Panasonic VL-GC001A-N Doorphone/Camera (Gold) (VLGC001AN)
Contents
1. Servicing is required when the apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled or objects have fallen into the apparatus the apparatus has been exposed to rain or moisture does not operate normally or has been dropped SAVE THESE INSTRUCTIONS Important Information Additional safety information 1 SOV ON 10 11 12 13 14 15 16 17 Use only the power source marked on the unit If you are not sure of the type of power supplied to your home consult your dealer or local power company Use only the specified AC adaptor Do not tamper with the plug Make sure the plug is securely inserted Do not touch the plug with wet hands Do not place objects on the power cord Install the unit where no one can step or trip on the cord To reduce the risk of electric shock do not disassemble this unit Take the unit to an authorized service center when service is required Opening or removing covers may expose you to dangerous voltages or other risks Incorrect reassembly can cause electric shock when the unit is subsequently used Unplug the monitor station from power outlets and refer servicing to an authorized service center when the following conditions occur A If smoke rises or an unaccustomed noise or smell is discharged from the unit B If metal objects have been dropped inside the monitor station Do not put your ear s near the speaker as loud2. the monitor station Microphone Call Button e The Call Button is lit with a blue LED light while the power is on O A visitor can press this button to call the monitor station Speaker Water drain hole e This hole allows rain water to drain Do not cover it Camera angle control lever e The camera angle can be adjusted when installing the door station page 7 10 Introduction and Installation Before installation To avoid malfunction or communication disturbances do not install the door station in the following locations Places where vibration or any other kind of impact occurs Places where echoing is frequent Places where a high concentration of dust hydrogen sulfide phosphorus ammonia sulfur carbon acid or noxious fumes occur Within 2 m 6 7 of a TV microwave personal computer air conditioner or any other electrical device Standard installation position of the door station and camera range Upper lower range Left right range e Side view of when the camera is facing the Top view of when the camera is facing the front at 0 front at 0 Image range 580 mm 2213 16 Center of the door station Image range 425 mm 16 4 Lo a gt ee Ll RU 191 16 O 1450 mm 571 16 e Top view of when the camera is facing the left at 15 Image range 650 mm 259 16 e Top view of when the camera is facing the right at 15 Image range 6
3. 50 mm 259 16 Introduction and Installation Note e The measurements and angles are for reference purposes and may vary depending on the environment e f a strong light is shining on the door station the visitor s face may not be distinguishable Do not place the door station in the following locations Where most of the background is the sky Where the background is a white wall and direct sunlight will reflect off it Where direct sunlight will shine on the door station Where echoing occurs causing the unit to beep frequently O Make sure the back of the door station is not subject to water Wire type and distance e Wire between the monitor station and the door station Type General cable CAT 3 24 AWG Distance Maximum 100 m about 328 feet Introduction and Installation Installing the door station Make sure to install the door station on a flat vertical wall Important information On the bottom surface of the door station there is a hole to allow water to drain Do not cover it up when installing 1 Unscrew the hex head screw using the longer end of the allen wrench and remove the mounting bracket from the rear of the door station e The pin hole camera is not a screw to be touched or removed Mounting bracket Pin hole camera Hex head screw Attached to the door station Allen wrench Introduction and Installation 2 Attach the mounting bracket to the wall us
4. Panasonic Door Station Installation and Operation Guide Model No VL GC001 A Thank you for purchasing a Panasonic Door Station Please read this Installation and Operation Guide before using the unit and save for future reference PFQX2165ZA DC0405NKO Table of Contents Important Information Important safety INSWuClONS isc a a ad 3 Additional safety information o ooooooocooronr tenet eens 4 FOr DeStpenOrnnanCe ws 24 4 ws Ce ois tas ied woe Meh Vos ete Sa ceed ets 4 Introduction and Installation Hended ems int Bie sires Beal ceo Bee A te Bohl Sle Sb whe oe ae A 5 LOCATION OMCONUOIS 23 15 04 ba pees kt hee Bead e ta 6 Beore IMStallatlO a rice heh oat el are ee ek ee eh ee en a ee Bard he dele ea te 7 Installing the ADORStatOM ssn 6 rl ene hake a dl o RE Sea de al ira JA 9 Help CIlCANING 221 a A A A ii 13 General Information Technical data about this product o ooooooooon ee ee ee 14 FCCand Other MOMO oc howe ee Ad eee Gee be 15 Important Information CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrow head within a triangle is The exclamation point within a triangle is intended to tell the intended to tell the user that user that important operating parts inside the product are a and servicing instructions are in risk of electric shock to persons the papers with the appliance Important safety instructions 9 Read these instruct
5. c Communications Co Ltd and may be reproduced for internal use only All other reproduction in whole or in part is prohibited without the written consent of Panasonic Communications Co Ltd 2005 Panasonic Communications Co Ltd All Rights Reserved
6. imits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the monitor station off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help 15 For your future reference Date of purchase Serial number found on the rear of the unit Dealer s name and address Dealer s telephone number Attach your sales receipt here Panasonic Consumer Electronics Company Division of Panasonic Corporation of North America One Panasonic Way Secaucus New Jersey 07094 U S A Panasonic Puerto Rico Inc San Gabriel Industrial Park Ave 65 de Infanter a Km 9 5 Carolina Puerto Rico 00985 U S A Copyright e This material is copyrighted by Panasoni
7. ing the wood screws 3 8 mm x 20 mm 1 8 x 13 16 e Before drilling see page 7 for installation location Mounting bracket Wood screws Wall 3 Connect the wires that connect to the monitor station to the terminal connector by unscrewing the screws pushing in the wires then tightly fastening the screws O See page 8 for the wire type and distance e You can change the camera angle using the camera angle control lever See page 7 for details Terminal connector Non polar Screw Wire Not included 10 Introduction and Installation e f you want to connect the wires without them going through a hole in the wall behind the mounting bracket connect the wires by passing them through the ribs and the wire hole Wire hole Push the door station down until it is secure 11 Introduction and Installation 5 Insert the hex head screw using the longer end of the allen wrench Hex head screw Allen wrench 6 Attach the bolt cover using the shorter end of the allen wrench e Use protrusion on the shorter end of the allen wrench to rotate the bolt cover until it is secure Allen wrench 12 Help Cleaning Clean the unit with a soft dry cloth when cleaning For excessive dirt wipe the unit with a slightly damp cloth Important information e Do not use anything containing alcohol polish powder powder soap benzine thinner wax petroleum or boiling water Also do not spray wi
8. ions All the safety and operating instructions should be read before the appliance is operated Keep these instructions The safety and operating instructions should be retained for future reference Heed all warnings All warnings on the appliance and in the operating instructions should be adhered to Follow all instructions All operating and use instructions should be followed Do not use this apparatus near water For example near a bathtub wash bowl kitchen sink or laundry tub in a wet basement or near a swimming pool and the like Clean only with dry cloth Do not use liquid cleaners or aerosol cleaners Use a dry cloth for cleaning Do not block any ventilation openings Install in accordance with the manufacturer s instructions Slots and Openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating The openings should never be blocked by placing the product on a bed sofa rug or other similar surface Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat This product should not be placed in a built in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer s instructions have been adhered to Only use attachments accessories specified by the manufacturer 10 Refer all servicing to qualified service personnel
9. sounds emitted from the speaker may cause hearing impairment Only a qualified technician is allowed to connect a power cable to the unit Contact an authorized service center Do not make any wiring connections when the power supply is turned on Never install wiring during a lightning storm When existing chime wires are used it is possible that they contain AC voltage Electric shock or unit damage could result Contact an authorized service center Be sure to install the unit as specified to endure the mass If the wiring is outdoors use a protection tube or a surge protector If the wiring is underground do not make any connections underground WARNING Unplug the monitor station from power outlets if it emits smoke an abnormal smell or makes unusual noise These conditions can cause fire or electric shock Confirm that smoke has stopped and contact an authorized service center For best performance O f a power failure occurs the unit will not function Introduction and Installation Included items borson hooo O Mounting bracket Attached to rear of the door station Wood screws 2 For the door station 3 8 mm x 20 mm 1 8 x13 16 Botcovers je oers o Introduction and Installation Location of controls Front view Rear view lin i J 4 de Camera e When a visitor presses the Call Button the camera will turn on and an image of the visitor will be shown on the display of
10. th insecticide glass cleaner or hair spray This could cause a change in color or quality 13 General Information Technical data about this product Power supply Standby Approximately 5 V DC 2 mA At operation Approximately 20 V DC 180 mA Dimensions Approximately height 165 mm x width 90 mm x depth 35 mm 61 2 x 39 16 x 19 8 Mass Weight Approximately 330 g 0 72 Ib Operating environment 10 C to 50 C 14 F 122 F Up to 90 RH Relative Humidity non condensing Installation method Wall mount Wall mount bracket included External material Aluminum 1 Supplied from the monitor station Note e Design and specifications are subject to change without notice e The pictures and illustrations in these instructions may vary slightly from the actual product 14 General Information FCC and Other Information This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference 2 This device must accept any interference received including interference that may cause undesired operation CAUTION Any changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this device NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These l
Download Pdf Manuals
Related Search