Sea Gull Lighting 44853-782 Installation Guide
Contents
1. Installation And Safety Instructions HC 1301 Sea Gull Lightin Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM __ Clee IMPORTANT SAFETY INSTRUCTIONS BEFORE YOU BEGIN Be sure the electricity to the system you are working on is turned Carefully remove the fixture from the carton and check that all parts off either the fuse removed or the circuit breaker set at off are included as shown in figure 1 and 2 Be careful not to misplace Use of other manufacturers components will void warranty listing any of the screws or parts which are needed to install this fixture and create a potential safety hazard Ifyou are unclear as to how to proceed contact a qualified electrician You don t need special tools to install this fixture Be sure to follow the steps in the order given Read instructions carefully Save these instructions BACKPLATE C GREEN GROUND MOUNTING CANOPY 1 GROUNDING WIRE SCREWS F SCREW G CAP NUTS E SOCKET CUP B j RETAINING SHADE A FIGURE 1 RING H NOT INCLUDED INSTALLATION HC 1301 STEP 4 IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX STEP 1 Place backplate C against wall and mark location for dr2. The green grounding screw G is to be inserted into the hole with two raised dimples provided on the backplate C Wrap the ground wire from the fixture if supplied and the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw G on the backplate C if uninsulated wire is on the backplate C connect the ground wire from the fixture if supplied and the outlet box to it using a small wire connector not supplied NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES FINAL ASSEMBLY STEP 1 Make sure no bare wires can be seen outside wire connectors After wires are connected tuck them carefully inside outlet box Push the fixture firmly over the mounting screws F and against the wall Secure canopy I in place by threading cap nuts E onto fixture mounting screws F STEP 2 Place shade A on socket cup B and secure by threading retaining ring H onto socket STEP 3 Install lamps CLEANING To clean wipe fixture body with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when ordering parts
3. ywall anchors Remove backplate C and drill appropriate sized holes into drywall STEP 2 Pull supply wires through appropriate opening in backplate C Place backplate C against wall and secure by installing drywall screws not supplied into drywall anchors STEP 3 A Take note of the color of the wire s on your fixture Identify which group your fixture wire s falls into and connect the wires according to the directions below GROUP A CONNECT TO BLACK GROUP B CONNECT TO WAITE HOUSE WIRE HOUSE WIRE BLACK WHITE PARALLEL WIRE ROUND amp SMOOTH PARALLEL WIRE SQUARE amp RIDGED ba Note When parallel wire is used the tracer wire is square shaped or ridged and less tracer wire is round in shape or smooth Seen best when viewed from wire end To separate wires grasp the ends of each wire and pull apart B Take your fixture wire s from group A and place evenly against the black wire from the outlet box DO NOT twist wires together before using wire connectors C Fit a wire connector not supplied over the wires and thread the connector clockwise until you feel a firm resistance D Gently try to remove the wires from the connector If you can remove the wires carefully re do steps B and C as above and check again for a firm connection E Connect the fixture wire from group B to the white wire from the outlet box in the same manner GROUNDING INSTRUCTIONS
Download Pdf Manuals
Related Search