Code Alarm HQ7415 User's Manual
Contents
1. CODE ALARM Model caTx510 Our Code h Ewan Programming Guide The keychain transmitters included with the system have been pre programmed at the factory with each button pre assigned to control a specific function of the system The system will store codes from up to 4 different transmitters If a 5 transmitter is programmed to the system then the first transmitter programmed to the system will be erased from the system s memory To program new or additional transmitters 1 Enter the vehicle and turn the ignition switch to the ON position 2 Press and release the programming button switch 3 times 3 The dash mounted LED will flash 1 time and the parking lights will flash 1 time indicating that the system is ready to accept programming of channel 1 which is LOCK 4 Press and hold the lock icon button of the transmitter you wish to program for 4 seconds or until a long flash from the parking lights 4a Repeat step 4 for any additional transmitter you wish to program 5 Press and release the programming button switch 1 time to advance to channel 2 The parking lights will flash 2 times and the dash mounted LED will flash 2 times indicating that the system is ready to accept programming for channel 2 which is UNLOCK 6 Press and hold the unlock icon button of the transmitter you wish to program for 4 seconds or until a long flash from the parking lights 6a Repeat step 6 for any additional transmitter you wish to progr2. am 7 Press and release the programming button switch 1 time to advance to channel 3 The parking lights will flash 3 times and the dash mounted LED will flash 3 times indicating that the system is ready to accept programming for channel 3 which is REMOTE START 8 Press and hold both buttons simultaneously of the transmitter you wish to program for 4 seconds or until a long flash from the parking lights 8a Repeat step 8 for any additional transmitter you wish to program CODE ALARM Model caTxs10 Our Code Emane Programming Guide Changing the Remote Control Battery The 12 volt alkaline battery supplied in your remote transmitter should last approximately one year depending on usage When the battery begins to weaken you will notice a decrease in range or the distance from your vehicle that your remote transmitter will operate Follow the instructions below to change the remote transmitter battery 1 Insert the edge of a coin into the slot at the side of the remote control Twist the coin to pry the remote control halves apart 2 Remove the old battery and replace with a new one Be sure to observe the and signs in the battery compartment 3 Carefully snap the case halves back together then test the remote control Battery h For Customer Service and Product information Call 1 800 421 3209
Download Pdf Manuals
Related Search