Home

manual

1. if needed e Protective template if needed e Compressed air if needed When the correct placement has been found tape the mounting template to the surface perfectly level Outline the cut out area with a pencil Remove the template and drill holes for insertion of saw or knife Saw cut carefully along the line marked in pencil A steel drop wire must be firmly attached between a solid support in the house ceiling beam wall stud etc and the eyehook on the DALI Helicon IW 200 Phantom in order to hold the speaker in case of a fall This is particularly important for ceiling mounting where a falling speaker can be life threatening Connect cable to the terminals being careful to connect the amplitier s red terminal to the loudspeaker s red terminal and the amplifi er s black terminal to the loudspeaker s black terminal Loudspeaker cable must not hang loose from the terminals It must be securely fastened with cable ties or by other means inside the wall If left unsupported cable can gradually come loose creating a poor electrical connection between wire and terminals Turn on the system and listen to the loudspeak ers before final mounting to make sure that all connections are correct Insert the speaker in the wall opening and tighten the 6 screws in the loudspeaker brack ets with the enclosed Allen wrench so that the speaker is firmly mounted in place Be careful to avoid over tightening
2. KVAI LIFICERET MONT R UDSK RING MONTERINGSDYBDE 3 74 The Influence of the Listening Room Every room has it own acoustics that affect the way we hear sound from loud speakers It is a question of how the room receives acoustic energy and releases it again You can improve the acoustics of your listening room in different ways Part of the sound that you hear does not come directly from the loudspeaker Instead it is reflected from the floor ceiling and walls Reflections can be reduced by furniture plants and carpets If the sound is overly bright soft absorbent objects like curtains and carpets can help Both the quantity and quality of deep bass depend on the size and shape of the room and the placement of the loudspeakers in it For instance bass can be boosted by placement near a sidewall and even more by placement in a corner Corner placement provides substantial added reflections As a general guideline avoid large hard reflective surfaces in the immediate vicinity of the loudspeakers Placement in the Listening Room DALI Helicon IW 200 Phantom incorporates Wide Dispersion technology Wide Dispersion means that the area in front of the loudspeakers where a full three dimen sional sonic image is achieved is a great deal wider than with other loudspeakers This ensures substantially better sound across a larger area within your listening room when compared to loudspeakers without Wide Disper
3. Thank you for choosing DALI In Wall loudspeakers DALI is acclaimed around the world for unique loudspeakers designed and built to our uncompromising standards for design and performance DALI s main area of expertise is the development and refinement of known and new techniques in the fields of audio and acoustics The goal for every single DALI loudspeaker is to create a listening experience in your home that will make you forget time and place It is essential that your DALI In Wall loudspeakers are correctly installed and connected This owner s manual contains our guidelines for installation con nection and maintenance NOTE The sections on installing and painting the loudspeaker is for the use of professional installers If you have any questions please feel free to con tact your authorised DALI dealer Enjoy Safety Guidelines About In Wall Loudspeakers e Always follow all safety guidelines DALI Helicon IW 200 Phantom provides the e DALI Helicon IW 200 Phantom is intended for home use only It is not unique acclaimed sound of a true DALI Heli intended for use in professional environments such as alarmsystems con loudspeaker for easy and discreet integra public address etc tion into your home e The speaker must only be used indoors and never in wet areas or at extreme hot or cold temperatures DALI Helicon IW 200 Phantom is equally e DALI Helicon IW 200 Phantom must not be exposed to direct sunlight suited fo
4. er Watt 30 150 50 400 50 300 50 200 Amplifier High frequency drivers 1 x 25 mm soft dome 1x 25 mm soft dome 1 x 25 mm soft dome 1 x 25 mm soft dome 1x 10 x 55 mm ribbon 1x 10x 55 mm ribbon 1x 10 x 55 mm ribbon 1x 10 x 55 mm ribbon Midrange drivers 1x 6 Low frequency drivers xo 2 x 8 2 x 642 1x 612 Connection inputs Single wire Bi wire Bi wire Bi wire Controls Dimensions HxBxD cm 47 7 x 28 5 x 11 0 112 6 x 25 5 x 49 3 102 6 x 21 9 x 45 7 43 5 x 20 8 x 35 6 Dimensions HxBxD inches 18 78 x 11 22 x 4 33 44 33 x 10 04 x 19 41 40 39 x 8 62 x 17 99 17 13 x 8 19 x 14 02 Weight kg Ib 7115 41 90 32 70 40 22 Finish White laquer High gloss High gloss High gloss NCS S0502 Y cherry and rosenut cherry and rosenut cherry and rosenut Frequency range 3 dB Hz HELICON C200 HELICON W200 HELICON S600 Centre Speaker Wall Speaker Active Subwoofer 49 27000 41 27000 25 175 Sensitivity 2 83 V 1m dB 90 89 Nominal impedance Q 4 4 20k Maximum SPL dB 111 108 117 Crossover frequencies Hz 2800 13000 3000 13000 45 120 Bas reflex tuning frequency Hz 36 Enclosure type Reflex Sealed Sealed Placement On top below TV or on S600 On wall Stand Floor Recommended Amp power Watt 40 250 30 150 Amplifier 300 W RMS High frequency drivers 1 x 25 mm soft dome 1 x 25 mm soft dome 1x 10x55 mm ribbon 1x 10x55 mm ribbo
5. ews approximately 5 to 10 turns counter clockwise and the brackets will loosen their grip Do not unscrew more than 5 to 10 turns or the bracket may fall off the screws DALI Helicon IW 200 Phantom must be fitted with a drop wire to prevent the speaker trom fall ing in the event of fire earthquake etc To pre vent injury or damage from a fall fit a steel wire or other non flammable connection between a solid support in the house ceiling beam wall stud etc and the eyehook on the Helicon IW 200 Phantom as shown Connect cables so that the loudspeaker is in cor rect phase The red loudspeaker terminal must be connected to the red amplifier terminal The black loudspeaker terminal must be connected to the black amplifier terminal Remove insulation so that approx 2 of bare wire is exposed Press the top of the terminal down and insert the bare wire into the open ing When the wire is fully in place with no loose strands exposed release the terminal The cable is now connected Mounting Template The enclosed template can be used to initially visualise how your speakers should be mounted Then tape the template perfectly level at the selected mounting position so that you can mark the necessary opening Skabelonen skal v re 100 vandret for sk ring WARNING INSTALLATIONS MUST BE INSTALLATION CUT OUT SIZE MOUNTING DEPTH 3 74 DONE BY TRAINED PROFESSIONALS AF
6. n Midrange drivers 2x 64 1x 6 Low frequency drivers 2x 12 long throw Connection inputs Bi wire Bi wire RCA Stereo low pass filtered RCA Mono LFE Controls 7 Volume Crossover Frequency Phase Dimensions HxBxD cm 21 65x 435 45 2 x 32 6 x 21 4 64 2 x 42 x 41 5 Dimensions HxBxD inches 8 27 x 25 59 x 17 13 17 8 x 12 83 x 8 13 25 28 x 16 54 x 16 34 Weight kg lb 18 41 10 21 40 88 Finish High gloss High gloss High gloss cherry and rosenut cherry and rosenut cherry and rosenut
7. nt After painting spray its rear with com pressed air to remove any paint in the holes Dried paint can block the sound Maintenance Clean the loudspeaker with a soft dry cloth If the cabinets are dirty a soft cloth wrung out in a mild household cleaning agent can be used Be very careful when dusting off the driver cones and domes as they are very sensitive The front grilles can be vacuumed and if necessary wiped with a lint free cloth wrung out nearly dry in a mild household cleaning agent Once again thank you for choosing DALI We remind you that your authorised DALI Helicon dealer will be glad to assist with advice on con necting and adjusting your new loudspeakers Finally we would like to invite you to visit our website www dali dk for more information on DALI and the technology behind the Helicon series Technical Specifications HELICON IW 200 Phantom In Wall Speaker HELICON 800 Main Speaker HELICON 400 Main Speaker HELICON 300 Compact Speaker Frequency range 3 dB Hz 64 27000 31 27000 31 5 27000 37 27000 Sensitivity 2 83 V 1m dB 89 89 5 88 86 Nominal impedance Q 8 4 4 4 Maximum SPL dB 107 113 111 108 Crossover frequencies Hz 3000 13000 580 3000 13000 700 3000 13500 3400 13000 Bas reflex tuning frequency Hz 28 5 32 34 5 Enclosure type Sealed Reflex Reflex Reflex Placement In wall Floor Floor Stand Recommended Amp pow
8. r stereo and surround systems where e DALI Helicon IW 200 Phantom must be installed with a secure drop wire sublime sound quality is a high priority support line e Power off the amplifier when connecting the speaker cables DALI recommends the use of a subwoofer such as DALI Helicon S600 in conjunction with Heli con IW 200 Phantom This will permit the repro Parts List duction of the lowest frequencies for an overall enhancement of your sound system The following parts are enclosed Your choice of cables is a crucial element in e 1 Helicon IW 200 Phantom your installation Be aware that replacing e 13 mm Allen wrench cables after installation is a difficult task There e 1 mounting template fore select quality cables such as DALI Silver 1 protective template for painting Wave Two e 1 owner s manual e 1 white logo badge Lo ff oF EUNGIWAL AAA ZZ STEEL WIRE MAX 30 CM 10 DROP Helicon IW 200 Phantom DALI Helicon IW 200 Phantom incorporates dog leg brackets for wall or ceiling mounting The brackets attach the loudspeaker firmly to the rear of the surface on which it is mounted They extend out at a 90 degree angle when the screws are tightened The screws should be tightened so that the loudspeaker sits securely in place but be careful not to tighten them too much If you need to remove the loudspeaker loosen the scr
9. sion charac teristics In a stereo system the speakers should ideally be placed the same distance from each other as the distance from each speaker to a central listen ing position The ideal mounting height for DALI Helicon IW 200 Phantom is at the listener s ear level when seated at the listening position i e typically 40 50 above the floor For surround systems the same guidelines as for stereo apply with the following additions The center speaker should be placed exactly in the middle between the left right front speakers The rear speakers should be placed in same height as the front speakers It is possible to place the speakers higher because of the good sound dispersion from the speakers WOOFER Installation BEWARE OF INSTALLATIONS PAS PA INSTALLATIONER a n Please study and follow the safety guidelines found on page 2 and 4 of this manual DALI Helicon IW 200 Phantom must be installed by a trained professional to ensure that all safety requirements are met to prevent it from falling etc The following tools and items are necessary for proper installation e Spirit level and tape measure e Pencil and saw or knife e 3 mm Allen wrench included with loudspeaker e Wire cutter and cutting nippers for mounting of steel wire e Drill and bit e Steel wire e Hook and rawlplugs of the correct sizes e Paint
10. the screws and shredding the thread Installation Ao ff ff COMAING I WALL A STEEL WIRE MAX 30 CM 10 DROP 9 45 24 cm 1 7 43 2 em PPPE 4 10 cm Painting the Loudspeaker optional Painting the loudspeaker requires great care and attention and should only be done by a qualified professional The loudspeaker s frame and front grille can be painted in colours to match your home decor We recommend spray paint It is extremely important for the loudspeaker s performance that no paint touches the drive units Therefore it is necessary to cover the black front and the drive units with the enclosed protective template before painting NOTE When painting the loudspeaker do not remove the drive units and the switch The front grille should be removed from the loudspeaker before painting Before painting the front grille remove the logo badge After painting it can be replaced with the new logo badge enclosed with the loud speaker The protective template must be carefully posi tioned because the drive units are very sensitive and can be damaged by even the slightest pres sure When the frame has been painted and the paint is dry remove the template It can be used again if you wish to re paint the loudspeaker later The front grille must be painted only from the fro

manual

Contents

Download Pdf Manuals

Related Search

Related Contents