View User`s Manual
Contents
1. HA80 User Manual A Channel PA System www harbingerproaudio com Welcome Congratulations on your purchase of the Harbinger HA80 PA Mixer and Speaker System Built within rugged vinyl covered wood enclosures they are the ideal choice for musicians looking for a P that sounds great night after night This manual will help you setup your new system By following our guidelines and suggestions your new Harbinger will provide many years of great sound and reliable service Inside you ll find e 80 Watt Mixer Amplifier Two Full range Two way Speakers for Rich Sound 4 Channels with Individual Balanced Mic Unbalanced Line Inputs e Built in Digital Delay Effect amp 3 Band Master EQ Volume Tone and Effect Levels on Every Channel for Complete Sound Control e AUX Input for CD and MP3 Players e Stereo Output to Recorders Tape Decks Computers and more Exclusive Sure Protect Rubber Corners on Mixer and Speakers for Long Lasting Protection Built in Stand Mounts will fit Standard Mounting Poles Two 25 Speaker Cables included FCC Statements 1 Caution Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment 2 Note This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable prote2. used use caution when moving cart p apparatus combination to avoid injury A from tip over me 13 Unplug this apparatus during lightning storms or when unused for long periods of time 14 Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation ports or any other openings 15 Refer all servicing to a qualified service professional Servicing is required when the apparatus does not oper ate normally or has been damaged in any way including damage to the power cord or plug damage due to liquids spilled or objects dropped inside the unit dropping the unit or anything else that interrupts normal use of the unit 16 WARNING To reduce the risk of fire or electric shock do not expose this apparatus to rain or moisture 17 When a mains plug is used as the disconnect device the disconnect device shall remain readily operable C29 Front Panel VOLUME TONE EFFECT VOLUME TONE EFFECT VOLUME TONE EFFECT VOLUME TONE EFFECT O ED 63 O E LINE LINE 4 5 9 10 11 12 Volume Control This controls the volume for each channel and sends the signal to the master mix bus Typical operation is between 4 and 8 depending upon the device s on the channel Please remember that this acts like a preamp so if you are using a device that has a volume output control i e an MP3 player or CD player you will need to do some level matching by adjusting the level con
3. 8 controls the level of this input Stereo input is summed internally for mono playback through the system Aux Out RCA jacks for hooking up a stereo recording device to record directly from the mixer The signal is taken from the pre master section so it does not include the master tone section the delay effect or the Aux In signal The impedance is 1k Ohm 10 dBv Specifications Model HA80 4 Channel Powered Mixer 80 Watts Ohms Power Output 55 Watts 8 Ohms CH 1 4 Mic XLR Balanced Line 1 4 Unbalanced Mono Inputs Line Level RCA Stereo IN summed AUX IN internally for mono playback through system 70 dB Mic Input Ch 1 4 to Speaker Out 50 dB Line input CH 1 4 to Speaker Out 40 dB Tape In to Speaker Out Maximum Gain Volume Max 40 dB Mic Input Ch 1 4 to Line Out Tones flat 20 dB Line input CH 1 4 to Line Out 10 dB Tape In to Line Out 40 dB Mic Input Ch 1 4 to Tape Out 20 dB Line input CH 1 4 to Tape Out Input Channel Equalization 15 dB 5 kHz Tone 15 dB 10 kHz High Master Equalization 15 dB 1 5 kHz Mid 15 dB 100 Hz Low Phantom Power 15v Mic XLR Balanced inputs Ch 1 4 USA Canada 120VAC 60Hz 120 Watts nominal Europe 230VAC 50Hz 120 Watts nominal Power Requirements UK 230VAC 50Hz 120 Watts nominal Australia 240VAC 50Hz 120 Watts nominal minke 130 Height x 480 Width x 310 Dep
4. could result in some hearing loss Ear plugs or protectors in the ear canal or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss If exposure in excess of the limits as put forth above to insure against potentially harmful exposure to high sound pressure levels it is recommended that all persons exposed to equipment capable of inducing high sound pressure levels such as this amplification system be protected by hearing protectors while this unit is in operation CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE CHASSIS NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR THIS SYMBOL IS INTENDED TO ALERT THE USER TO THE PRESENCE OF NON INSULATED DANGEROUS VOLTAGE WITHIN THE PRODUCT S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS THIS SYMBOL IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE SERVICING INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE UNIT APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUIDS SUCH AS VASES SHALL BE PLACED ON THE APPARATUS IMPORTANT SAFETY INSTRUCTIONS 1 Read all safety and operating instructions before using this product 2 All safety and operating instruction
5. ction against harmful interference in a residential installation This equip ment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help ID User Manual Important Safety Instructions DANGER Exposure to extremely high noise levels may cause permanent hearing loss Individuals vary considerably to noise induced hearing loss but most will lose some hearing if exposed to intense noise for a sufficient period of time The U S Government s Occupational Safety and Health Administration OSHA has specified the following permissible noise level exposures DURATION PER DAY HOURS 8 6 4 3 2 SOUND LEVEL dB 90 93 95 97 100 103 According to OSHA any exposure in the above permissible limits
6. e event that applicable law does not allow the limitation of the duration of the implied warranties to the warranty period then the duration of the implied warranties shall be limited to as long as is provided by applicable law No warranties apply after that period So we may serve you better please register on line at www HarbingerProAudio com California Prop 65 Warning This product may contain a chemical s known to the state of California to cause cancer or birth defects or other reproductive harm Retailer and manufacturer shall not be liable for damages based upon inconvenience loss of use of product loss of time interrupted operation or commercial loss or any other incidental or con sequential damages including but not limited to lost profits downtime goodwill damage to or replacement of equipment and property and any costs of recovering reprogramming or reproduc ing any program or data stored in equipment that is used with Harbinger products This guarantee gives you specific legal rights You may have other legal rights which vary from state to state Harbinger P O Box 5111 Thousand Oaks CA 91359 5111 All trademarks and registered trademarks mentioned herein are recognized as the property of their respective holders Made in China 0807 8187 01 E HARBINGER X www harbingerproaudio com
7. nt of middle frequencies 1 5kHz allowing 15 dB of boost or cut 12 Master High This controls the overall amount of high frequencies 10kHz allowing 15 dB of boost or cut Power This switches the unit on or off When the unit is powered up a red LED will illuminate User Manual be 9 gt Back Panel 20V 600 HZ 120W CAUTION SPEAKER OUT FF Colon lt D 80 WATTS ers D CAN CSA STD Q 22 2 LK C Ko CAUTION ATTENTION Hae HA80 RO OR FACEHOT SUPERACE DECHASSS CHUDE NO USER SERVICEABLE PARTS 8 OHM SERIAL NUMBER IN OUT PEPE ETTER AC Cable Standard cable for use with standard voltages from AC wall outlets It is grounded and should never have the ground pin removed for any reason Speaker Out 1 4 2 conductor speaker outputs Each one is rated for an 8 Ohm minimum impedance Total minimum load for the amplifier is 4 Ohms You may connect one 4 Ohm one 8 Ohm or two 8 Ohm speaker cabinets Do not go below the rated minimum impedance Line Out 1 4 2 conductor line level output The impedance is 1k Ohm 10 dBv It is used to connect the HA80 to either an additional power amplifier or an external recording device This line level signal comes out after the master EQ section and before the power amp Aux In RCA jacks for playing an MP3 Player CD player or other line level source through the system The impedance is 10k Ohms 10 dBv Aux volume on front panel
8. rProAudio com or visit www HarbingerProAudio com Return Authorization Number must be obtained from our Customer Service Department prior to shipping the product To locate a repair center near you and to obtain a Return Authorization Number contact support HarbingerProAudio com or visit www HarbingerProAudio com This warranty does not cover service or parts to repair damage caused by neglect abuse normal wear and tear and cosmetic appearance to the cabinetry not directly attributed to defects in materials or workmanship Also excluded from coverage are damages caused directly or indirectly due to any service repair s or modifications of the cabinet which has not been authorized or approved by Harbinger This two 2 year warranty does not cover service or parts to repair damage caused by accident disaster misuse abuse burnt voice coils over powering negligence inadequate packing or inadequate shipping procedures The sole and exclusive remedy of the foregoing limited warranty shall be limited to the repair or replacement of any defective or non conforming component All warranties including but not limited to the express warranty and the implied warranties of merchantability and fitness for a particular purpose are limited to the two 2 year warranty period Some states do not allow limitation on how long an implied warranty lasts so the above limitation may not apply to you There are no express warranties beyond those stated here In th
9. s should be kept for future reference 3 Read and understand all warnings listed on the operating instructions 4 Follow all operating instructions to operate this product 5 This product should not be used near water i e a bathtub sink swimming pool wet basement etc 6 Use only a dry cloth to clean this product 7 Do not block any ventilation openings The product should not be placed flat against a wall or placed in a built in enclosure that will impede the flow of cooling air 8 Do not install this product near any heat sources such as radiators heat registers stoves or any other apparatus including heat producing amplifiers that produces heat 9 Do not defeat the safety purpose of the polarized or grounding type plug A polarized plug has two blades with one wider than the other A grounding type plug has two blades and a third grounding prong The wide blade or the third prong are provided for your safety If the provided plug does not fit into your outlet consult an electrician for replacement of the obsolete outlet 10 Protect the power cord being walked on or pinched particularly at plugs convenience receptacles and the point where they exit from the apparatus Do not break the ground pin of the power supply cord 11 Only use attachments specified by the manufacturer 12 Use only with the cart stand tripod bracket or table specified by the manufacturer or sold with the apparatus When a cart is
10. th Dimensions amp Weight Powered 8 1 kg Mixer only y laches Ponni 5 1 Height x 18 9 Width x 12 2 Depth 17 9 Ibs Speaker Information 60 Watts each RMS Power Capacity 120 Watts each Program Power peak music power Frequency Response 75Hz 18kHz Sensitivity 96 dB each 1 Watt I Meter Nominal Impedance 8 Ohms 475 Height x 350 Width x 270 Depth mm kg 9 8 kg Dimensions amp Weight Per Cabinet EE 18 7 Height x 13 8 Width x 10 6 Depth 21 6 Ibs User Manual HA80 Block Diagram amp Warranty Volume Volume Tone Effect Speaker Out Power Amp i Effect Speaker gle Volume Out lala 3 amp ET EET ede 22 ee Low Mid High Master EQ In Out Aux Volume IN Line Out Aux In Aux Out Harbinger Limited Warranty Harbinger provides to the original purchaser a two 2 year limited warranty on materials and workmanship on all Harbinger cabinets and loudspeaker components from the date of purchase If your covered product is defective ship the defective component together with proof of purchase freight prepaid and insured to an Authorized Harbinger repair center or directly to Harbinger Support Headquarters If you are uncertain which component is defective or to obtain instructions for removing a component please contact Harbinger Support Headquarters for assistance at support Harbinge
11. trols on each unit Tone Control This adjusts the overall tone for the output of the channel It is set at 5 kHz Since it is a cut or boost control 15 dB it will add or diminish the presence of the sound s content around that frequency Effect Control This is a send control to the Effect sending the signal from each channel to the delay effect The output of the delay is blended back in with the mixer s overall output using the master effect knob 7 3 Pin Low Impedance Microphone Input Phantom power 1 5 volts for condenser microphones is consistently available Input has an impedance of 1k Ohm The connector is wired as Pin 1 shield Pin 2 positive hot Pin 3 negative cold 1 4 Line High Impedance Input This input can be used as an input for either a high impedance microphone or line level device like a guitar keyboard or sampler It is a 2 conductor input with an impedance of 10k Ohms Both the high and low impedance inputs may be used simultaneously Master Volume This controls the overall volume level of the entire amplifier Typical operation is between 4 and 8 Master Effect This controls the level of delay effect added back to the overall mix Aux Volume This controls the level coming in from the Aux In RCA plugs on the unit s back panel Master Low This controls the overall amount of bass frequencies 100 Hz allowing 15 dB of boost or cut 10 Master Mid This controls the overall amou
Download Pdf Manuals
Related Search