Anthem™ PVA 2/5/7 Owner`s manual
Contents
1. REAR LEFT 4 OUTPUT n INPUTS FRONT RIGHT REAR OUTPUT RIGHT INPUTS FRONT 0 SURROUND INPUTS RIGHT LEFT SURROUND OUTPU CENTER INPt LEFT FRONT OUTPUT RIGHT FRONT OUTPUT CENTER OUTPUT A A WARNING SHOCK HAZARD DO NOT OPEN AVERTISSEMENT RISQUE DE CHOC LECTRIQUE NE PAS OUVRIR A 6 1 Single Ended RCA Inputs 2 Trigger Input and Output 3 On Mode Trigger Manual Auto PVA7 4 Power Cord Socket 5 6 Speaker Binding Posts Chassis Ground2. JALONNECTIONS AND OPERATION ummm 2 1 SPEAKER CONNECTIONS Each 5 way binding post accepts a connection from one speaker Connect the positive red connection on the speaker to the positive red binding post on the appropriate amplifier channel As well connect the negative black connection on the speaker to the negative black binding post on the same amplifier channel Be careful not to overtighten the binding posts 2 2 INPUT CONNECTIONS The input signal connection is made with connectors from a suitable preamp or surround sound processor Connect the outputs from your preamp or surround sound preamp to the corresponding Right Right Surround Right Rear Center Left Surround Left Rear and Left inputs number of channels depends on PVA model 2 3 ON MODES With the three way switch located on the rear panel you can set the way your amplifier is turned on and off To use Trigger On connect a standard 3 5mm 125 mono mini plug cable between your PVA amplifier and the preamplifier or control component Once all other connections are made connect the power cord to the amplifier and then the wall outlet One or two clicks should be heard from relays inside the amplifier a few seconds after power is turned on Manual On When in this position the amplifier is turned on off via the power button on the front panel Trigger On This feature allows your amplifier to be turned on or off remotely via the trigger T
3. he 3 5mm 125 mini jack INPUT receives power from an upstream component or system ui E n controller and delivers the same trigger signal through the OUTPUT to other components The power for the relay can range from 5 to 24 volts AC or DC The power button on the front panel must be left on Auto On This innovative feature also eliminates the need to manually operate the power button Auto On turns the amplifier on whenever it senses an input signal on any one of the channels and switches off 20 minutes after the input signal stops The power button on the front panel must be left on 2 Color LED In Manual mode the LED on the front panel is lit green when the amplifier is on In Auto or Trigger mode the LED is lit red to indicate standby mode and green to indicate operate mode Note Your PVA amplifier is equipped with a thermal shut off feature In the event of overheating due to overload the affected channel will remain off until the temperature falls below the shut off threshold Once this condition is met the channel will reset itself JALONNECTIONS AND OPERATION cootimued 2 4 REAR PANEL LAYOUT PVA5 PVA 2 TRIGGERS INPUT 5 24V ACDC ouTPUT ON MODES TRIGGER MANUAL CHASSIS 120v eop GROUND I50OVA MAXIMUM ANTHEM MADE IN CANADA PVA 7 0 REAR LEFT REAR LEFT
Download Pdf Manuals
Related Search