Lenco TS-10
Contents
1. IN 2 3 VOLUME Increase or decrease the volume level Connections Connect to TV Connect Power This unit is very user friendly please just Caution connect it directly to TV s headphone Risk of product damage jack as below Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the unit HEADPHONE S 1 Connect the LINE IN cable to LINE IN socket on the unit Connect the AC power cord to HEADPHONE socket on TV the AC socket on this unit 2 Unit turn on automatically Press the wall socket the G4 SOURCE button to select source Turn On Off 3 Turn on your TV When you connect TV or an Tip external device to the unit unit will You can simply use your TV s turn on automatically Auto Power inherent Remote Control set to indication light is green connect control Vol Vol to LINE IN 1 or yellow connect to LINE IN 2 And will turn red when disconnected or when you turn off If the volume of TV or an external device is too low the unit also turn off automatically Adjust Volume Level During play press the VOLUME buttons to increase decrease the volume level If the unit is connected to the TV s headphne jack you can also control the Volume Level by using the TV s remote control set directly Troubleshooting Specifications To keep the warranty valid never try to repair the system yourself If2. Lenco TS 10 Speaker System Instruction Manual CEN For information and support www lenco eu What s in the Box of Main Unit Instruction Manual 3 5mm to 3 5mm Cable AC Power Cable For TV Headphone Output Design and specifications are subject to change without notice Important Safety Instructions Safety aAKRWDN Oo Read these instructions Keep these instructions Heed all warnings Follow all instructions Do not use this apparatus near water Clean only with dry cloth Do not block any ventilation openings Install in accordance with the manufacturer s instructions Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat Protect the power cord from being walked on or pinched particularly at plugs convenience receptacles and the point where they exit from the apparatus 10 Unplug this apparatus during lightning storms or when unused for long periods of time 11 Refer all servicing to qualified service personnel Servicing is required when the apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled or objects have fallen into the apparatus the apparatus has been exposed to rain or moisture does not operate normally or has been dropped 12 Unit shall not be exposed to dripping or splashing 13Do not place any sources o
3. f danger on the apparatus e g liquid filled objects lighted candle 14The mains plug is used as the disconnect device the disconnect device shall remain readily operable Warning 1 Before operating this system check the voltage of this system to see if it is identical with the voltage of your local power supply Do not place this unit close to strong magnetic field If the system is brought directly from a cold to a warm location or is placed in a very damp room moisture may condense on the lens inside the player Should this occur the system will not operate properly Leave the system turned on for about an hour until the moisture evaporates Should any solid object or liquid fall into the system unplug the system and have it checked by qualified personnel before operating it any further Do not attempt to clean the unit with chemical solvents as this might damage the finish Use a clean dry or slightly damp cloth When removing the power plug from the wall outlet always pull directly on the plug never yank on the cord Identifying the Parts Main Unit Top View Rear View 4 LINEIN Terminal Connect to an external audio device 1 G SOURCE 5 AC Select LINE IN 1 or LINE IN 2 Connect to a power source 2 AUTO POWER Light Indicate mode of auto power Red light Standby mode Green light play through LINE IN 1 Yellow light play through LINE
4. you encounter problems when using this unit check the following points before requesting service No power Ensure that the AC cord of the apparatus is connected properly Ensure that there is power at the AC outlet Press standby button to turn the unit on No Response From the Unit Disconnect and reconnect the AC power plug then turn on the unit again General Power Requirements AC 230V 50Hz Power CONSUMPTION eseeeeeeeees 6 5W Output POWET 00 7 5W x 2 15W Total Harmonic Distortion ceee RIAA EAE AEAT EATA TET 1 1kHz 1W Audio Input Sensitivity Impedance INES ioanen 500MV 47kO Frequency RESPONSE ii ssscecedessiseresecssaee E AREKE Eri Rai 40Hz 20kHz 0 3cB Unit Dimensions W x H XD eee E E E E E A 584 x 50 x 218mm Speaker Front MpPEdANC Ennon 30 Rate POWE cccececeeeeeesesesteneeeeeeees 10W Subwoofer IMpeEdANGE siirre 60 RONG POWER cccsceiccscsiaoes seudsesceeredeeees 30W a If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste Please recycle where facilities exise Check with your Local Authority or retailer for recycling advise Waste Electrical and Electronic Equipment Directive
Download Pdf Manuals
Related Search