Installation and Operating Instructions VW EOS Comfort
Contents
1. with the remote command close open open As a safety precaution the top movement can be terminated with the close button You can start the top s operation then pull in the ignition key start the car and drive away the top will continue to automatically close or open e One touch operation for the central window lift switch Now you need only to tap gt 2s with your finger on the central window lift switch then the windows will automatically open or close This automatic operation can be interrupted at any time by simply tapping on the switch again in any direction e Service mode for technical vehicle inspections and diagnostic purposes The central open switch in the drivers door can be held gt 4s depressed to activate the module to set the module into service mode deactivate it use the central lock The module is completely passive in service mode i e all functions operate as if no module was installed The module cannot even be detected with vehicle diagnostic equipment An acoustic signal will be sounded as confirmation when mode has changed Service mode is set by default after the battery has been disconnected or after the module is initially installed Attention After the module has been installed it must first be set to normal mode in order to obtain its additional features because service mode is set by default www cabrio module de page 2 of 6 www cabrio module d Dipl Inf Andreas Reinhold Blume2. 0 8548257 The module s functional scope and operation e One touch function for the top s switch Now you need only to tap gt 2s with your finger on the convertible top switch then the top will automatically open or close This automatic operation can be interrupted at any time by simply tapping on the switch again in any direction You can start the top s operation pull out the ignition key get out of the car and lock it the top will continue to automatically close or open without the ignition e Operating the top while driving up to a speed of 60 km h maximum Up to a pre programmed speed though not greater than 60 km h you can operate the top while driving e Threshold speed adjustment If while driving you press the central open button in the drivers door for longer than 4s this will automatically set the vehicle s current speed as the new threshold limit An acoustic signal will be sounded as confirmation that the new speed has been set The maximum permissible threshold speed is 60 km h Anytime the battery is disconnected including during the initial installation of the module a threshold speed of 50 km h will be set by default e Auto lock unlock The vehicle will be locked automatically when it starts to move and will be unlocked by turning off the ignition e Operating the top per OEM remote control Press the Open switch on the remote control three times and the top will open automatically Closing the top works
3. e 2 remove mounting T bber Figure 5 remove connector www cabrio module de page 4 of 6 www cabrio module de Dipl Inf Andreas Reinhold Blumenstr 36 D 97332 Volkach Fax 49 9381 710656 Mobile 49 170 8548257 Figures 7 12 module installation TP Ne nee RE X Dy a tae tras ut ww d i g p ove plastic rivets Figure 11 remove connector s housing Figure 12 remove wires www cabrio module de page 5 of 6 www cabrio module de Dipl Inf Andreas Reinhold Blumenstr 36 D 97332 Volkach Fax 49 9381 710656 Mobile 49 170 8548257 Figures 13 18 module installation NY q oe ee K oe AS i E Figure 13 wires of comfort module plugged in Figure 14 ground connection connector Figure 15 pinout connector 1 Figure 16 pinout connector 2 green lt gt green orange brown lt gt grey black blue lt gt blue orange green lt gt red black Figure 17 test the module push screwdriver in Figure 18 release locking unit locking unit www cabrio module de page 6 of 6
4. nstr 36 D 97332 Volkach Fax 49 9381 710656 Mobile 49 170 8548257 Module installation i 2 3 4 g 10 11 12 13 14 15 www cabrio module de close the top open the trunk and remove the floor pull out locking mechanism Figure 1 to remove the trunk separation remove mounting by loosen the screw Figure 2 remove warning triangle and 2 plastic rivets behind it Figure 3 and 4 Then lift the trunk sealing that the back cover can be removed by pulling it to the top it is clipsed additionally Note the wire to the trunk light must be disconnected Figure 5 remove bump rubber Figure 6 remove side cover in the trunk remove all plastic rivets Figure 7 and Figure 8 Pull the cover carefully to the middle of the trunk note the wire to the switch which is connected to the cover Disconnect the wire Figure 9 now you can remove the side cover completely pull out right connector of the roof ECU connector 1 Figure 10 pull out red locking mechanism and push the black one to remove the connector remove the housing of the connector lift locking mechanism Figure 11 and pull out remove following wires from the connector orange green Pin 1 orange wire with green stripe orange brown Pin 2 orange wire with brown stripe green Pin 9 blue Pin 10 push the locking mechanism down to pull out the wire use a small screwdriver Figure 12 push the contacts of the module in the f
5. ree places of the connector Figure 13 yellow black Pin 1 which was orange green before grey black Pin 2 which was orange brown before green Pin 9 which was green before blue Pin 10 which was blue before the wires pulled out of the connector have to be plugged in the empty 2 pole connectors You will hear a click when they are in the right position Then push the locking mechanism on the connector downwards The wires have to be plugged in like this connector 1 green Pin 1 und blue Pin 2 Figure 15 connector 2 orange green Pin 1 and orange brown Pin 2 Figure 16 now connect them like shown in figure 15 and 16 Be sure that the wiring is correct connect ground Figure 14 and permanent 12V Figure 10 connector 2 wire color red with yellow stripe We recommend to solder the 12V connection this is the safest way to connect two wires test the module push a screwdriver into the trunk lock Figure 17 now you should hear the lock motor running You can unlock it when you stick the srewdriver in it Figure 18 Press the central open button in the drivers door for gt 5s then a acoustic signal will come up to show that the module is enabled now assembly everything in the reverse order page 3 of 6 www cabrio module de Dipl Inf Andreas Reinhold Blumenstr 36 D 97332 Volkach Fax 49 9381 710656 Mobile 49 170 8548257 Figures 1 6 module installation F Figur
6. www cabrio module de Dipl Inf Andreas Reinhold Blumenstr 36 D 97332 Volkach Fax 49 9381 710656 Mobile 49 170 8548257 Installation and Operating Instructions VW EOS Comfort Module Before installation Please read these instructions carefully and take your time with the installation Performing the installation improperly can cause damage to the module or to electronic components in your vehicle Claims cannot be asserted for consequences which arise out of disregard for these installation instructions If you are not confident in doing the installation yourself please obtain the services of a vehicle specialist Attention Installation of this module may be grounds to invalidate your vehicle s homologation general type certification and or its manufacturer s warranty Do not operate the convertible top without the presence of another person there is no entanglement protection The installation and operation of the module is at your own risk Functional description The module only uses functions which were originally built into the vehicle All data relevant to convertible top control e g limit switches window position speed will be continuously monitored All OEM safety functions under over voltage cut off thermal protection etc remain intact www cabrio module de page 1 of 6 www cabrio module d Dipl Inf Andreas Reinhold Blumenstr 36 D 97332 Volkach Fax 49 9381 710656 Mobile 49 17
Download Pdf Manuals
Related Search