FIELD CONTROLS z100 User's Manual
Contents
1. hold the baffle plate to the tank Lift the baffle slightly back to clear the water probe and then straight up and out of the tank You can then see the round Z100 or rather what is left of it after a single season Notice the heavy scale build up on the Z100 that would have been on your element if the Z100 was not there Use a rag or pliers to grasp the edges of the Z100 and simply unscrew it from the baffle plate Rinse off or wipe away any residual scale from the baffle plate and install a new Z100 Leave a slight gap between the bottom of the Z100 and the baffle plate Now re insert the baffle plate into the tank and secure with the two screws that were removed previously It s that simple The Z100 can also benefit the older model steam humidifiers Simply lay the Z100 down into the baffle plate in the same location as the factory installed model DO NOT lay the Z100 down into the main tank It may come in contact with the heating element and damage it The dimensions of the baffle plate prevent the Z100 from falling down into the tank P N 090376A0131 REV C 10 2011 Copyright 2011 Field Controls Inc All Rights Reserved Field Controls Inc 2630 Airport Road Kinston NC 28504 PH 252 522 3031 FAX 252 522 02142. APPLICATION NOUE AN 131 INSTALLATION INSTRUCTIONS amp OWNER S MANUAL FIELDCONTROLS Z100REPLACEMENT INSTRUCTIONS SUPPLEMENT TO THE ELECTRONIC STEAM Z100 ASSEMBLY POWER HUMIDIFIERS MODEL S2000 AND S2020 The Field Controls Steam Humidifier now comes equipped with a factory installed Z100 which acts as a sacrificial metal Put simply minerals in the water will attack and cling to the Z100 The minerals will not attack the other components inside the humidifier as long as the Z100 is present and active This results in a dramatic decrease in mineral and scale build up on the critical components inside the tank In particular it means less scale build up on the heating element which is subject to damage from excessive scaling and over heating This also means that efficiency stays high and preventive maintenance is faster and easier The Z100 is positioned on the baffle plate inside the tank and is easily removed and replaced Remember that the Z100 s job is to become the target of mineral attack so it will be heavily covered with scale and should be replaced annually for best results To remove the Z100 you must have already unplugged and shutdown your steam humidifier and allowed it to cool The water tank has been drained the water supply drain lines and electrical wiring have been disconnected and the unit has been removed from the duct Refer to the blow up view on Page 11 Using a phillips screwdriver remove the two screws that
Download Pdf Manuals
Related Search