TAFCO WINDOWS VCC9548-RL Installation Guide
Contents
1.2. Casement Awning Window Installation Instructions arco 7 bus Viny Mounting Flange Nailing Fin Window ROUGH OPENING PREPARATION WINDOW PREPARATION Rough opening should be sized one half The operable sash of the window must inch 112 larger than the window size in width remain closed and locked during the entire and height Provide a minimum of one quarter installation process inch 1 4 clearance at the top head and one eighth inch 1 8 clearance on each side Apply a three eights inch 3 8 nominal amb of the unit improperly sized rough continuous bead of sealant to the interior openings will not allow the window to function perimeter of the mounting flange nailing fin in as was intended line with the pre punched holes and along the seams of all joints at the comers it is important WINDOW INSTALLATION to property select and apply sealant Immediately set the window centered in the rough opening and compress the sealant against the wall Select and apply shims as necessary The proper number and position of shims is important Position shims where support is needed but do not over or under shim as either can cause distortion of the window frame I shims are needed at the sill use gt continuous support across the entire bottom Gill of the window to prevent any warping Sagging or crowning Fasten tack upper comer on the side amb not the top head in place through the 1 moun
3. ting flange nailing fin three inches 3 from the comer using an appropriate fastener that will penetrate the stud one inch 1 DO NOT DRIVE THE FASTENER ALL THE WAY IN Adjust the shims and check the window for level plumb and true Make sure the window is square operates smoothly the operable sash is square in its opening and the latches are able to engage Fasten tack the comer diagonally opposite the upper comer that was tacked first on the side jamb not the bottom sil in place through the mounting flange nailing fin three inches 3 rom tne comer using an appropriate fastener that will penetrate the stud one inch 1 DO NOT DRIVE THE a A nin A pate or ey ame FASTENER ALL THE WAY IN ober obstructive material CLEANING THE WINDOW Start cleaning the window by removing any visible residue Clean and clear all excess building materials such as plaster cement soil paint and excess caulk sealant from the window to ensure proper functioning A vacuum cleaner should be used to remove loose debris and drywall dust from the window track and interlock Inspect and clean all weepholes to ensure proper drainage of the window A mild detergent cleaner can be used along with a soft sponge to gently scrub the surface of the window if soil stil adheres Mild detergent deemed safe for bare hands should be safe to use on vinyl windows ABRASIVE PADS SHOULD NOT BE USED TO CLEAN FINISHED SURFACES
Download Pdf Manuals
Related Search