Owner/User Manual
Contents
1. a rubber weather insulator or silicone caulking not included An F connector wall plate can be used inside the home to cover the inside portion of the hole You can typically find an F connector wall plate at any local electronics or hardware store 10 12 Month Limited Warranty VOXX Accessories Corporation the Company warrants to the original retail purchaser of this product that should this product or any part thereof under normal use and conditions be proven defective in material or workmanship within 12 months from the date of original purchase such defect s will be repaired or replaced at the Company s option without charge for parts and repair labor To obtain repair or replacement within the terms of this Warranty the product along with any accessories included in the original packaging is to be delivered with proof of warranty coverage e g dated bill of sale specification of defect s transportation prepaid to the Company at the address shown below Do not return this product to the Retailer This Warranty is not transferable and does not cover product purchased serviced or used outside the United States or Canada The warranty does not extend to the elimination of externally generated static or noise This Warranty does not apply to costs incurred for installation removal or reinstallation of the product or if in the Company s opinion the product has been damaged through acts of nature alterati2. any metal surface including aluminum siding Mounting on a metal surface will seriously degrade reception quality In most cases the antenna provides the best performance when mounted outdoors in a high location such as on the roof or high up on the side of your house The antenna can also be mounted in an attic or indoors Mounting to a Surface 1 Mount the base to the surface Find the four wood screws included in this package Using these screws attach the base to the surface as shown here If you re mounting to concrete brick or drywall You ll need to use the anchors included in this package Here s how to install them Place the antenna base against the concrete where you want to mount the antenna Make sure it s level Mark the surface through the holes in the base where you re going to mount the antenna Set the base aside and drill a 0 1575 pilot hole at each marked location Remove any excess dust from the holes Insert a concrete anchor into each hole so that it is flush with the concrete surface You can use a hammer to gently tap the anchors into place if necessary Place the antenna base back against the concrete surface and secure it using the four wood screws provided Do not overtighten these screws continues on next page MERINE 2 Attach the arm to the base Find one of the bolts included in this package First set the bolt in the base s mounting well Then position the arm
3. over the other side of the well Tighten the bolt to attach the arm to the base 3 Attach the antenna to the arm Find the other bolt included in this package First set the bolt in the antenna s mounting well Then position the arm over the other side of the well Tighten the bolt to attach the arm to the antenna Connect the coaxial cable to the antenna Connect the coaxial cable to the F connector on the bottom of the antenna Cover the connector with the cable s attached weather boot To adjust the antenna s position 1 Loosen the bolt on either end of the arm 2 Move the arm or antenna to the desired position 3 Re tighten the bolt so that the antenna and arm stay firmly in position Mounting to a Mast 1 If you re using the provided coaxial cable thread it through one of the U bolts Find the coaxial cable and one of the U bolts included in this package Thread the coaxial cable through the U bolt as shown here IMPORTANT If you re not using the coaxial cable that came with this antenna skip step 1 continues on next page HSIONA 2 Attach the clamp assemblies to the base Find the other U bolt the four washer nuts the two clamps and the antenna base included in this package Insert each U bolt into the base as shown here Then position a clamp and two washer nuts on the end of each U bolt as shown here Important These diagrams show the
4. the well Tighten the bolt to attach the arm to the antenna as shown here continues on next page HSIONA The antenna can be mounted either vertically or horizontally To mount it horizontally simply rotate the arm clockwise 90 Try different positions for best performance Important These diagrams show the cable that came with this antenna This cable was designed to fit under the U bolt If you are using a different cable DO NOT pass it under the U bolt as shown here Instead leave it outside the U bolt and tape it to the mast To adjust the antenna s position 1 Loosen the bolt on either end of the arm 2 Move the arm or antenna to the desired position 3 Re tighten the bolt so that the antenna and arm stay firmly in position 6 Connect the coaxial cable to the antenna Connect the coaxial cable to the F connector of the antenna as shown here Then cover the connector with the attached weather boot Note If you re using your own coaxial cable i e not the one provided with this antenna make sure to affix it to the outside of the mounting base Connecting to YourTV 1 Run the coaxial cable from the antenna towards your television set Connect the coaxial cable to the ANT jack on the supplied amplifier insert 2 Connect built in coaxial cable on the amplifier insert to the antenna input jack on your TV or converter box Note If
5. you want to split the signal coming from the antenna connect the short coaxial cable built into the amplifier insert to your splitter splitter sold separately DO NOT PUT THE SIGNAL SPLITTER BETWEEN THE AMPLIFIER INSERT AND THE ANTENNA After all other connections are made connect the power adapter into the amplifier insert Plug it into a standard AC outlet The amplifier insert should always be located indoors TV iow h 4 Set the switch on the amplifier to high or rer wo low amplification As a rule of thumb you H should set this switch to HI if the antenna is outside or if you re using it with a splitter for multiple TVs and LOW if the antenna is inside However if you notice you re not receiving channels you usually receive try the switch in the other position 12VDC 5 Scan for channels on your TV or converter box HSIONA Water Damage Prevention At the point where your coaxial cable lead enters the house you should allow for some slack in the coaxial cable as a drip loop This will prevent moisture from running down the coaxial cable and entering the house Run the coaxial cable approximately six inches below the wall entry point and then turn it upwards towards this spot Any moisture that accumulates on the coaxial cable will drip off in the bend instead of running into the house You should seal the point where the cable enters your home with
6. ANT702F Digital Amplified Indoor Outdoor Antenna User s Guide FCC Statement This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation This equipment has been tested and found to comply with the limits for a Class B Digital Device pursuant to Part 15 of the FCC Rules These limits are designed to this equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the radio or television off and on the user is encouraged to try to correct interference by one or more of the following measures e Reorient or relocate the receiving antenna e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on another circuit e Consult the dealer or an experienced radio TV technician for help Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this equipment Industry C
7. Genco 6685 Kennedy Road Unit 3 Door 14 Mississauga Ontario L5T 3A5 2013 VOXX Accessories Corporation 3502 Woodview Trace Suite 220 Indianapolis IN 46268 ANT7 02F NA IB 01 11 HSIIONA
8. anada Regulatory Information CAN ICES 3 B NMB 3 B Avis d industrie Canada CAN ICES 3 B NMB 3 B Important This power adapter should be plugged in so that it stays vertical or lays flat BEFORE YOU START Please read the IMPORTANT SAFETY INFORMATION sheet included in this package Getting Started Remove the antenna and the hardware bag from package Make sure the following parts are in the package e Antenna e Amplifier Insert e Power Adapter e Mounting Base e Mounting Arm e Hardware bag 2 U Bolts 2 Clamps 4 Plastic Anchors 4 Wood screws 4 Washer Nuts 1 Coaxial cable 2 Bolts MERINE Finding the Right Location Before you mount the antenna consider the following factors in reception performance e The antenna performs best when mounted vertically e The antenna should be mounted on the side of your house that faces most of your local broadcast towers Visit www antennaweb org to see the locations of your local broadcast towers e The higher the elevation of the antenna the better the reception performance will be Mounting the Antenna The antenna mounting base and arm give you flexibility in mounting the antenna The antenna can be mounted e To a surface such as a rooftop eaves siding or rafters in an attic OR e To a standard mast not included WARNING Never hang anything from the antenna never attach foreign objects to the antenna NOTES Do not install the antenna on
9. cable that came with this antenna This cable was designed to fit under the U bolt If you are using a different cable DO NOT pass it under the U bolt as shown here Instead leave it outside the U bolt and tape it to the mast 3 Mount the base to the mast not included Slide the antenna clamp assembly over the mast positioning the mast between the clamp and the antenna base Position the antenna base as high as possible on the mast Orient the base in the direction you want Then tighten the clamps and washer nuts securely onto the mast Note If you used the provided coaxial cable make sure to mount the base so that the cable exits downward 4 Attach the arm to the base Find one of the bolts included in this package First set the bolt in the base s mounting well Then position the arm over the other side of the well Tighten the bolt to attach the arm to the base as shown here LN J sh A ud gt A NES A CRA YE rs YS Important These diagrams show the cable that came with this antenna This cable was designed to fit under the U bolt If you are using a different cable DO NOT pass it under the U bolt as shown here Instead leave it outside the U bolt and tape it to the mast 5 Attach the antenna to the arm Find the other bolt included in this package First set the bolt in the antenna s mounting well Then position the arm over the other side of
10. on improper installation mishandling misuse neglect or accident This warranty does not cover damage caused by an AC adapter not provided with the product THE EXTENT OFTHE COMPANY S LIABILITY UNDERTHIS WARRANTY IS LIMITED TOTHE REPAIR OR REPLACEMENT PROVIDED ABOVE AND IN NO EVENT SHALL THE COMPANY S LIABILITY EXCEEDTHE PURCHASE PRICE PAID BY PURCHASER FORTHE PRODUCT This Warranty is in lieu of all other express warranties or liabilities ANY IMPLIED WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE SHALL BE LIMITED TO DURATION OFTHIS WARRANTY ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY MUST BE BROUGHT WITHIN A PERIOD OF 24 MONTHS FROMTHE DATE OF ORIGINAL PURCHASE IN NO CASE SHALLTHE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER No person or representative is authorized to assume for the Company any liability other than expressed herein in connection with the sale of this product Some states provinces do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage so the above limitations or exclusions may not apply to you This Warranty gives you specific legal rights and you may also have other rights which vary from state province to state province U S A Audiovox Return Center 150 Marcus Blvd Hauppauge NY 11788 CANADA Audiovox Return Center c o
Download Pdf Manuals
Related Search