SOLAR SHED LIGHT USER MANUAL
Contents
1. Py w OPERATION First Use It is recommended that the battery pack be charged by the solar panel in direct sunlight for 14 hours before the first use The LED light A can be turned on off by the switch A3 located on the side The solar shed light is now ready to be used and will run approximately 3 hours on full charge Page 2 OPERATION CONTINUED Back View Back View To change the battery pack in the LED light Remove the 2 screws in the back of the light Once the screws are removed separate the cover from the casing this might have a little resistance Once the case is removed remove the battery pack D by unclipping it from the casing and replace it with a new fully charged battery pack Finish by reassembling the light CARE AND MAINTENANCE e From time to time ensure the plug between the solar panel and light is securely connected e It is advisable to adjust the angle of the solar panel to optimize the exposure of the sun during the winter months The solar panel should be cleaned with a damp cotton cloth on a regular basis This will ensure optimal performance and battery charging Utilize the same technique periodically to clean the lens of the shed light Never let any abrasive material come into contact with the solar panel TROUBLESHOOTING Where should the solar panel be mounted Mount the solar panel in a position that will enable the most amount of light to be absorbed In the Northern H2. Yatriot scan LIGHTING SOLAR SHED LIGHT USER MANUAL THIS PRODUCT IS DESIGNED TO THE HIGHEST TECHNICAL SPECIFICATIONS AND STANDARDS IT WILL SUPPLY YEARS OF MAINTENANCE FREE USE PLEASE READ THESE INSTRUCTIONS THOROUGHLY PRIOR TO INSTALLATION KEEP THESE INSTRUCTIONS SAFE FOR FUTURE REFERENCE IMPORTANT INFORMATION Avoid exposing the LED shed light to weather hazards including rain The solar panel is weatherproof If using a step ladder have a second person help install the solar panel and or shed light Prior to installation make sure all the components mentioned in the part list section below are present Never look directly into the shed light when illuminated PARTS LIST Front View A 5 LED Shed Light x1 Socket for solar panel plug 5 Super bright LEDs ON OFF Switch Key hole mounting slots B Solar Panel x1 Back View 1 Mounting bracket 2 8ft wire C Mounting Screws x5 D AA Battery Pack x1 TOOLS REQUIRED not included ck eD C Erectie Power Dri Screwdriver Peni Ladder Eye Protection tev INSTALLATION The solar panel B is fully weatherproofed and can be installed outside Maximize sun exposure by orientating the panel towards the sun This procedure will optimize charging of the light s internal battery pack Be aware of overhanging trees or obstacles that can affect sun exposure
3. emisphere this is usually south facing Does the solar panel require direct sun to charge The solar panel can charge the internal battery pack in direct and indirect light For best results try to optimize the solar panel s sun exposure Can additional or extended cable wire for the solar panel be At this point there are no extensions available for the cable that connects the light to the purchased solar panel Any additions to the cable will void the warranty What type of battery does the LED shed light require to operate The LED shed light requires the use of a Ni MH rechargeable AA battery pack made up of 3 batteries WARRANTY ONE YEAR LIMITED WARRANTY If during normal use this PATRIOT LIGHTING lighting fixture breaks or fails due to a defect in material and workmanship within one 1 year from the date of original purchase simply bring this lighting fixture with the original sales receipt back to your nearest MENARDS retail store At its discretion PATRIOT LIGHTING agrees to have the product or any defective part s repaired or replaced with the same or similar PATRIOT LIGHTING product or part free of charge within the stated warranty period when returned by the original purchaser with original sales receipt This warranty 1 excludes expendable parts including but not limited to light bulbs and batteries 2 does not cover damage that has resulted from abuse or misuse and 3 does not cover any losses labor injurie
4. on the panel The LED shed light A is an interior light and should only be installed in a dry area away from the effects of the weather Page 1 INSTALLATION CONTINUED INSTALLING THE LED LIGHT OPTION 1 INSTALLING THE LED LIGHT WITH INTEGRATED MAGNETS Back View Metallic Surface v4 Ut The LED shed light A has integrated magnets for easy and practical installation without the use of screw holes OPTION 2 INSTALLING THE LED LIGHT WITH MOUNTING HARDWARE Back View E Side View wai C C Step 1 Step 2 Step 3 Step 4 The LED shed light A has two pre drilled key hole mounting slots A4 for permanent Use a power drill to drill Install the included screws Place the LED shed light A installation The two pre drilled key hole mounting slots are approximately 6 5 inches the holes on the chosen C into the chosen surface over the screws aligning the apart mounting surface key hole mounting slots with the screws Pull downwards to secure the light in place INSTALLING THE SOLAR PANEL Front View Side View Step 1 Step 2 Step 3 Place the solar panel mounting bracket B1 Use a power drill to drill the holes on Screw the solar panel B to the You can now connect the wire B2 from the solar panel to on the chosen surface Using a pencil mark the chosen mounting surface chosen surface with the included the LED shed light socket A1 the three screw holes through the bracket screws C
5. s to persons property or costs This warranty does give you specific legal rights and you may have other rights which vary from state to state For questions regarding this product please call 1 888 478 6435 from Monday to Friday 8 30 am to 5 00 pm Eastern Standard Time Proof of purchase including date and an explanation of complaint is required for warranty service Page 3
Download Pdf Manuals
Related Search