Delta 55531 Installation Guide
Contents
1. backing will not stick properly To clean most surfaces nail polish remover rubbing alcohol or lighter fluid can be used Be sure to follow the precautions noted on the container A mild abrasive cleaner should be used if silicone or wax has been applied to the wall Mount Rail Peel protective covering from tape being careful not to touch or otherwise contaminate the adhesive Position rail and press firmly into place by rubbing on the rail with the heel of your hand NOTE l For best results allow the adhesive to dry for a minimum of 4 hours before using shower B Screw Mounting Procedure Mark screw hole positions on the wall Drill 1 4 holes as near the center of the slotted holes as possible for the screw anchors provided use a carbide tipped drill for ceramic tile or concrete Peel adhesive protective covering from Glide Rail and install as in 3A above being sure the slotted holes are aligned with the screw anchors before pressing into place Install screws and tighten until the tape is slightly compressed Replace chrome end caps by tapping on the caps lightly with a hammer until they snap into place Protect the M caps with a cloth or other soft substance while striking 4 MOUNT HAND SHOWER Mount the hand shower on glide rail and attach to water supply Tighten hose nuts sufficiently to slightly compress the urethane hose ends which act as gasket seals www deltafaucet com 2 7262. 33 Rev B
3. Model 555314 Series A Designate proper finish suffix INSTALLATION INSTRUCTIONS FOR HAND SHOWER GLIDE RAIL Q VW Your Glide Rail adjustable shower mount is designed for easy installation using the special adhesive tape and screws supplied However before you proceed we recommend you carefully read these instructions to help determine the best mounting method and assure a satisfactory installation OOOO g 1 SELECT LOCATION Select wall position at convenient location suitable for height of bathers Hold the Glide Rail against the wall to check height and make sure it is located to permit full height adjustment with the shower hose to be used 2 DECIDE ON MOUNTING METHOD On any smooth surface such as tile fiberglass marble etc the special mounting tape attached to the rail is usually satisfactory by itself For best adhesion of the mounting tape do not mount rail directly over a vertical ceramic tile line On any rough surface such as uneven tile etc the screws provided should be used in addition to the tape www deltafaucet com 1 3 9 12 Rev B 3 MOUNT GLIDE RAIL A Adhesive Bonded Mounting Procedure iy Clean Surface If mounting tape only is used the wall surface must be thoroughly cleaned To achieve maximum adhesion it is necessary that the surface be free of any residue If the wall surface is not absolutely dry and clean the self adhesive
Download Pdf Manuals
Related Search