Chief KONTOUR
Contents
1. Install display to Kontour arm using quick connect faceplate KRA208 Kc CHIEF Our Mounts Your Vision Chief Manufacturing a products division of Milestone AV Technologies 8800 002191 Rev00 2012 Milestone AV Technologies a Duchossois Group Company www chiefmfg com 07 12 USA International Europe Asia Pacific pDpmu mu Tl U Installation Instructions 6436 City West Parkway Eden Prairie MN 55344 800 582 6480 952 225 6000 877 894 6918 952 894 6918 Franklinstraat 14 6003 DK Weert Netherlands 31 0 495 580 852 31 0 495 580 845 Office No 1 on 12 F Shatin Galleria 18 24 Shan Mei Street Fotan Shatin Hong Kong 852 2145 4099 852 2145 44772. serious personal injury or damage to equipment It is the installer s responsibility to make sure the combined weight of all components located between the K1D100 200 Monitor Arm up to and including the display does not exceed 20 lbs 9 07 kg per arm when using the KRA208 extension arm Use with products heavier than the maximum weight indicated may result in collapse of the mount and its accessories causing possible injury 2 Disassemble mounting arm of Kontour mount by unscrewing button head cap screw and removing three assembled washers See Figure 1 3 Remove arm from pin by lifting arm off of pin See Figure 1 Set arm and removed hardware aside for reuse K1D100 shown 4 Use 5 16 18 x 1 button head cap screw F two steel washers C plastic washer H and 5 16 washer G to secure KRA208 arm A to pin on base of Kontour mount Follow the exact order shown in Figure 2 See Figure 2 5 Place chrome ring D and pivot ring E on outer hole of extension arm A See Figure 2 KRA208 E 1 C 2 B 1 steel washer chrome ring pivot ring pivot pin J 1 1 4 20 X 3 4 6 Use 1 4 20 x 3 4 set screw J to secure pivot pin B to extension arm A See Figure 2 K1D100 shown Figure 2 7 Use hardware removed in Step 2 to attach removed arm B See Figure 3 removed K1D100 shown VIN washers removed Kontour arm Figure 3 8
3. INSTRUCTIONS INSTALLATION Kontour Extension Arm KRA208 CHIEF Our Mounts Your Vision KRA208 DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document Chief and Kontour are registered trademarks of Milestone AV Technologies All rights reserved A IMPORTANT SAFETY INSTRUCTIONS WARNING A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions CAUTION A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions WARNING Failure to read thoroughly understand and follow all instructions can result in serious personal injury damage to equipment or voiding of factory warranty It is the Installer s responsibility to make su
4. re all components are properly assembled and installed using the instructions provided DIMENSIONS Installation Instructions WARNING Use this mounting system only for its intended use as described in these instructions Do not use attachments not recommended by the manufacturer WARNING Never operate this mounting system if it is damaged Return the mounting system to a service center for examination and repair WARNING Exceeding the weight capacity can result in serious personal injury or damage to equipment It is the installer s responsibility to make sure the combined weight of all components located between the K1D100 200 Monitor Arm up to and including the display does not exceed 20 Ibs 9 07 kg per arm when using the KRA208 extension arm Use with products heavier than the maximum weight indicated may result in collapse of the mount and its accessories causing possible injury IMPORTANT The KRA208 extension arm is only designed to be attached to the K1D100 and K1D200 Kontour arms Do NOT attach the KRA208 to any other mounting arm WARNING Do not use this product outdoors SAVE THESE INSTRUCTIONS Installation Instructions TOOLS PARTS FOR INSTALLATION KRA208 arm 3 16 included 1 8 included F 1 5 16 18 x 1 ASSEMBLY AND INSTALLATION 1 If already installed remove display from Kontour arm using quick connect faceplate WARNING Exceeding the weight capacity can result in
Download Pdf Manuals
Related Search