BL-5201MV Master Valve biCoder Installation
Contents
1. BL 5201MV Master Valve biCoder Installation Guide Installation Instructions 1 Power off the two wire when installing devices Leave 24 to 36 inches of slack on the two wire to allow for easy installation and maintenance Place the biCoder in the valve box for convenience and protection Valves can be located a maximum of 250ft from the biCoder location by using additional 14 gauge wires Connect the orange wire to the pilot wire from the master valve and the white wire to the common wire from the master valve Note The common wires cannot be shared between different biCoders Connect the red and black wire from the biCoder to the corresponding red and black wires on the two wire using DBR Y or equivalent connectors It is critical that polarity be maintained Using the controller test the connections and assign the Master Valve biCoder address as instructed in the controller s user manual For normally open master valves configure the master valve as normally open in the controller as instructed in the controller s user manual CN BASE LINE bn IRRIGATION SOLUTIONS 1 866 294 5847 Rev 1 3 2013 www baselinesystems com Master Valve Orange wire connects to the pilot wire BL 5201MV White wire connects to the common wire WARNING The biCoder wires must not have electrical contact with soil or water All connections must use DBR Y or equivalent moisture resistant connectors Install all connections correctly Damage t2. o the system will occur if these specifications are not followed
Download Pdf Manuals
Related Search