CyberPower COMMCARD300
Contents
1. Status Information Card Status Information Card Installation a a a a Switch off the Paragon UPS using the on off button located on the front panel of the unit see the Paragon Series User Manual Disconnect from the power supply Unscrew the communication card cover at the rear of the unit The default pin settings can be modified optional pinout configuration procedure pin 2 used for the replace battery signal in the default configuration but can be reconfigured for the emergency off command pin 5 provides a common electrical reference for all signals Connected to 0 volts in the default configuration but can be reconfigured for volt free contacts See configuring pins 2 and 3 below for further information on modifying the default configuration Insert the status information card Secure the card with the screws Functions This relay card provides you with a simple means of transmitting data to a management system a PLC or a computer system using a 9 pin connector with the following pinout a a A battery test is performed when the UPS is first powered on then again weekly adjustable with UPS Driver If a battery fault is detected the contact closes DODODDOO Pin 1 chassis ground Pin 2 contact closed when the battery must be replaced Relay breaking capacity Vmax 25V DC Imax 1A no normally open nc normally cl2. 11537 External emergency Remote EPO switch wiring must be 10m maximum boo power off contact Status Information Card 3 CyberPower Status Information Card
3. osed Pin 4 contact open when operating on battery supply Pin 5 common electrical reference for all signals 0V Pin 6 contact closed when operating on automatic bypass Pin 7 contact closed when a low battery warning is received Pin 8 contact closed when your application is powered via a UPS Pin 9 contact closed when operating on battery supply 2 Status Information Card Configuring pins 2 and 5 optional Possible settings Standard settings Replace battery and common electrical reference at 0V JP01 BATT FAIL JP02 EPO JP03 GND JP04 Connected Connected Removed Connected Comments Pin 2 delivers the replace battery signal e Pin 5 is referenced to OV Customer settings Replace battery and volt free contacts JP01 BATT FAIL JP02 EPO JP03 GND JP04 Connected Connected Removed Removed Comments Pin 2 delivers the replace battery signal Pin 5 is volt free Customer setting Emergency Power Off EPO JP01 BATT FAIL JP02 EPO JP03 GND JP04 Removed Removed Connected Connected Comments Pins 2 and 5 receive the customer Emergency Power Off command S1 wiring max length 10m see diagram below pin 5 remains connected to OV Opening of external contact S1 immediately shuts the Paragon UPS off o_o The Emergency Power Off configuration only Y Y works if pin 5 remains connected to OV
Download Pdf Manuals
Related Search