Progress Lighting PE012-30 Installation Guide
Contents
1. PROGRESS LIGHTING Assembly amp Installation Instructions PE012 IMPORTANT SAFEGUARDS When using electrical equipment basic safety precautions should always be followed including the following READ AND FOLLOW ALL SAFETY INSTRUCTIONS Do not let power supply cords touch hot surfaces Do not mount near gas or electric heaters Equipment should be mounted in locations and at heights where it will not readily be subject to tampering by unauthorized personnel The use of accessory equipment not authorized by the manufacturer may cause an unsafe condition Do not use this equipment for other than its intended purpose Servicing of this equipment should be performed by qualified service personnel Do not use outdoors INSTALLER SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS SAVE THESE INSTRUCTIONS FOR USE BY OWNER OCCUPANT WARNING This product contains chemicals known to the State of California to cause cancer birth defects and or other reproductive harm Thoroughly wash hands after installing handling cleaning or otherwise touching this product J Box Mounting Feed fixture leads through main bottom case and connect AC power supply Connect wires through J Box Main bottom case on J Box and secure with screws Connect battery only after continuous AC power can be provided to the unit Align snaps and push housing directly onto main bottom case Apply continuous AC power and press TEST button to check light onduit2. Secure main bottom case to wall surface Route wires through hole in conduit flange and make conduit connection Connect battery only after continuous AC power can be provided to the unit Align snaps and push housing directly onto main bottom case Apply continuous AC power and press TEST button to check light During an electrical power failure the lamps will automatically come on for a minimum of 90 minutes Operation 13 2 To test depress the TEST switch The emergency lamps will illuminate When the switch is released the lamps will go off 277 VOLT RED Warning 120 VOLT Unused wires must be capped using enclosed wire nuts NEUTRAL CHARGER BOARD BLACK g BATTERY READY TEST 3 6V 900 MAH RECYCLING INFORMATION All steel aluminum and thermoplastic are recyclable All cartons contain recycle d materials Please recycle responsibly Page 1of1 93046404 REV A
Download Pdf Manuals
Related Search