NEC (OP-270-69001) Plug
Contents
1. by Innovation Al 16x DVD R RW DL QUICKSTART GUIDE 16x DVD Quickstart Guide Table of Contents WEICOM Oe dura 2 Hardware System Requirements 3 Drive cece eee 4 Using MOU DINE sasien eater anaes 6 About DVD Media 7 Product Specifications 8 DISC CAG aden 9 Troubleshooting amp Technical 5 10 Warranty Information 0 0 00 ccc cece ees 11 16x DVD Quickstart 16x DVD Quickstart Guide DVD ReWritable R RW B DVD R DL COMPACT ISG ReWritable Welcome Thank you for purchasing the NEC 16x DVD R RW DL drive Please remove your service tag sticker found on the outer carton s label This label contains your drive s service tag number and model number and can be placed in the space below or can be affixed to the outer cover of your PC You will need this information for product registration and to obtain technical support service To register this product online please visit http www necsam com registration Save the box that your drive was shipped in as NEC can not be held accountable for damages caused by shipping in the case of a returned product Service Tag Number Purchase Date FCC NOTICE This equipment has been tested and2. found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee interference will not occur in a particular installation If this equipment causes harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Changes or modifications of this device must be approved by the party responsible for FCC compliance or the user loses authority to operate this product LASER WARNING Visible and invisible laser radiation Do not open optical housing Avoid direct exposure to the beam 16x DVD Quickstart Guide Hardware System Requirements Minimum Intel Pentium 11 800 MHz 256 MB memory Used for
3. EACH OF CONTRACT NEGLIGENCE STRICT LIABILITY OR ANY OTHER LEGAL THEORY RELATED TO THIS PRODUCT SUCH DAMAGES INCLUDE BUT ARE NOT LIMITED TO LOSS OF DATA LOSS OF BUSINESS LOSS OF PROFITS LOSS OF USE OF THE PRODUCT OR ANY ASSOCIATED PERIPHERALS COST OF REPLACEMENT PRODUCT DOWN TIME OR CHARGES FOR PURCHASER S TIME AND EFFORT Some states do not allow the exclusion or limitation of incidental or consequential damages or allow limitations on how long an implied warranty lasts so the above limitations or exclusions may not apply to you This limited warranty gives you specific legal rights and you may also have other rights that may vary from state to state Obtaining Warranty Service Please call the NEC telephone technical support line listed below Original purchase receipt must be retained and presented to obtain warranty service Request a RMA number and write the RMA number on the outside of the package in a prominent location Return the Product freight prepaid in its original packaging or in other comparable packaging to avoid shipping damage Be sure to remove all parts or options not under warranty or any discs prior to returning the Product NECSAM is not responsible for any damage or loss to these items NEC Technical Support For telephone technical support please call 801 401 1466 Telephone technical support hours are Monday Friday 5 00 a m 5 00 p m Pacific Time Warranty Registration Register your Product o
4. c Types NEC Supports DVD ROM 25 stot acters Read DVD Video Read DVD R SL DL eee Read Write DVDRW daily 5 Read Write DVDER Read Write DVDRW te acer ce Read Write DVD RAM 0 ccc cece een Not Supported SL Single Layer DL Double Layer 16x DVD Quickstart 16x DVD Quickstart Guide Product Specifications Read Speed 16x max DVD ROM and 48x max CD ROM Write Speed DVD R 16x max DVD RW 8x max DVD R DL 4x max DVD R 16x max DVD RW 6x max CD R 48x max CD RW 24x max Access Time 120 ms CD 140 ms DVD Mechanism Motorized tray load mechanism for horizontal and vertical use Audio Digital out and line out at the back MPC compatible Interface IDE ATAPI Burst Transfer Rate PIO mode 4 Ultra DMA 33 Cache 2 MB Compatibility MPC level 3 Multi Read PC2001 Media Modes Supported DVD ROM DVD R DVD RW DVD R DVD R DL DVD RW DVD Video CD ROM CD ROM XA CD Audio CD Extra CD Text CD I Ready CD Bridge Photo CD VideoCD Hybrid CD Writing Methods DAO disc at once SAO session at once TAO track at once with zero gap variable or fixed packet multisession Dust Protected Enclosure Forced Eject Hole 16x DVD Quickstart Guide Disc Care To clean the disc use a soft cloth and wipe from the inside to the outside edge rather tha
5. face cable connector Drive is very loud when reading writing Make sure the drive is securely mounted to the computer s chassis Excessive vibration can be caused by loose or uneven mounting Still having problems m Visit NEC customer support at http support necsam com or call 801 401 1466 for assistance Monday Friday 5 00 a m 5 00 p m Pacific Time Quickstart Guide Warranty Information ONE 1 YEAR LIMITED WARRANTY NEC Solutions America Inc NECSAM warrants this hardware product Product against defects in material and workmanship for a period of one year from the date of original purchase as established by the date of purchase on your sales receipt from an authorized NECSAM dealer retailer or distributor This warranty only covers the hardware packaged with this Product This warranty does not cover any software contained in or included with the Product Any such software is provided AS 15 For your rights with respect to software please refer to any software documentation included This limited warranty is valid only for Product purchased within the United States of America This warranty applies only to the original purchaser of the Product and is non transferable This limited warranty excludes service due to 1 any external cause including acts of God theft fire power failures and other electrical and or environmental problems 2 accident misuse abuse neglect unauthori
6. n in a circular motion Do not use record cleaning or anti static agents as the solutions may damage a disc Always store discs in proper storage cases when not in use Check for dirt dust or fingerprints on a disc s recording side before inserting into the unit Avoid touching or scratching the recording side of the disc m Hold the disc only by the edges or by the center hole and one edge Do not affix stickers labels or tape to the disc Discard warped or cracked discs as they may cause damage to the drive Avoid unusually shaped discs such as business card CDs 16x DVD Quickstart Guide g 16x DVD Quickstart Guide Troubleshooting amp Technical Support Nothing happens when eject button is pressed m Make sure the power cable is securely connected to the drive Verify the computer is powered up and running Drive has power responds to eject button but is not recognized by computer Verify the interface cable is attached correctly Verify the drive s jumper settings If your system uses CABLE SELECT verify the jumper settings are set to CSEL If your system is MASTER SLAVE verify that there is no other device connected to the same cable using the same setting Computer shuts down immediately after power up when drive is installed Verify the drive s jumper settings f drive is the only device connected to the interface cable connect it to the alternate inter
7. nline today to help ensure seamless warranty coverage for your new equipment Failure to complete registration does not diminish your limited warranty rights http www necsam com registration 2005 NEC Solutions America Inc All rights reserved ey 0 16x DVD Quickstart 16x DVD Quickstart Guide NEC Solutions America Inc Solutions Platform Group 2890 Scott Boulevard Santa Clara CA 95050 Information in this publication is subject to change without notice NEC is a registered trademark of NEC Corporation and or one or more of its subsidiaries All are used under license All other trademarks and registered trademarks are the property of their respective owners 2005 NEC Solutions America Inc All rights reserved _____ wm p R RW DVD ReWritable DL ReWritable 5 NEC NEC Solutions America NEC Solutions America Inc 2890 Scott Boulevard Santa Clara CA 95050 http www necsam com
8. of the six pins as seen below Fig 4 You may need small needle nose pliers to gently slide the jumper off If you are installing the DVD drive as an additional drive you will need to set the jumper settings according to your system requirements see next jumper a 16x DVD Quickstart Guide Jumper Setting Tutorial There are three possible jumper settings MASTER SLAVE Cable Selec and CABLE SELECT CSEL When two drives are connected to the same interface cable one must be set to MASTER e one set to SLAVE Alternatively both drives may be set to CABLE SELECT in which case the system defines which MASTER drive is MASTER and which drive is SLAVE If only one drive is present set the jumper to MASTER The NEC drive ships with a default setting of MASTER __ If you are installing the DVD drive as a second drive look at SENE the jumper settings on the second drive already in your si system If the settings on that drive are set to MASTER or ki SLAVE set the jumper to the opposite setting If the existing drive is set to CABLE SELECT CSEL set the jumper on the NEC DVD drive to CSEL also Slide the NEC DVD drive into the empty drive bay from the front of the computer Fig 5 Mount the drive to your computer s chassis using the existing mounting hardware or the p
9. rovided screws refer to your computer s documentation 9 Connect the interface cable making sure the red stripe matches Pin 1 on the drive If your drive is set to MASTER connect it to the endmost connector on the cable Fig 6 Connect your computer s analog audio cable from the drive s audio connector to your sound card not applicable for Windows XP users or those using digital audio playback Fig 7 ein Connect the power cable Fig 7 i lt Replace the computer s cover and re connect all cables Fig 6 that were previously unplugged Power up the computer Fig 7 0900 4 Power Cable gt 16x DVD Quickstart 16x DVD Quickstart Guide Using Your Drive Disc Tray Busy Forced Eject Eject Button Indicator LED Hole Busy Indicator LED Lights up when reading or writing data Eject Button Press to load or unload a disc Disc Tray Open or close by pressing the eject button Load discs into the tray with the label side facing up Forced Eject Hole If the eject button will not open the tray insert a stiff rod such as a large paper clip into the hole and push in to eject the tray after the drive has been turned off and the disc has stopped spinning 16x DVD Quickstart Guide About DVD Media Types Media compatibility Dis
10. such things as data backup Recommended Intel Pentium 4 1 0 GHz 512 MB memory Highly recommended for all DVD recording 16x DVD Quickstart Guide ag 16x DVD Quickstart Guide Drive Installation Shut down your computer and disconnect all cables plugged into the computer Fig 1 Remove the computer s case refer to your computer s documentation Once the cover is removed touch a non painted metal surface i e the power supply to ground yourself This is an important step You can damage the components inside the computer if you do not ground yourself If you are replacing an existing drive Unplug the cables from the rear of the drive Fig 2 Remove the mounting hardware holding the drive in place refer to your computer s documentation SE eee foal Slide the drive out through the front of the computer Fig 3 mn Fig 2 If you are NOT replacing an existing drive i e adding an additional drive Remove the front cover plate from the empty drive bay where you are installing the drive refer to your computer s documentation Check the jumper settings on the NEC DVD drive If you are replacing an existing drive set the jumper to the same setting as the drive you are replacing The jumper is the black plastic piece on the back of your drive bridging two
11. zed modifications improper installation or service not authorized by NECSAM 3 cosmetic damages 4 usage not in accordance with Product documentation and instructions or 5 problems caused by use of software parts and components not supplied by NECSAM This warranty does not cover damage or loss to any software programs data or removable discs This warranty is invalid if the serial number has been defaced modified or removed If a defect arises and a valid claim is received by NECSAM during the limited warranty period at its option NECSAM will repair the Product using new or refurbished parts or replace the Product with a new or refurbished Product Repair or replacement is your sole and exclusive remedy All parts or Products exchanged under this warranty become the property of NECSAM The replacement part or Product is warranted for the remainder of the original limited warranty period or thirty 30 days from shipment whichever is longer NECSAM MAKES NO OTHER EXPRESS WARRANTY WITH RESPECT TO THIS PRODUCT ANY IMPLIED WARRANTIES INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE AND NO WARRANTIES WHETHER EXPRESS OR IMPLIED WILL APPLY AFTER SUCH PERIOD NECSAM IS NOT RESPONSIBLE FOR ANY INCIDENTAL INDIRECT SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY BR
Download Pdf Manuals
Related Search