USER MANUAL
Contents
1. to adjust the temperature A Power Saving Sleeping Standard modes the default setting is 38 C which is the highest temperature you can set up to B Frosting mode the constant temperature is 7 C the temperature cannot be adjusted When the room temperature is lt 5 C heater will run automatic to increase up to 7 G When the room temperature 2 7 C it will stop automatically All mode settings will be automatically set after five seconds In Power Saving Sleeping and Standards modes when the ambient temperature is lt 1 C of set temperature heater will increase the heat when the ambient temperature 2 C of set temperature heater will stop 4 Timer Press Timer button to enter the pre set Timer On setting mode the time digit flashes The setting time can be from 00 01 1 minute to 23 59 23 Hours and 59 minutes Press button for setting the Hour increase 1 23 Hours and press button for setting the Minute increase 1 59 Minutes After five seconds the counting will be started automatically After set Timer On mode heater will not operate until the set time started Timer setting ON Timer On is set at 01 30 the heater will start operation after 1 hour and 30 minutes Timer setting OFF Timer Off is set at 01 30 the heater starts and stop operation after 1 hour and 30 minutes In the process of pre set Timer On or Off setting mode you can press button to change the2. heating mode vl a XX e m C A Power saving mode ydy IS am C M on Wt wu B Sleeping mode Jit a C Standard mode Ji D Frosting mode time out working is completed after the screen display End and the heater will stop We can always cancel the timer setting by pressing button on control panel or remote controller Overheating Protection Heater is equipped with a safety system It will shut down when overheat or when air vent is blocked Please allow the device to cool and ensure vent is clear before turning on again Automatic power off The heater will stop when the device falls over 1 Unplug the device when it requires repair or during maintenance Do not handle the device when it is still hot Gently wipe the dirt on the housing with a soft damp cloth Please do not attempt to repair the device yourself Always send it back to the retailers Possible remedial actions before contacting the retailers for repair Problem Actions O Heater will Check that the device is properly plugged in not turn on 2 Check the power source is 230 240V AC Make sure the device is on a flat and horizontal surface Check if the set temperature is higher than room temperature Remote Remote control with low battery level control Out of range without Obstructions affecting the reception reaction Specifications se o DISPOSAL The packaging materia
3. USER MANUAL 360 Turbo Fan Heater Cat No 25963 ea 2 Please read this manual before using 1 This heater is for general indoor home heating only 2 Place heater in a well ventilated area away from flammable materials and air cans 3 Place the heater on a steady and even floor Do not hang or install on wall 4 Please use individual socket if the output rated current is more than 10A Do not use the same socket with other equipment to avoid overloading Make sure plug is properly inserted into the socket 5 Supervise usage when in use with children and elderly 6 Unauthorized disassembly modification repair are prohibited 7 Do not operate or touch the plug with wet hands 8 Use 230 240V AC power 9 Ensure filters are clear and properly cleaned 10 Do not move the heater when operating 11 Do not cover the heater or the air vents 12 Be careful the device will be very hot when in operation 13 Please unplug the device when not in use 14 Do not use any aerosols near the device when in operation 15 If there is a burning smell stop using and unplug the power cord Contact your retailer 16 Do not use in the batch room or near water 17 Do not allow children to play with this heater LCD Display Control Panel Remote Controller On Off button Hand grip Metal gauze Mica heating element Power cord CON DU BP NN FR 1 Remove the packaging
4. and place on a flat and dry area 2 Plug the heater s power cord by using the specified connect 230 240V 50Hz power output 3 Turn on the heater by pressing the On Off button item 4 above 4 Insert the button battery correctly into the Remote Control Timer setting Temperature amp Timer control up Temperature amp Timer control Down Mode Mode setting 1 Power on OFF A a Plug in the power supply press the ON button The LCD wy amp care 70 nane Aer screen displays all the icons in two seconds JO at Then entering into the standby mode the heater will show the ambient temperature 0 50 degrees and a time digit 00 00 on the screen 00 00 will keep flashing The Mica heater is ready for operation 2 Operation mode setting Press button on control panel or remote controller to enter the Power Saving mode the display gives a default temperature 38 C flashing 2 3 seconds then it will significantly show the ambient temperature Press MODE button to select the modes there are four operating modes A Power Saving mode B Sleeping mode C Standard mode D Frosting mode the mode selection will be displayed for a duration of 5 seconds after pressing the MODE button 3 Temperature Press MODE button once to enter the temperature setting The temperature digit flashes press Temperature increase setting and Temperature decrease setting
5. l is reusable Dispose of the packaging in an environmentally friendly way by putting it in the appropriate recyclable waste collection containers Dispose of the product and the batteries in view of the environment if you want to separate The device and the batteries must not be thrown in with domestic waste Take them to a recycling center for used electrical and electronic devices For more information you can consult your local government Remove batteries first a Eurotops Versand GmbH Elisabeth Selbert StraBe 3 40764 Langenfeld Germany 10 If technical support is needed please call in Germany 0180 530 63 63 or info eurotops de in Austria 01 230 60 43 12 or info eurotops at in Switzerland 044 28 36 125 or info eurotops ch in the Netherlands 026 37 36 333 or info eurotops nl in France 0892 700 470 or info eurotops fr 14 Cents minute via German landline max 42 cents minute via mobile phone network 34 Cents minute via French landline A possible return of products should be addressed to the return address stated on your invoice The manual only reflects the technical conditions available under printing Any changes in technology and equipment are reserved 26 04 2013
Download Pdf Manuals
Related Search