Symantec Clientless VPN Gateway 5.0 (10220550) for PC, Mac, Linux
Contents
1. 9 symantec Symantec Clientless VPN Gateway 4400 Series Installing and setting up the Symantec Clientless VPN Gateway 4400 Series appliance The following instructions describe installing and setting up the appliance and one interface for management Before you begin the appliance installation and setup you need to know its inside static IP and netmask addresses For instructions on how to configure the second interface see the Symantec Clientless VPN Gateway 4400 Series Installation Guide To set up Symantec Clientless VPN Gateway 4400 Series appliance 1 Mount the appliance in the appropriate rack or place it on a stable level surface Refer to these back panel graphics for the location of various features in the instructions that follow A Model 4460 Part Number 10209303 1 2 10 11 Plug the power cord into the power socket 1 and then plug it into a power supply An uninterruptible power supply UPS is recommended Do not use an extension cord Plug the Ethernet cable from the LAN segment through which you will connect to the appliance in to intO 2 For initial setup this must be a directly connected LAN Use the master power switch 3 to turn on the power Wait a few moments for the power to turn on and the boot process to finish The LCD will step through various messages as it boots up Note To turn off the appliance press the down arrow on the front panel until you see Symantec CVG2. 5 0 Shutdown on the LCD Press the e button to confirm shutdown When you see the System Halted on the LCD turn off the appliance using the power switch When the system messages display on the LCD press any arrow button to display the 1 Network system menu option Press e to start the network setup Under Select Interface use the left or right arrow button to select Interface 0 Under Interface 0 IP Address enter the inside IP address Each octet of the IP address is a separate field in the display Use the left and right buttons to move between the fields of the IP address The selected field is surrounded by brackets Use the up and down buttons to change the number in the field that is selected Once the desired IP address displays on the LCD press e Under Netmask enter the netmask address for the IP address you just entered Use the same method to enter this value as the previous address Under Default Gateway enter the gateway address that the inside interface should use Use the same method to enter this value as the previous address 12 13 14 15 Press e Under Save Setup use the left or right buttons to select one of the following Yes The configuration will be saved and the new password will display when you press e This is the administrator password A new password is generated each time you save this setup from the front panel Use this password to log in to the Securi
3. ty Gateway Management Interface SGMI or the Command line Interface CLI You can also change the passwords in the SGMI or CLI if you are logged in as the administrator No The configuration is not saved the system restarts and all your information is lost The default selection is No If you select No you will exit Network setup when you press e Press e The password displays Record it and store in a secure location Passwords are case sensitive Press e The following message displays on the LCD Network is now configured The LCD screen displays the system menu After a period of inactivity the LCD screen then displays the time percent CPU usage percent memory percent log disk and interface throughput rate Note Do not configure the second interface using this procedure You can now configure the appliance and the second interface using the Security Gateway Management Interface SGMI or the Command line Interface CLI from the inside interface See the Symantec Clientless VPN Gateway 4400 Series Administrator s Guide for more information
Download Pdf Manuals
Related Search