Operating Instructions for Thermapen™
Contents
1. EMC RFI Instrument performance may be affected if operated within a high trequency radio tield such as near a mobile phone or it subjected to an electrostatic shock GUARANTEE This instrument carries a two year warranty against detects in either components or workmanship During this period products that prove to be detective will at the discretion of ETI be either repaired or replaced without charge This warranty does not apply to probes where a six month period is offered The product warranty does not cover damage caused by fair wear and tear abnormal storage conditions incorrect use accidental misuse abuse neglect misapplication or moditication Full details of liability are available with ETl s Terms amp Conditons of Sale available by request In line with our policy of continuous development we reserve the right to amend our product specification without prior notice2. SPECIFICATION range 49 9 to 299 9 C resolution 0 1 C or 1 C user selectable accuracy 04 C 49 9 to 199 9 C 1 C 200 to 299 9 C sensor type K thermocouple battery 2 x 3 volt CR2032 lithium coin cell battery lite 1500 hours display 14 mm LCD dimensions 19x 47x 153 mm weight 97 grams CALIBRATION test temperature instrument indication serial number calibrated by This Thermapen has been checked or calibrated against reference instrument s calibrated by an UKAS accredited calibration laboratory manufactured by Electronic Temperature Instruments Ltd Ross Brown Sales Pty Ltd ABN 28 000 690 362 Phone 612 9899 2744 Fax 612 9899 4233 Email sales rossbrownsales com au Web www rossbrownsales com au Operating Instructions for Thermapen INSTRUMENT OPERATION The instrument is switched on by unfolding the probe until the display illuminates The unit is turned off by folding the probe back into the rubber probe retainer The probe should not be rotated more than 180 degrees as damage will occur It is recommended to store the probe in the closed position when not in use Apply the tip of the probe to the substance surface or area to be measured The probe should be allowed adequate time to stabilise to the temperature of the item to be measured INSTRUMENT CONFIGURATION This instrument has four user selectable slide switches switch bank adjustable with
3. a paperclip and a single push button Trim Adjust which is located under the battery cover Switch bank Trim adjust CR2032 battery Switch factory default shown Switch 1 Not used Switch 2 Resolution To change the resolution from 0 1 C factory default to 1 C push the switch away from the batteries Switch 3 Auto oft To disable the auto off factory default 10 minutes push the switch away from the batteries Switch 4 Reading Trim For normal use we do not recommend using the Trim Adjust For further details visit www etiltd com INSTRUMENT CLEANING Clean the instrument regularly with an anti bacterial probe wipe to avoid potential food borne bacteria growth BATTERY REPLACEMENT A battery symbol indicates that the batteries will need replacing The instrument continues to measure accurately but we recommend that the batteries be changed as soon as possible To replace the batteries remove the battery cover using a coin Remove the batteries by pulling the battery retaining clip back whilst holding the unit upside down Replace both batteries positive side up replace cover ERROR MESSAGES Lo will be displayed if you are measuring below the instrument s range Hi will be displayed if you are measuring above the instrument s range Err will be displayed if the probe develops a fault If the error message remains contact our service department for turther assistance
Download Pdf Manuals
Related Search