Chief Large FUSION
Contents
1. EQUIPMENT DO NOT over tighten screws when installing interface brackets NOTE Properly sized screws will easily and completely thread into display mounting holes If spacers are required be sure to use longer screws of the same diameter 2 Figure 2 Continue installation following the instructions included with the Chief is a registered trademark of Milestone AV Technologies All rights reserved mount Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document F Chief Manufacturing a products division of 8800 002010 Rev00 rN f E Milestone AV Technologies 2009 Milestone AV Technologies RA 8401 Eagle Creek Parkway Savage MN 55378 a Duchossois Group Company P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 www chiefmfg com Our Mounts Your Visi2. INSTALLATION INSTRUCTIONS FHB 3029 FHB 5029 FHB 7029 The FHB hardware kits are designed for use with Chief Series NOTE The provided fasteners should be used with the universal Mounts See the specific installation instructions provided with the washer A as noted See Figure 1 mount for additional installation information ae s aa Universal Unpack and verify kit contents If any listed parts are missing Washer a immediately contact a Chief Customer Service representative a Za a WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer Qty Description 4 Universal Washer 4 Screw Phillips Pan Head M5 x 10mm A B Cc 4 Screw Phillips Pan Head M6 x 10mm A M4 not included D 4 Screw Phillips Pan Head M6 x 20mm Figure 1 1 Attach interface brackets to back of display using the provided hardware and noting where the centerline of display should be located against the interface bracket See Figure 2 N A 4 B 4 9 Universal M5 x 10mm 3 Washer 3 E SS o j D ass a G S C 4 D 4 f M6 x 10mm Mex eomm Centerline of Display WARNING OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO
3. on 06 09
Download Pdf Manuals
Related Search