Sunbeam Pedestal Fan with Remote Control
Contents
1. power surges power dips voltage supply problems or use of the product on incorrect voltage servicing or modification of the product other than by Sunbeam or an authorised Sunbeam service centre use of the product with other accessories attachments product supplies parts or devices that do not conform to Sunbeam specifications or exposure of the product to abnormally corrosive conditions or e extend beyond 3 months if the product is used in commercial industrial educational or rental applications The benefits given to you by our warranty are in addition to other rights and remedies under law in relation to the product In Australia our goods come with guarantees that cannot be excluded under the Australian Consumer Law You are entitled to a replacement or refund for a major failure and for compensation for any other foreseeable loss or damage You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure Our goods also come with guarantees that cannot be excluded under the New Zealand Consumer Guarantees Act If your warranty claim is not accepted we will inform you and if requested to do so by you repair the product provided you pay the usual charges for such repair You will also be responsible for all freight and other costs Should your product require repair or service after the warranty period cont2. 2 Insert the lower extension shaft firmly into the base and attach the moulded securing knob to the underside of the base and tighten Refer Figure 4 Figure 5 Sontrol Remote Co Memole U Oscillation Your pedestal fan oscillates 70 distributing cool air throughout the room Remote control Operates within 8 metres of the Pedestal Fan Fan speed button Choose from 3 speed settings low medium or high Preset Timer The preset timer allows you to set your pedestal fan to turn Wind Mode off after 1 2 or 4 hours You have a choice of 2 Nature or Sleep airflow types When used in nature mode the fan speed is randomly adjusted giving the feeling of a natural breeze When set to Sleep Mode the fan speed decreases after 30 minutes from high to medium then medium to low Using the remote control Inserting or changing the batteries 1 Point the remote towards the control panel 1 Slide battery tray at the base of the unit on the front of the pedestal to operate 2 Insert the button cell battery provided with your pedestal fan 3 Slide battery tray into the base of the remote control unit Using Your Pedestal Fan 1 Place the pedestal fan on a flat level surface 2 Adjust the height by unlocking the height adjustment clip on the lower shaft Raise the shaft to your selected height and engage the clip to lock into place Insert the plug into a 230 240 V power
3. Sunbeam Pedestal Fan with Remote Control Instruction Booklet FA8600 40cm Pedestal Fan Please read these instructions carefully and retain for future reference Sunbeam s Safety Precautions Sunbeam is very safety conscious when designing and manufacturing consumer products but it is essential that the product user also exercise care when using an electrical appliance Listed below are important precautions for the safe use of an electrical appliance Read carefully and save all the instructions provided with an appliance Always turn the power off at the power outlet before you insert or remove a plug Remove by grasping the plug do not pull on the cord Turn the power off and remove the plug when the appliance is not in use and before cleaning Do not use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person Always use your appliance from a power outlet of the voltage A C only marked on the appliance This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance The temperature of accessible surfaces may be high when the appli
4. Guard Ring Blade Knob Fan Blade Guard Locking Nut Rear Guard Base Locking Nut Handle Motor Cover Screw Rear Stand Screw Cord Clip Stand Height adjustment Locking Clip Extension Shaft Base Control Panel Remote Control a Assembling Your Pedestal Fan 1 Unpack all the components from the box 2 Unfasten the interlocking nut and blade knob from the front of the motor See Figure 2 and place to one side Figure 1 3 Attach the rear fan blade grill and ensure it is in the correct orientation with the UP and the two holes aligned at the top See Figure 1 Firmly screw on the interlocking nut 4 Mount the fan blade onto the motor shaft and fasten the blade knob firmly by turning in an anti clockwise direction See Figure 2 Figure 2 5 Open the front guard clip and attach the fan blade grill with the UP word which appears on the inside of the grill the Sunbeam logo should be straight Push the round edges of the grill firmly together with the back grill and lock the clip Using a Phillips head screwdriver tighten the screw provided See Figure 3 Figure 3 Assembling Your Pedestal Fan continued Connecting The Stand base extension shaft 3 Insert the upper shaft into the extension upper shaft and base locking nut shaft and secure with the rear stand Screw 1 Locate the base locking nut using a flat head screw driver
5. resolve your difficulties or if the product is defective advise you on how to obtain a replacement or refund To assist us in managing warranty claims we recommend you register your product as soon as practicable after purchase by creating a MySunbeam account on our website and send a copy of your original receipt to Sunbeam In order to make a claim under our warranty you must have the original proof of purchase documentation for the product and present it when requested Should your product develop any defect within 2 years of purchase because of faulty materials or workmanship we will replace or repair it at our discretion free of charge A product presented for repair may be replaced by a refurbished product of the same type rather than being repaired Refurbished parts may be used to repair the product Our replacement or repair warranty only applies where a defect arises as a result of faulty material or workmanship during the warranty period Your warranty does not cover misuse or negligent handling including damage caused by failing to use the product in accordance with this instruction booklet accidental damage or normal wear and tear Your warranty does not e cover freight or any other costs incurred in making a claim consumable items accessories that by their nature and limited lifespan require periodic renewal such as filters and seals or any consequential loss or damage or e cover damage caused by
6. act your nearest Sunbeam service centre For a complete list of Sunbeam s service centres visit our website or call our customer service line for advice on 1300 881 861 in Australia or 0800 786 232 in New Zealand Need help with your appliance Contact our customer service team or visit our website for information and tips on getting the most from your appliance In Australia Visit www sunbeam com au Or call 1300 881 861 In New Zealand Visit www sunbeam co nz Or call 0800 786 232 Sunbeam is a registered trademark ade in China Due to minor changes in design or otherwise the product may differ from the one shown in this leaflet Copyright Sunbeam Corporation Limited 2012 ABN 45 000 006 771 Units 5 amp 6 13 Lord Street Botany NSW 2019 Australia Unit 3 Building D 26 Vestey Drive t Wellington Auckland ew Zealand Sunbeam Corporation is a division of GUD Holdings Ltd 6 13
7. ance is operating Never leave an appliance unattended while in use Do not use an appliance for any purpose other than its intended use Do not place an appliance on or near a hot gas flame electric element or on a heated oven Do not place on top of any other appliance Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface Do not operate any electrical appliance with a damaged cord or after the appliance has been damaged in any manner If damage is suspected return the appliance to the nearest Sunbeam Appointed Service Centre for examination repair or adjustment For additional protection Sunbeam recommend the use of a residual current device RCD with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances Do not immerse the appliance in water or any other liquid unless recommended Appliances are not intended to be operated by means of an external timer or separate remote control system This appliance is intended to be used in household and similar applications such as staff kitchen areas in shops offices and other working environments farm houses by clients in hotels motels and other residential type environments bed and breakfast type environments If you have any concerns regarding the performance and use of your appliance please visit www sunbeam com au or contact the Sunbeam Consumer Service Line Ensure
8. es wind speed circulates as this sequence 3 0sc O This just turns oscillation on or off with each press 11 Care and Cleaning e Ensure that your pedestal fan is switched e Take care that excessive dust does not build off and disconnected from the power outlet up in or around the motor body Use a dry before cleaning soft brush or vacuum cleaner to remove it e Carefully wipe your fan using a clean e Do not allow the motor or other electrical soft cloth Do not use abrasive cleaners components to be exposed to water or brushes to clean the fan as these will e Always store your fan in a cool dry place scratch and damage the surface when not in use preferably in the original box umbeam 2 Year Warranty This Sunbeam product is covered by a 2 year replacement or repair warranty which is in addition to your rights under the Australian Consumer Law if your product was purchased in Australia or New Zealand Consumer Guarantees Act if your product was purchased in New Zealand Should you experience any difficulties with your product during the warranty period please contact our customer service line for advice on 1300 881 861 in Australia or 0800 786 232 in New Zealand Alternatively you can send a written claim to Sunbeam to Australia Units 5 amp 6 13 Lord Street Botany NSW 2019 Australia New Zealand 26 Vestey Drive Mt Wellington Auckland New Zealand Upon receipt of your claim Sunbeam will seek to
9. op of the pedestal When disposing of the fan at the end of its useful life follow local regulations Do not coil the power cord too tightly around the motor housing as this may damage the cord Locating Your Pedestal Fan 1 Always locate your fan on a level surface 2 Your pedestal fan should be located in a dry cool well ventilated location Keep your fan away from heat sources corrosive gases and avoid direct sunlight 3 Do not attempt to move your pedestal fan whilst it is operating If your fan needs to be moved please ensure that it is turned off and you use the carry handle on top of the fan Features Of Your Sunbeam Pedestal Fan D gt Us Metal Grille Easily assembled 50cm secure grille Mas N Im a gt d Plastic Fan Blades 3 blades to effectively move the air about your room i l D Sm i N I N SS IR DH i 7 Control Panel Simply press the on off button to turn the unit on Use the other buttons to select wind mode timer speed and oscillation functions PS gt 117799 RY y N 2 Y Wy Uf las EA Solid Base Makes your pedestal fan stable and secure zz BOB Parts Identification Cvs OY OV oS OPP RP RP RP PrP rrr wo OOAN DA VO PwWwWM Hm OO Locking Screw Front Guard Guard Clip
10. outlet and turn the power on Note Only adjust the height when the fan is switched off 3 Press the on off button on the fan or the remote control The fan will start at low speed Selecting a fan speed 1 To select a fan speed simply press the speed button on either the fan or remote control repeatedly to select the desired speed from the 3 settings available The LED lights indicate the selected speed setting Note If you will not be using the fan for a length of time it is advisable to turn the power off at the wall socket and unplug the power cord Using Your Pedestal Fan continued Oscillation Press the oscillation button to turn on To turn oscillation off press the oscillation button again Tilting Head 4 position vertical 3 position horizontal 10 Timer Pre set to turn off To pre set the timer to turn the fan off press the timer button to switch to timer mode Press the 1 2 or 4 hours timer button to select When this set time is reached the fan will switch OFF automatically Using Your Pedestal Fan continued Operations 1 ON OFF Press this symbol to control the fan power on or off Touch one time fan shows power on for one more time the fan is power off 2 Wind Speed 2 Press this symbol to control the wind speed Press one time show the low speed press two times shows the medium speed press three times shows the high speed press more tim
11. the above safety precautions are understood Safety Precautions For Your Pedestal Fan e Do not use outdoors Do not run the cord of the fan under carpeting Do not cover the cord with throw rugs runners or other floor coverings Arrange the cord away from traffic areas so that it will not be tripped over Do not use this fan in the immediate surrounds of a bath shower laundry area or swimming pool e Be sure the fan is placed on a dry even surface Do not use on soft surfaces such as beds e When operating with the oscillation function do not place the fan in a position that may restrict or impede its movement e Keep your fan away from heat sources corrosive gases and avoid direct sunlight e This fan is only to be used with the base fitted and in good condition e Disconnect the power plug before dismantling assembling or before cleaning Always unplug the fan when not in use The fan must not be used if the guards are damaged in any way Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause electric shock or fire or damage to the fan Never insert fingers or any other objects through the guards whenever the power plug is connected especially while running Avoid touching moving parts of the fan Do not attempt to move your fan whilst it is operating If your fan needs to be moved please ensure that it is turned off and you use the carry handle on t
Download Pdf Manuals
Related Search