Infocus Remote Control
Contents
1. InFocus Remote Control Overlay Modes for HW NAVIGATOR 3 HW DIRECTOR 2 and HW COMMANDER 2 This document describes how to make your InFocus remote control produce NOTE Information in this document applies to the following commands that may not be directly available as buttons on the remote InFocus remote control models These commands are intended to be used by 3 party learning remotes that can learn codes from other remotes For example by using these modes you could program a 3 party remote to produce a discrete power on command as part of a macro used to turn on all of your A V devices and then produce a discrete power off command as part of another macro that turns off all of your A V devices ol Sfo Sfo Your remote supports three different modes for producing additional a commands Each mode reconfigures the buttons on the remote to produce a different set of commands refer to the table below to find out which commands EDE and modes you ll need volume custom source miea oman aa Alixi ea ir a Example To make your remote produce the 16 9 Aspect Ratio command X 1 3 1 Look up 16 9 Aspect Ratio in the table below it is produced when you press the Auto Image button while the remote is in mode 3 InFocus InFocus 2 Enter mode 3 by holding down the Presets button on your remote for 10 seconds HW NAVIGATOR 3 HW DIRECTOR 2 HW COMMANDER 2 3 Press the Auto Im2. age button on your remote to produce the 16 9 Aspect Ratio command 4 Exit mode 3 and return to normal remote operation by holding down the Presets button on your remote for 10 seconds or wait 2 minutes for the remote to automatically exit the mode Overlay Mode Table 1 Enter the mode by holding down a button on your remote To enter mode 1 To enter mode 2 To enter mode 3 Hold down the Custom button on the Hold down the Auto Image button on the Hold down the Presets button on the remote remote for 10 seconds if the remote has a remote for 10 seconds if the remote has a for 10 seconds if the remote has a backlight backlight the backlight will show one long backlight the backlight will show one long the backlight will show one long blink followed blink followed by one short blink blink followed by two short blinks by three short blinks After you have entered a mode press buttons on your remote to produce the following commands the remote will stay in the mode you selected until you exit the mode see step 3 below to produce this command in mode 1 to produce this command in mode 2 Press this to produce this command in mode 3 remote button Native Aspect Ratio When you re done exit the mode and return to normal remote operation by holding down a button on your remote or wait 2 minutes 3 to go directly from one mode to another you can skip this step and j
3. ust hold down Custom Auto Image or Presets for 10 seconds to enter a different mode Hold down the Custom key button the Hold down the Auto Image button on the Hold down the Presets button on the remote remote for 10 seconds again or do not use remote for 10 seconds again or do not use for 10 seconds again or do not use the remote the remote for 2 minutes if the remote has the remote for 2 minutes if the remote hasa for 2 minutes if the remote has a backlight a backlight the backlight will show one long backlight the backlight will show one long the backlight will show one long blink blink blink Some commands are not supported by some projector models For details on supported commands please refer to your projector s documentation or go to www infocus com support to download documentation
Download Pdf Manuals
Related Search