Xerox 4004 User's Manual
Contents
1. Step by Step Instructions PRINT this set of instructions to follow every time you refill your cartridge Xerox 8R7638 8R7659 4004 Cartridges Xerox Xj4C Document Work Centre 450C 4004 Home Work Centre Printers Texas Instruments Micromarc Printers Make 3 mm 1 8 Hole Nozzel Assembly a Items needed gloves 2 refill station hand drill Flat aluminum plugs dye based black ink paper towels review hints amp tips and check list Bottle Seal Unscrew lid on ink bottle Puncture silver seal with needle top making a small hole in the center of seal Tightly screw on dispensing tip Rinse dispenser tip before using dispenser tip with another color Rinse tip with water until the water runs clear Pull plastic tip cover off of tip of syringe to pour ink 1 Make a filling hole on the front of the cartridge 1 2 from the top using the thumb drill provided 2 Insert the Black Dye filling needle through the hole and push towards the center of the cartridge The cartridge contains felt Stop inserting the syringe when the needle touches the felt The needle is in as far as it can go 3 Slowly inject up to 20 ml of ink or until ink appears at the filling hole 4 Seal the filling hole with the aluminum tape provided 5 Xerox_8R7638 Check the ink flow by gently pressing a dry paper towel against the printhead You should see a line or dot of Black ink If not gently press a warm wet paper towel against the print2. head until the black is visible 6 When black is visible on paper towel place cartridge back into the printer and run 1 to 2 print tests Or print 2 pages at this test site http www inkonline net support blackinktest Black ink test For best results leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge Note Empty cartridges should be refilled immediately To Clean the Printhead Clean the printhead only if the cartridge doesn t print or prints in streaks 1 Follow the directions in the printer manual 2 If that doesn t work here s a quick and easy method to try next o Turn on the hot water faucet and let the water get good and hot Stick just the copper printhead under the hot water for 3 to 5 seconds Remove the printhead and dry with a tissue Re insert in the printer and run the printhead cleaning routine Print 2 pages You should get dilute print for a half page or so and then good quality printing 3 If this doesn t work soak only the printhead in simmering water for up to 2 hours You may add up to 50 percent ammonia for tough clogs O O O O
Download Pdf Manuals
Related Search