User Manual - DAZA Opticare
Contents
1. with the European Directive on Waste Electrical and Electronic Equipment WEEE and compliant with local laws relating to this directive Page 2 of 22. 9021 9021 CE R Optiseat 2014 06 12 V2 5 User Manual General This wireless Optiseat alarms when a person is standing up from a chair If the person is standing up longer than a preset time the Optiseat will alarm This Optiseat works in combination with the Daza receiver and the Daza pagers Operating the Optiseat There is a LED on the control box figure 1 that indicates whether the cushion is on or off green or red and a push button to turn the cushion on off Daza Check whether the system is on or off e e Press the push button briefly figure 1 2 7 e The lamp indicates whether the system is on or off Red is off green is on LED Switching on and off e Hold the push button for 3 seconds e The LED changes colour and the system is now on or off e This is also indicated by an acoustic signal 2 short beeps for on 1 beep for PUSH BUTTON off e When someone sits down on the cushion the LED on the control box will show the status of the system Figure 1 Push button LED Reminder function e When the system is switched off and a client is helped out of the chair the next time the chair is used the cushion is automatically switched on after 10 seconds By default the Optiseat works as follows e Switch the system on e When the client gets out of the chair a beep sounds for 4 seconds adjustable to activate the client s self correcting ability e If the client does not sit down
3. again within 4 seconds a call signal will be sent to the receiver or the pager If the client does sit down within 4 seconds the beep signal stops and nothing else happens Battery empty notification When the LED flashes red green every 5 seconds the batteries AA 1 5V are almost empty need to be replaced If the system is on a short beep will also be sounded once every minute If you wait too long before replacing the batteries a discharged battery notification will appear on the receiver Changes to the default settings The technical customer service representative can change the default time settings and the length of the delay before transmission See page 2 of this manual Daza Opticare BV follows a policy of continuous improvement in the development of its products The technical data can therefore be changed without notice This product is classified as an electrical and electronic device When you decide to discard this product please ensure that this is done accordance with the European Directive on Waste Electrical and Electronic Equipment WEEE and compliant with local laws relating to this directive 9021 9021 Ce Optiseat 2014 06 12 V2 5 User Manual Opening the unit To open the unit you must remove four screws The two lower screws are located in the battery compartment Alarm delay S1 and S2 The Optiseat has an alarm delay This is the time that the person has to sit again before the alarm will sound F
4. our time settings are available These times can be changed upon request The standard delay times you can choose from are 1 4 10 and 255 seconds other lengths of time are optional The selection from among these 4 lengths of time is made using the first 2 switches S1 and S2 figure 2 S1 2 S3 S4 S1 S2 3 S4 51 52 3 S4 S1 52 3 S4 u i m M omi T 1sec T 4sec T 15se T 10min Figure 2 Alarm delay time Buzzer switch S3 and S4 With the third switch S3 the buzzer can be set If this is up ON the buzzer is audible until the end of the alarm delay time set with S1 and S2 If S3 is down OFF the buzzer will only sound for one second regardless of the alarm delay time With the fourth switch S4 the buzzer can be switched on or off When it is switched on the buzzer is audible as set by S3 When it is switched off the buzzer is completely switched off during alarm Figure 3 51 S52 53 H Figure 3 Buzzer On Off When closing the unit make sure the LED is positioned in the corresponding opening Attention After changing the settings the Optiseat have to be switched off and on again to activate the new settings Daza Opticare BV follows a policy of continuous improvement in the development of its products The technical data can therefore be changed without notice This product is classified as an electrical and electronic device When you decide to discard this product please ensure that this is done accordance
Download Pdf Manuals
Related Search