Harbor Freight Tools 4 gal. Backpack Sprayer Product manual
Contents
1. all text under subheadings therein before set up or use of this product 7 For continuous spray press the Trigger down and push the Trigger Lock back then release the Trigger To stop continuous spray press the Trigger down and push the Trigger Lock forward then release the Trigger Trigger Lock Trigger Trigger Lock On Trigger Lock Trigger Trigger Lock Off Figure F 8 As you spray the Sprayer will depressurize When decreased pressure is affecting spray pattern pump the Pump Handle until proper pressure is achieved then resume spraying 9 When finished spraying a Point Wand is safe direction and depressurize the Tank by pressing down on the Trigger b Dispose of liquid according to manufacturer guidelines c Clean the Sprayer according to Maintenance Instructions please call 1 800 444 3353 Item 61368 Inspection Maintenance and Cleaning Procedures not specifically explained in this manual must be performed only by a qualified technician AWARNING TO PREVENT SERIOUS INJURY FROM PRODUCT FAILURE Do not use damaged equipment If abnormal noise vibration or leaking air occurs have the problem corrected before further use Follow all guidelines regarding chemicals sprayed including MSDS instructions and EPA regulations 1 BEFORE EACH USE inspect the general 2 AFTER EVERY USE Clean the Sprayer condition of the Sprayer Check for a Flush with water loose hardware b Clea2. by the operator Store idle tools and equipment out of reach of children and other untrained people Tools and equipment are dangerous in the hands of untrained users Maintain the Sprayer with care Keep this product clean A properly maintained Sprayer is easier to control A SAVE THESE INSTRUCTIONS Item 61368 For technical questions please call 1 800 444 3353 Page 3 Specifications Tank Capacity 4 Gallons Empty Weight 6 4 Ib Full Weight 40 4 Ib Components and Controls Note For additional information regarding the parts listed in the following pages refer to the Assembly Diagram near the end of this manual Tank Pump Handle Lock Pump Handle Tank Hose Shoulder diligo Strap Trigger Trigger Lock Nozzle p Figure A Page 4 For technical questions please call 1 800 444 3353 Item 61368 Assembly Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product Assembling the Wand 1 Insert end of Wand into end of 2 Slide Hose Nut 27 over threaded end of Wand Handle Assembly Handle then tighten Hose Nut securely Wand Hose Handle Wand Nut Assembly CoS e Figure B Changing the Nozzle 1 Loosen Hose Nut 27 and remove Single Nozzle 53 from end of Wand 2 Choose another Nozzle a Double Nozzle 54 b Fan Noz
3. LUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS To take advantage of this warranty the product or part must be returned to us with transportation charges prepaid Proof of purchase date and an explanation of the complaint must accompany the merchandise If our inspection verifies the defect we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement We will return repaired products at our expense but if we determine there is no defect or that the defect resulted from causes not within the scope of our warranty then you must bear the cost of returning the product This warranty gives you specific legal rights and you may also have other rights which vary from state to state GREENWOOD 3491 Mission Oaks Blvd PO Box 6009 Camarillo CA 93011 800 444 3353
4. Owner s Manual amp Safety Instructions Save This Manual Keep this manual for the safety warnings and precautions assembly operating inspection maintenance and cleaning procedures Write the product s serial number in the back of the manual near the assembly diagram or month and year of purchase if product has no number Keep this manual and the receipt in a safe and dry place for future reference 4 GALLON HOME amp GARDEN BACKPACK Visit our website at http www harborfreight com ITEM 61368 Email our technical support at tech harbortfreight com When unpacking make sure that the product is intact and undamaged If any parts are missing or broken AWARNING please call 1 800 444 3353 as soon as possible Copyright 2013 by Harbor Freight Tools All rights reserved No portion of this manual or any artwork contained herein may be reproduced in Read this material before using this product any shape or form without the express written consent of Harbor Freight Tools Failure to do so can result in serious injury Diagrams within this manual may not be drawn proportionally Due to continuing SAVE THIS MANUAL improvements actual product may differ slightly from the product described herein Tools required for assembly and service may not be included WARNING SYMBOLS AND DEFINITIONS This is the safety alert symbol It is used to alert you to potential personal injury hazards Obey all safety messages that follow th
5. iption Q 1 Wggerlok 2 mgserPm 7 Sealing Ball Seat Pump Handle Cover oO 0 Part EIE sz Lee om Spare Parts Kit Includes Parts 2 17 27 47x2 not shown 58 Seal Kit not shown 1 N eo N O Part EON DE ul WINITNMI MINI MI MINIM Oj dv oo o oO1 i o N Page 10 For technical questions please call 1 800 444 3353 Item 61368 Assembly Diagram 1c 8 6C Item 61368 For technical questions please call 1 800 444 3353 Page 11 Limited 90 Day Warranty Harbor Freight Tools Co makes every effort to assure that its products meet high quality and durability standards and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase This warranty does not apply to damage due directly or indirectly to misuse abuse negligence or accidents repairs or alterations outside our facilities criminal activity improper installation normal wear and tear or to lack of maintenance We shall in no event be liable for death injuries to persons or property or for incidental contingent special or consequential damages arising from the use of our product Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation of exclusion may not apply to you THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED INC
6. is symbol to avoid possible injury or death A DANGER Indicates a hazardous situation which if not avoided will result in death or serious injury AWARNING Indicates a hazardous situation which if not avoided could result in death or serious injury ACAUTION Indicates a hazardous situation which if not avoided could result in minor or moderate injury NOTICE _ Addresses practices not related to personal injury CAUTION IMPORTANT SAFETY INFORMATION AWARNING Read all safety warnings and instructions Failure to follow the warnings and instructions may result in serious injury Work Area 1 Keep your work area clean and well lit 3 Keep bystanders children and visitors Cluttered dark areas invite accidents away while operating the Sprayer Distractions can cause you to lose control 2 The work area should have adequate drainage to reduce the possibility of a fall due to slippery surfaces Personal Safety 1 Follow all guidelines regarding 4 Dress properly Do not wear loose chemicals sprayed including MSDS clothing or jewelry Contain long hair instructions and EPA regulations 5 Do notoverreach Keep proper 2 If the amount of weight you can lift safely footing and balance at all times is limited do not fill the Tank completely Proper footing and balance enable better to prevent strain and injury control of the tool in unexpected situations 3 Stay alert Watch what you are doing and use 6 Always
7. n Nozzle Wand Handle Filter 33 misalignment or binding of moving parts and Tank Filter 21 cracked or broken parts and c Rinse with water and allow to air dry with the Tank open any other condition that may affect its safe operation 3 PERIODICALLY lubricate all moving parts of the pump assembly with petroleum jelly 4 Store the Sprayer in a safe dry clean location out of reach of children and out of sunlight GREENWOOD Item 61368 For technical questions please call 1 800 444 3353 Page 7 Troubleshooting Possible Causes Likely Solutions Unit does not spray Spray pattern is undesirable Not enough liquid in tank Sprayer not pressurized Tank Lid loose Hose Nuts loose Pump Lid 12 loose Spray fluid contains particles or sand Nozzle and or Filter clogged with mineral buildup Spray fluid contains particles or sand Nozzle and or Filter clogged with mineral buildup Add liquid to tank Pump Handle to pressurize Sprayer Tighten Tank Lid Tighten Hose Nuts Tighten Pump Lid Disassemble clean then reassemble Nozzle and or Wand Handle and Tank Filters Empty clean then refill Tank with properly strained fluid Disassemble clean then reassemble Nozzle and or Wand Handle and Tank Filters Disassemble clean then reassemble Nozzle and or Wand Handle and Tank Filters Empty clean then refill Tank with properly strained fl
8. uid Disassemble clean then reassemble Nozzle and or Wand Handle and Tank Filters Follow all safety precautions whenever diagnosing or servicing the Sprayer Page 8 GREENWOOD For technical questions please call 1 800 444 3353 Item 61368 PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS DOCUMENT AS A REFERENCE TOOL ONLY NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT IN FACT THE MANUFACTURER AND OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO Record Serial Number Here Note If product has no serial number record month and year of purchase instead Note Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts GREENWOOD Item 61368 For technical questions please call 1 800 444 3353 Page 9 Parts List and Diagram Parts List Description Q Pump Handie cip Descr
9. wear eye protection common sense when operating the Sprayer Wear ANSI approved safety goggles Do not use the Sprayer while tired or under the influence of drugs alcohol or medication A moment of inattention while operating the Sprayer may result in serious personal injury Page 2 For technical questions please call 1 800 444 3353 Item 61368 Use 1 Use only for water or water based fertilizers herbicides pesticides and sealers Do not use to spray combustible or corrosive chemicals 2 Do not point the Sprayer at yourself other people or animals 3 Industrial applications must follow OSHA requirements 4 Make sure the liquid used in the Sprayer is not dirty or sandy 5 This product is not a toy Do not allow children to play with or near this item Service 1 Have your Sprayer serviced by a qualified repair person using only identical replacement parts This will ensure that the safety of the tool is maintained Use as intended only Inspect before every use do not use if parts are loose or damaged Maintain product labels and nameplates These carry important safety information If unreadable or missing contact Harbor Freight Tools for a replacement The warnings and cautions discussed in this manual cannot cover all possible conditions and situations that may occur The operator must understand that common sense and caution are factors that cannot be built into this product but must be supplied
10. zle 55 c Sprinkler Nozzle 56 3 Slide Nozzle over end of Wand slide Hose Nut over threads of Nozzle then tighten Hose Nut securely Double Fan Sprinkler Nozzle Nozzle Nozzle Figure C Pump Handle Orientation To change the side that the Pump Handle is on 1 Pass the end of the Strap through the back of the Buckle then around the bar until it is free See Figure D 2 Route the Strap to the other side of the Tank then reattach the Strap 3 Do this to both Straps Figure D Item 61368 For technical questions please call 1 800 444 3353 Page 5 Operating Instructions A WARNING Follow all guidelines regarding chemicals sprayed including MSDS instructions and EPA regulations CAUTION If the amount of weight you can lift safely is limited do not fill the Tank completely to prevent strain and injury 1 Remove Tank Lid and fill Tank through a strainer sold separately no higher than top fill line Replace Tank Lid 2 Disengage the Pump Handle from the Pump Handle Lock Pump Handle Lock Pump Handle Figure E 3 Strap the Sprayer to your back 4 Raise and lower the Pump handle to build up sufficient pressure 5 Adjust Shoulder straps as needed 6 Point the Nozzle toward the area to be sprayed then depress the Trigger to begin spraying Page 6 For technical questions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including
Download Pdf Manuals
Related Search