Shure RK100PKW User's Manual
Contents
1. Model RK1OOPK and RK100PKW Microflex Se U Preamplfier Kit User Guide INSTALLATION RK100PK BLACK RK100PKW WHITE 5 Insert the rubber flex relief G into the cap C and feed The RK100PK and RK100PKW preamp comes assembled for through the microphone cabling use with microphones using a miniature 4 pin connector To wire a Note You will need to reuse the rubber flex relief from your old microphone cable directly to the preamp follow these instructions preamp If the rubber flex relief is unavailable please contact the Shure Service Department 1 Turn screw A counter clockwise until it recedes below the case 2 Remove the cap C by removing the set screw B with the provided hex wrench 05 in 6 Solder the wires directly back onto the circuit board Match wires as marked on the circuit board using the fol lowing key R RED B BLACK S GROUND SHIELD FIGURE 1 3 Push the circuit board out from the case interior to expose the black and red wires D 4 Unsolder the wires from the circuit board E FIGURE 4 7 Push the circuit board back into the case making sure that the set screw A is lined up with the screw hole in the side of the case if the circuit board does not go in all the way twist it slightly until the screw and hole are aligned Raise the set screw A by turning clockwise so that the preamplifier is held securely in place Screw on the cap C Do not use th2. e set screw with the cap FIGURE 2 SHURE Incorporated http www shure com United States Canada Latin America Caribbean 5800 W Touhy Avenue Niles IL 60714 4608 U S A Phone 847 600 2000 U S Fax 847 600 1212 Int l Fax 847 600 6446 Europe Middle East Africa Shure Europe GmbH Phone 49 7131 72140 Fax 49 7131 721414 Asia Pacific Shure Asia Limited Phone 852 2893 4290 Fax 852 2893 4055 27A3252 Rev 1 A Printed in U S A 2007 Shure Incorporated
Download Pdf Manuals
Related Search