Swann SW248-LM8 Computer Monitor User Manual
Contents
1. Swann MONITORING 8 LCD Monitor Instruction Manual SW248 LM8 FCC WARNING STATEMENT NOTE This equipment has been tested and found to comply with the limits for Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Important Notice All jurisdictions have specific laws and regulations regarding the use of monitoring amp recording devices Before using any camera for any purpose it is the buyer s responsibility to be aware of all applicable laws and regulations that prohibit or limit the use of cameras and to comply with the applicable laws and regulations The legality of watching people other than you changes from country to country and even state to state C2. 1 Before Vou Begin E Storage 1 Keep this product awav from extreme hot or cold places The storage temperature ranges from 20 C to 60 and the operating temperature is from Ot to 40 Do not use this product in or near moist environments such as bathtubs wash basins kitchens basements swimming pools etc Do not expose the LCD display to high humidity dust oil or smoke Do not throw or drop this product Do not subject this device to strong vibrations shock Do not brush or scrub this product with abrasive objects NO O C1 A OW B Maintenance 1 Disconnect all cables from the monitor before cleaning 2 Wipe the enclosure screen and kevs using a drv soft cloth or moisten cloth with diluted dish detergent only 3 Do not use polishing cloth abstergent or other types of chemical detergents with alcohol or benzene A Warning 1 Do not use this device while driving 2 Do not submerge this product in liquids or expose to rain Special Notice Do not attempt to repair or disassemble there are no user serviceable parts inside this device Contact Swann Technical support if this monitor malfunctions or fails to operate correctly 2 Package Contents LCD Monitor Car Power Adapter Power Adapter Remote Control AAA Batteries for Remote Control A V Cable Monitor Stand Instruction Manual If any of the above accessories are damaged or missing contact Swann Communications for assist
3. Year Month Day format Use A V to change year and 4 gt to change day AV Press to switch between AV1 and AV2 Press to flip image horizontally Press to flip image vertically 6 Monitor Connections 6 1 Connecting the Power Adapter Connect the Power Adapter plug to the input on the side of the monitor marked DC 12V Plug the other end of the adapter to a power point or cigarette lighter if applicable 6 2 Connecting the AV Cable T AV conversion cable Insert the mini jack end of the AV Cable into the AV1 or AV2 port on the Monitor Connect the Yellow RCA cable to the video source of the AV device Connect the Red and White RCA cables to the Right and Left audio source if applicable 7 Menu Operation Press MENU to displav following options PICTURE OPTION CLOCK SYSTEM PRESET 7 1 PICTURE CONTRAST BRIGHT COLOR SHARP TINT Press A or V to select the item and press lt or gt to adjust the value Te The TINT option will appear on NTSC Monitors only 7 2 OPTION LANGUAGE CALENDAR GAME LANGUAGE CALENDAR and GAME displays on the screen as below description 7 2 1 LANGUAGE Press A or V to select Language and press lt or gt to change on screen languages 7 2 2 CALENDAR Press A or V to highlight Calendar and press lt or gt to adjust Press A or V to change year and press lt or gt to change month 7 2 3 GAME Push to enter Game Mode 7 3 CLOCK TIME Set the current
4. free 0800 479 266 International 461 3 8412 4610 See http www worldtimeserver com for information on different time zones and the time in Melbourne Australia compare to your local time Q Swann Swann Communications 20080 SR247 LM8 10006 170309
5. time ON TIME Set time to turn monitor on OFF TIME Set time to turn monitor off ATTENTION Set an alarm time reminder to appear at a specified time lt i gt If you wish to use the Timer features TIME must be set first Times appear in 24 hour clock format 7 4 SYSTEM COLOR SYS Choose the color format from AUTO PAL SECAM NTSC BLUE BACK Change the background to blue if no signal is detected HORIZONTAL Flip the image horizontally VERTICAL Flip the image vertically 8 Troubleshooting Guide If vour monitor appears to be malfunctioning or is not responding correctiv consult the Troubleshooting Guide below for possible solutions before contacting Technical Support for repair Problem Possible Causes No picture no sound Check power connection from power adapter or car adapter Ensure the provided power adapter is used and Monitor is not in Standbv mode No image from source No sound Dark picture Lines through image Gheck monitor is set to correct AV Channel Confirm yellow AV cable is connected from video output on the device to the yellow video input on the monitor Press the VOL button to check levels Ensure headphone jack is not plugged into monitor Check RCA cables are connected to Red White Audio inputs on the monitor AV Cable Check monitor brightness and contrast levels in Picture menu Monitor is operating in cold environment Keep awav from mic
6. ance C Ln uJ m3 Monitor Layout LCD Screen AV1 AV2 Button AUTO Button PICT Button MENU Button POWER Button UP Button DOWN Button VOL Right Button 10 VOL Left Button 11 IR Remote Sensor 12 Monitor Stand o cO OnN Oo BR WN 13 Bracket 14 AV2 in jack 15 AV1 in jack 16 Headphone jack 17 DC Input 18 Speaker Monitor Controls e AV1 AV2 Switches input from AV1 to AV2 e AUTO Press to cycle between AV1 and AV2 inputs at 4 6 or 8 seconds push again to turn off e PICT Choose from 5 image settings Standard Soft Vivid Light and Personal e MENU Press to enter or exit the menu e POWER Press to turn monitor on off e A Move selection up in Menu e V Move selection down in Menu e VOL Increase Monitor volume or move right in menu e VOL Decrease the Monitor volume or move left in the menu 5 Remote Control Lavout POWER Turn the monitor on off MUTE Press to disable sound press MUTE again or press VOL to enable sound A Move selection up V Move selection down 4 VOL Decrease volume move left gt VOL Increase volume move right MENU Press to enter exit the Menu MODE Change image settings from Standard Soft Vivid Light and Personal CALL Displays current AV channel TIMER Push to set Sleep Timer up 120 minutes LANG Sets the menu language default English CALE Press to set Calendar date T in
7. ontact your local government s privacy information body or your local Police for more information on what if any restrictions you may face WARNING Important notice about correct usage of the power adapter The correct orientation for the enclosed power adapter is in a vertical or floor mount position Precautions and Safety Instructions e Read this manual carefully before using the Monitor e Follow the instructions for proper and safe use of this product e Keep the instructions in a safe place for future reference e Use only the power adapter that is designed and supplied with this product Do not use this device near water or other liquids e Do not use solvents or alcohols to clean the unit use a dry soft cloth or moisten cloth with diluted dish detergent only e Ensure the vents on the sides and back of the unit are not covered e Do not use near heat sources such as heaters stoves fireplaces e Ifthe product has been damaged do not attempt to repair it yourself contact Swann Technical Support for assistance Table of Contents mk Before You Begin Package Contents Monitor Layout Monitor Controls Remote Control Layout 5 p oO JA S Tq Monitor Connections eeu 6 6 1 Connecting the Power Adapter 6 2 Connecting the AV Cable 7 Menu Operations 7 7 1 Picture Menu 7 2 Option Menu 7 3 Clock Menu 7 4 System Menu 8 Troubleshooting Guide 9 9 Warrantv Swann Technical Support Technical Specifications
8. rowaves high voltage lines wireless devices that mav cause interference if possible B amp W or rolling image Upside down or laterallv inverted picture Ensure the Monitor is set to the correct region in the System gt Color Sys menu NTSC for N America PAL for Europe Australia Adjust the Horizontal and Vertical settings on the remote control or in System menu 9 Technical Specifications Product Code Displav Tvpe Video Format Video Inputs Displav Resolution Displav Size Aspect Ratio Audio Inputs Speakers Audio Output Connections Operating Power Monitor Dimensions Weight SW248 LM8 Color TFT LCD NTSC PAL SECAM AV inputs x 2 800 x 600 8 Diagonal 4 3 L R AV inputs x 2 4cm loudspeakers x 2 gt 0 3W x 2CH 3 5mm headphone jack 2 x AV inputs external power supply DC 12V 255mm x 185mm x 35mm 10 0 x 7 3 x 1 4 650g 1 4lbs 10 Swann Communications Limited Warrantv Terms and Conditions Swann warrants this product against defects in workmanship and material for a period of one 1 vear from its original purchase date Vou must present vour receipt as proof of date of purchase for warrantv validation Anv unit which proves defective during the stated period will be repaired without charge for parts or labour or replaced at the sole discretion of Swann The end user is responsible for all freight charges incurred to send the product to Swann s repair cen
9. ters The end user is responsible for all shipping costs incurred when shipping from and to any country other than the country of origin The warranty does not cover any incidental accidental or consequential damages arising from the use of or the inability to use this product Any costs associated with the fitting or removal of this product by a tradesman or other person or any other costs associated with its use are the responsibility of the end user This warranty applies to the original purchaser of the product only and is not transferable to any third party Unauthorized end user or third party modifications to any component or evidence of misuse or abuse of the device will render all warranties void A Warning No user serviceable components exist in this device Do not attempt to dismantle or modify the monitor for risk of damage or electrical shock Maintenance and internal repairs of this device are to be carried out by qualified professionals only 11 Swann Technical Support Worldwide email support tech swannsecurity com UNITED STATES toll free 1 800 627 2799 Su 2pm 10pm US PT M Th 6am 10pm US PT F 6am 2pm US PT USA Exchange amp Repairs 562 777 2551 M F 9am 5pm US PT UK 020 3027 0979 M F 9am 5pm GMT IRELAND 015 245 007 M F 9am 5pm GMT AUSTRALIA toll free 1300 138 324 M 9am 5pm AUS ET Tu F 1am 5pm AUS ET Sa 1am 9am AUS ET New Zealand toll free 0800 479 266 NEW ZEALAND toll
Download Pdf Manuals
Related Search