Philips Docking Entertainment System AJ300D
Contents
1. Pl repeatedly to set and adjust the mintues 5 Press ALM1 or ALM2 to confirm SETTING THE ALARM MODE 1 Press POWER to switch to standby mode 2 Select your choice of alarm mode either docked player only for Apple iPod and Philips GoGear SA9100 and SA9200 buzzer or radio by using the DOCK BUZZER TUNER slider e At the set alarm time the docked player only for Apple iPod and Philips GoGear SA9100 and SA9200 or radio or buzzer will switch on automatically Helpful hints Ifyou have selected TUNER alarm mode make sure you have properly tuned to a station before turning off the set Ifyou have selected DOCK alarm mode only for Apple iPod and Philips GoGear SA9100 and SA9200 make sure you have docked the compatible player or the buzzer mode will be selected automatically To check the alarm time setting for ALM1 or ALM2 press ALM1 or ALM2 SWITCHING OFF THE ALARM con for the cur There are three ways of switching off the alarm Unless you cancel the alarm completely the 24 hour ALARM RESET will be automatically selected after 59 minutes from the time your alarm first goes off 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day e Press POWER REPEAT ALARM This repeats your alarm call at 9 minute intervals e During the alarm call press REPEAT ALARM sricHtNess CONTROL2. replace the battery with a new CR2025 type battery 1 Pull the battery tray out as shown in the figure 2 Replace a new battery according to polarity indication and fully insert the battery tray back to the original position is Sd Battery contain chemical substances so they should be disposed of properly Q S 5 gt i CAUTION High voltage Do not open You run the risk of getting an electric shock The machine does not contain any user serviceable parts Modification of the product could result in hazardous radiation of EMC or other unsafe operation This product complies with the radio interference requirements of the European Community SELF POWERED BACK UP The self powered back up conveniently allows your preset stations alarm and clock time settings to be stored for up to 10 minutes when there is a power interruption e g AC power failure The complete clock radio and backlight illumination will be switched off If power supply returns after 10 minutes and the display shows e clock time blinking indicates you need to re adjust the clock time BASIC OPERATION Switching on the system e Press POWER The system will switch to the last selected source e Press TUNER AUX or DOCK The system will switch to the selected source Switching the system to standby mode e In any source mode press POWER Switching off the volume temporarily Press MUTE on the remote control to stop sound play back in
3. Display shows ALM1 or ALM2 flashing during a repeat alarm e Repeat if desired up to a maximum of 6 times CANCELING THE ALARM COMPLETELY e Press ALM 1 or ALM 2 button once or more until ALM1 or ALM2 disappears DOCK See 4 By connecting the iPod Philips GoGear to your AJ300D you can listen to the sound of the docked player through the powerful speakers of the Hi Fi system Important e AJ300D comes with two dock types Use the designated dock type as indicated on the top panel of the dock supplied to work with either Apple iPod or Philips GoGear COMPATIBLE PORTABLE PLAYER e Apple iPod models with 30 pin dock connector as follows Nano 1st 2nd 3rd generation iPod 5th generation video iPod touch and iPod classic e Philips GoGear players with dock connectors as follows HDD1420 HDD1620 HDD1630 HDD1635 HDD1820 HDD1830 HDD1835 HDD1840 1850 HDD6320 HDD6330 SA9100 SA9200 CHANGING THE DOCK The iPod connector is pre installed with the AJ300D main unit For Philips GoGear users change to the supplied Philips GoGear connector before use 1 Slide the dock switch located near the dock connector to of 2 Take the dock out 3 Correctly place the suitable dock in Then firmly hold down the dock and simultaneously push the dock switch back to position DOCK ADAPTERS Before plugging your player in the dock snap the suitable dock adaptor into the dock to provide a snug fit for the pla
4. Docking Entertainment System AJ300D Docking Entertainment System Register your product and get support at Meet Philips at the Internet www philips com welcome http www philips com User manual English DY PHILIPS PH l LI PS Printed in China PDCC ZYL 0824 PRESET English Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your prod uct at www philips com welcome SUPPLIED ACCESSORIES 1 X certified AC DC 18V adapter Input 100 240V 50 60Hz 800mA Output 18V 1 6A Docking kit e 1 X Apple iPod dock pre installed with AJ300D 1 X Philips GoGear jukebox dock dock adapters 4 adapters for different iPod types and 4 adapters for different Philips GoGear types 1 X AUX IN cable CONTROLS See 1 POWER switches the system on or to standby mode stops active alarm for 24 hours deactivates the sleep function 44 gt gt adjust clock alarm time selects previous next tracks in the dock mode fast searches forward backward in the dock mode only available to iPod PRESET 1 5 stores recalls and shows radio station SLEEP activates the sleep function deactivates the sleep function DOCK selects dock mode for Apple iPod and Philips GoGear TUNER AUX selects FM radio mode selects AUX m
5. and position the pigtail fully to obtain optimum reception STORING AND USING PRESET STATIONS You can store up to 5 FM radio stations in the memory 1 Tune to your desired station see TUNING TO RADIO STATIONS 2 To store a preset hold down briefly on a PRESET button 1 5 until you hear a dou ble beep Display shows the preset number of your station 3 Repeat steps 1 and 2 to store your other stations e You can overwrite a preset station by storing another frequency in its place 4 Press a PRESET button 1 5 or PRESET YW A on the remote control to listen to a preset station To display clock time press PI on the set USING THE ALARM GENERAL Two different alarm times can be set This can be useful when you need to be woken up at a different time e g during the week and at the weekend and you can set different wake up modes e tuner mode buzzer mode The gentle wake buzzer alarm increases its beep tone frequency within seconds e dock mode only for Apple iPod and Philips GoGear SA9100 and SA9200 SETTING THE ALARM TIME See 3 1 In any mode press and hold ALM1 or ALM2 for two seconds ALM1 ALM2 icon and the hour digits flash And the icon for the current alarm mode also flashes 2 Hold down or press Kd gt repeatedly to set and adjust the hours 3 Press ALM1 or ALM2 to confirm ALM1 ALM2 icon and the minutes digits flash And the rent alarm mode also flashes 4 Hold down or press Ht4
6. ck of the audio contents stored on the docked player CHARGING iPod PHILIPS GoGear BATTERY USING THE DOCK Docking your iPod Philips GoGear and connecting the dock to AJ300D you can charge the iPod GoGear in the standby mode and power on mode of AJ300D SLEEP This set has a built in sleep timer which enables the radio to be automatically switched off after a set period of time There are five sleep time options parte and switching off SLEEP 1 During playback set your timer by pressing SLEEP repeatedly until the desired timer option appears Selections are follows time in minute AEFI E GOOF Fo MED 2 The set will turn off automatically at the selected time 3 To cancel sleep press either POWER SLEEP once or more until SLEEP disappears from the display Reset Should your set receive external interference e g static electricity from carpets thun derstorms etc RESET allows you to clear all previous settings and start up again e Use a ballpoint pen to press the RESET hole found on the bottom of the set CONNECTING AN EXTERNAL DEVICE You can listen to the sound of the connected external device through your AJ300D s speakers 1 Press TUNER AUX twice to select AUX mode 2 Use the supplied AUX IN cable to connect AJ300D s AUX IN jack to an AUDIO OUT or headphone jack on an external equipment such as CD player or VCR MAINTENANCE amp SAFETY Install the unit near the AC outlet and where the AC p
7. e 2002 96 EC Please inform yourself about the local separate collection sys tem for electrical and electronic products Please act according to your local rules and do not dispose of your old products with your normal household waste The correct disposal of your old product will help prevent potential negative consequences for the environment and human health
8. ed into three materials cardboard polystyrene and plas tic Your set consists of materials which can be recycled if disas sembled by a specialized company Please observe the local regulations regarding the disposal of packaging dead batteries and old equipment Electrical malfunction e Unplug the power cord then re plug Intermittent crackling sound during FM reception Weak signal e Extend and position the pigtail aerial The alarm does not function Alarm time mode not set e See SETTING THE ALARM Dock mode is for Apple iPod and Philips GoGear SA9100 and SA9200 Volume too low for radio e Increase the volume Dock operation The menu navigation or photo playback of the docked player cannot be car ried out through the buttons on AJ300D or its remote control e The buttons on AJ300D and its remote control can control playback of audio con ents only To navigate the menu use the controls on the docked player Some buttons on AJ300D and its remote control have no function e The buttons PII 44 gt gt and VOLUME function only For Philips GoGear fast orwarding rewinding is not available Disposal of your old product Your product is designed and manufactured with high quality materials and components which can be recycled and reused When this crossed out wheeled bin symbol is attached to a product it means the product is covered by the European Directiv
9. ode O Pal starts pauses playback in the dock mode selects 12 hour or 24 hour mode VOL adjusts the sound level MUTE switches playback sound off and on Display shows clock alarm times and status of the set Dock connector 30 pins connects iPod Philips GoGear player ALM2 activates confirm ALARM 2 time setting displays ALARM 2 time switches off ALARM 2 time 3 REPEAT ALARM BRIGHTNESS CONTROL switches off the alarm for a 9 minute period changes the brightness of the display illumination POWER jack socket for AC DC 18V adapter 45 Pigtail improves FM reception ALM 1 activates confirm ALARM 1 time setting displays ALARM 1 time switches off ALARM 1 time 42 TIME SET activates confirm clock time date setting Wake up mode DOCK BUZZER TUNER selects alarm mode dock buzzer or radio AUX IN jack 3 5 mm connects to external audio source RESET clears clock time setting POWER SUPPLY Mains adapter 1 Connect the mains adapter to the set s DC 18V socket and to the power socket Helpful hints To avoid damage to the set use only the adapter supplied The type plate is located on the bottom of the set Remote control Important e Before using the remote control remove the insulation plastic tab as shown in the figure Ifthe remote control does not function correctly or the operating range is reduced
10. ower plug can be easily reached The apparatus shall not be exposed to dripping or splashing Do not expose the set to humidity rain sand or excessive heat caused by heating equipment or direct sunlight To clean your set use a soft damp cloth or chamois leather Do not use clean ing products which contain benzene thinner etc as these may harm the hous ing Where the MAINS plug or an appliance coupler is used as the disconnect device the disconnet device shall remain readily operable Batteries battery pack or batteries installed shall not be exposed to exces sive heat such as sunshine fire or the like SPECIFICATIONS Power Consumption Output power Dimensions w x h x d 161 x 191 x 164 mm atest Sct Steed 1 34 kg TROUBLESHOOTING If a fault occurs first check the points listed below before taking the set for repair If you are unable to remedy a problem by following these hints consult your dealer or service centre WARNING Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee Do not open the set as there is a risk of electric shock No sound Volume not adjusted e Adjust the volume The set is muted e Press MUTE on the remote control to active playback sound Display error no reaction to any controls ENVIROMENTAL INFORMATION All unnecessary packaging material has been omitted The packaging can be easily separat
11. stantly Playback will continue without sound and the display shows MUTE e To start sound playback you can press MUTE again adjust the volume controls change source Illumination brightness Press REPEAT ALARM BrIGHTNESS CONTROL once or more e The brightness of the display can be adjusted Bright gt Low gt Off gt Bright SETTING THE CLOCK AND DATE In any mode press and hold TIME SET until clock digits flashes Press PHI to select 12 Hours 24 Hours mode Hold down or press 4 PPI repeatedly to set and adjust the hours L Press TIME SET to confirm The clock digits for the minutes flash ROH 5 Repeat the steps 3 4 until you complete all the other settings for minutes year month and days TUNER 1 Press TUNER AUX once to switch on the radio FM only Display shows the radio frequency of the last selected waveband Your preset station is also shown if you are listening to a preset See 2 2 Adjust the sound using VOL 3 To select preset stations press the respective PRESET button 1 5 TUNING TO RADIO STATIONS 1 Press and hold I4 gt gt until the frequency in the display starts changing Display shows Scrh during automatic tuning After the system tunes to a station of sufficient reception display shows its frequency e To tune to a weak station press M4 l briefly and repeatedly until an optimal reception is found To improve reception FM Extend
12. yer to be docked Selecting the correct dock adaptor e 4 Pod dock adaptors are included Each adaptor has indication to match differ ent iPod types e For the Philips GoGear dock 4 dock adaptors of different type are included Each adaptor is marked a number from 1 to 4 at its back These numbers indicate the fit Philips GoGear players as follows 1 HDD6320 6330 2 HDD1420 1620 1630 1635 1820 1830 1835 3 HDD1840 1850 4 SA9100 SA9200 PLAYING APPLE iPod PHILIPS GoGear USING AJ300D 1 Snap the compatible iPod GoGear into the dock connector 2 Press DOCK to switch on the dock mode e Make sure that you have powered on Philips GoGear before selecting DOCK source On the AJ300D s display HDD is displayed when GoGear player is connected or iPod is displayed when iPod is connected 3 For iPod the connected player will play automatically e For Philips GoGear press MI to start playback if the playback doesn t start Notes In dock mode if no player is docked for 15 minutes AJ300D will come to standby By using the buttons PAL 44 gt gt and VOLUME on the AJ300D and its remote control the following disc playback features are available Play Pause selecting next previous track fast forwarding rewinding only available to Apple iPod and changing volume The buttons PM 4 gt gt and VOLUME on the AJ300D and its remote control can work only with playba
Download Pdf Manuals
Related Search