the Windows R 2000 XP and Server 2003 starts Gigabit Ethernet ExpressCard will be detected by system Following is the procedures for installing Gigabit Ethernet ExpressCar2. d driver under Windows R XP Service Pack 2 operating system 1 When Found New Hardware Wizard Window pop up please click Cancel button to cancel the driver installation for the device at this moment The driver for this device will be installed in the next step 2 Please insert the CD driver bound with Gigabit Ethernet ExpressCard into your CD ROM Drive 3 At the Windows desktop click Start then Run Type D ExpressCard Gig Lan TE1310 windows setup exe then click OK Change D to match your CD ROM drive letter 5 Follow the on screen instructions to complete the instructions to complete the installation to complete the installation 6 Restart Windows to complete the installation For Windows R Vista In Windows R Vista when the system is booted up it automatically detects the Gigabit Ethernet ExpressCard and installs the Gigabit Ethernet ExpressCard with built in drivers Following is the procedures for upgrading Gigabit Ethernet ExpressCard driver under Windows R Vista operating system 1 Please insert the CD driver bound with Gigabit Ethernet ExpressCard into your CD ROM Drive 2 At the Windows desktop click Start then Run 3 Type D ExpressCard Gig Lan TE1310 windows setup exe then click OK Change D to match your CD ROM drive letter 4 Follow the on screen instructions to complete the instructions to complete the installation to complete the installation 5 Restart Windows to complete the installati
3. on Verify Driver Installation Click on the Device Manager tab in System Properties which you access from the Windows Control Panel You should see a Agere Systems ET 131x PCI E Gigabit Ethernet Adapter installed under Network adapters item Networking Settings 1 Click Network Connection in Control Panel to set your network settings 2 Right click the Local Area Connection used by the Gigabit Ethernet ExpressCard then select Properties from the pop up menu 3 Double click the Internet Protocol TCP IP item to set network settings 4 Right click the Local Area Connection used by the Gigabit Ethernet ExpressCard then select Status from the pop up menu You can affirm network status
Download Pdf Manuals
Related Search