Auto Page EXP-52 Automobile Alarm User Manual
Contents
1. Your vehicle must be equipped with power door locks and optional relays may be required Additionally all doors will lock automatically each time the ignition key is turned on and unlock each time the ignition key is turned off Please see Section H 2 TEMPORARY CHIRP DELETE FROM REMOTE Upon approaching the vehicle whether armed or disarmed push the AUX button on the remote control transmitter for half 0 5 second then very quickly push the ON OFF button on the transmitter to arm or disarm in the usual manner The chirp sound will be silenced only for this particular operation The sequence must be repeated each time if it is desired to cancel the arm disarm chirp sound 4 EXP 52 3 PANIC FUNCTION The EXP 52 remote control may be used as a remote panic switch to trigger the siren in cases of emergency To activate the PANIC FUNCTION press and hold the ON OFF button on the remote transmitter for a minimum of 3 seconds The siren will sound To stop the PANIC FUNCTION press the ON OFF button on the transmitter 4 DELETING THE PRE WARNING SENSOR CIRCUIT If installed The EXP 52 offers the dual stage SIS 5 impact sensor to pre warn a light impact on the vehicle with a siren chirp before triggering the alarm The alarm will trigger with the third violation within 15 seconds The EXP 52 also provides a pre warning sensor input for an additional sensor like a radar sensor to pre warn approach to the vehicle To delete the2. F PASSIVE MANUAL ARMING OPERATION Optional at installation Passive Manual operations can be selectable if an optional toggle switch is installed Consult your installing dealer 1 PASSIVE ARMING If you choose the PASSIVE automatic mode the system must be operated as below 1 Switch OFF vehicle ignition exit vehicle and be sure all protected openings are closed R EXP 52 2 The LED STATUS INDICATOR will begin fast flashing and the passive arming timer will begin counting down 3 If you re open the exit the LED will stop flashing 4 Close the exit and the LED will start flashing again 5 The EXP 52 will count down for 30 seconds After 30 seconds the siren will chirp 1 time indicating the EXP 52 has armed NOTE If the optional remote power door locks feature is installed the doors will automatically lock 10 seconds after the PASSIVE arming cycle is completed 2 MANUAL ARMING If you choose the MANUAL active arming mode follow the steps below 1 Switch off ignition leave vehicle and close all protected openings 2 Press the ON OFF button on the remote transmitter 3 The siren will chirp 1 time 5 seconds later the EXP 52 will be fully armed G AUTOMATIC RE ARMING The EXP 52 is equipped with an automatic re arming circuit that will return the alarm to a fully armed state if a door is notopened within 60 seconds after disarming This automatic re arming circuit can be eliminated at the time
3. absence Press the ON OFF button on the remote transmitter If a breach has occurred the siren will signal with 4 chirps the lights will flash four times and the LED will be flashing in a 2 second flash hold sequence E VALET OVERRIDE SWITCH NOTE Both VALET and OVERRIDE functions are performed from the same switch 1 OVERRIDE FUNCTION The OVERRIDE FUNCTION may be used if the EXP 52 remote is lost or inoperative To operate the OVERRIDE FUNCTION enter the vehicle 4 EXP 52 siren will sound switch the vehicle ignition to ON Move the VALET OVERRIDE switch to ON then OFF the siren will stop The EXP 52 will be disarmed Quickly replace or service the remote transmitter to insure continued vehicle protection 2 VALET FUNCTION The EXP 52 may be placed into the VALET stand by mode to allow for vehicle service car washing or attendant parking without self arming after the ignition is switched off and without leaving the EXP 52 remote control with unauthorized individuals To operate the VALET FUNCTION turn the vehicle ignition to ON and move the VALET OVERRIDE SWITCH to ON To return to normal operation turn the vehicle ignition to ON and move the VALET OVERRIDE SWITCH to OFF 3 KEYLESS ENTRY MODE In the valet mode the vehicle doors can be locked and unlocked using the remote However there will be no chirp confirmation it is strongly recommended that the driver visually confirm that the doors are locked
4. feature If any transmitter is lost or stolen enter the programming mode and re program existing transmitters Transmitters can only be programmed by entering the programming mode Existing codes will remain in memory even if power to the EXP 52 is disconnected To program the EXP 52 transmitters follow the directions as written below in their exact order EXP 52 K Flip the VALET OVERRIDE switch to ON position Turn the ignition switch to ON then OFF then immediately Flip the VALET OVERRIDE switch OFF ON OFF ON OFF The siren will chirp one 1 time Turn the ignition switch ON OFF ON OFF The siren will chirp two 2 times You are now in the programming mode Press the ON OFF button on one of the remote transmitters until the alarm siren responds with a confirming chirp The first transmitter is now programmed Within five 5 seconds press the ON OFF button on the second transmitter until the alarm siren responds with a confirming chirp The second transmitter is now programmed NOTE f the EXP 52 does not receive a second code to learn within five 5 seconds it will automatically close the programming mode and resume normal alarm functions lf this happens it will be necessary to repeat steps 1 through 6 and re program all transmitters If three or four transmitters are programmed continue pressing the ON OFF button of the third and or fourth transmitters The EXP 52 can learn up to four re
5. of installation H IGNITION CONTROL POWER DOOR LOCK SYSTEM When installed with remote power door locks the vehicle s doors will automatically lock when the ignition is switched on The doors will automatically unlock when the ignition is switched off In order to avoid any undesirable lock out the doors will notlock if any door is left open R EXP 52 This feature is optional at time of installation l TRIGGER TEST After arming the EXP 52 in either the PASSIVE or MANUAL mode test the system in the following manner 1 Open any door or other protected opening The siren will sound instantly and the lights will flash 2 Ifthe pre warning feature is activated the EXP 52 s SIS 5 impact sensor will respond to a light shock with a chirp sound and trigger the alarm when a heavier shock is detected Please refer to A 4 for details 3 If optional sensors have been installed arm the EXP 52 and test according to the directions of the particular sensor installed If triggered in the armed condition the EXP 52 will sound its siren and flash the lights for 60 seconds then it will stop and automatically reset and rearm If the violation continues the alarm will sound and lights will flash for two 60 second cycles J PROGRAMMING THE REMOTE TRANSMITTERS NOTE Each time the programming mode is entered all programmed transmitter codes will be automatically deleted and must be re programmed This is an important security
6. pre warning sensor press the ON OFF button again within 5 seconds after arming The siren will confirm deletion with a low chirp NOTE Deleted sensor s will return to normal operation upon disarming the EXP 52 Sensor s deletion procedure must be followed each time the EXP 52 is armed This operation deletes only the pre warning sensor of the alarm NOTE This pre warning feature is set inactive by the factory and must be activated at the time of installation if this feature is desired 5 TRUNK HATCH RELEASE To remotely release the electric trunk or hatch on the vehicle you must first disarm the EXP 52 After disarming push the AUX button on the transmitter for THREE 3 seconds Trunk or hatch will release and open NOTE The alarm will not control mechanical latch trunk release mechanisms EXP 52 6 OPTIONAL ACCESSORY OPERATION Simultaneously pressing both the ON OFF and AUX buttons will allow third channel operation A negative pulse begins and will continue until buttons are released It is not recommended to press the buttons longer than 3 seconds 7 SECOND CAR OPERATION Refer to SECTION K of this operation manual Arming and disarming will be determined by how the transmitters have been programmed for multiple vehicle operation 8 CHANGING THE REMOTE TRANSMITTER BATTERY The EXP 52 remote transmitter uses one 1 12 volt miniature battery EL12 VR22 or Radio Shack 23 144 It will provide approxima
7. APL EXP 52 OPERATION INSTRUCTIONS THE BEST SECURITY SPEAKS FOR ITSELF THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY Congratulations on your purchase of the EXP 52 vehicle security system Please take the time to read over this operation manual to thoroughly familiarize yourself with the many features and options THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY IINOTICE THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS 1 THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND 2 THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION FEDERAL COMMUNICATION COMMISSION RULES AND REGULATIONS PROHIBIT THE ADJUSTMENT OF THE TRANSMITTER PORTION OF THIS SYSTEM BY UNLICENSED PERSONNEL EXP 52 EXP 52 OPERATION INSTRUCTIONS A REMOTE CONTROL TRANSMITTER OPERATION The new remote control transmitter XT 54 included with the EXP 52 offers the code rolling feature which will prevent illegal use of a code grabber with an attempt to record the code of your transmitter 1 ARM DISARM TO ARM THE EXP 52 ol O Press the ON OFF button once to arm The siren will chirp one 1 time the lights will flash and all doors will lock TO DISARM THE EXP 52 Press the ON OFF button once to disarm The siren will chirp two 2 times the lights will flash and all doors will unlock NOTE
8. mote transmitter codes If later optional third and forth transmitters are to be programmed follow sequence 1 through 6 and re program all existing transmitters PROGRAMMING REMOTE FOR A SECOND VEHICLE The EXP 52 transmitters are capable of controlling separately installed EXP 52 or RF 302 alarm systems in two or three vehicles EXP 52 To code the EXP 52 transmitters for two or three vehicles follow the diagrams as shown below Before multiple vehicle programming can be achieved it is necessary to enter the programming mode as described in SECTION K 1 TWO VEHICLE OPERATION VEHICLE 1 Enter the programming mode on vehicle 1 and push the ON OFF button on the transmitter for Vehicle 1 The alarm siren will respond with a confirming chirp Within five 5 seconds push the AUX button on the transmitter for Vehicle 2 The alarm siren will respond with a confirming chirp Both transmitters are now programmed to Vehicle 1 VEHICLE 2 Enter the programming mode on Vehicle 2 and push the AUX button on the first transmitter used for Vehicle 1 The alarm siren will respond with a confirming chirp Within five 5 seconds push the ON OFF button on the second transmitter that had been previously programmed on Vehicle 1 The alarm siren will respond with a confirming chirp Both transmitters are now programmed to Vehicle 2 NOTE Here the first transmitter is assumed to be the primary transmitter of Vehicle 1 and the second t
9. ransmitter is assumed to be the primary transmitter of Vehicle 2 vemerem VEHICLE 2 TRANSMITTER 1 ON OFF BUTTON AUX BUTTON TRANSMITTER 2 AUX BUTTON ON OFF BUTTON A P I
10. tely one year of operation before replacement is necessary To replace the battery carefully remove the case screw located at the end of the remote where the key ring attaches to the case Use a small blade Phillips screwdriver Before removing the battery note the direction of its terminals Install the new battery exactly the same using caution so as not to bend or otherwise damage the battery contacts Replace the case cover and carefully tighten the screw Do not over tighten the screw Test the transmitter to insure it arms and disarms the alarm EXP 52 B LED STATUS INDICATOR OPERATION LED OFF The EXP 52 is disarmed LED CONSTANT ON Indicates open trigger circuit LED FAST FLASHING Passive arming timer is counting down LED FLASHING The EXP 52 is armed LED FLASHING IN A 2 FLASH HOLD SEQUENCE Alarm breach akWON NOTE Unless a door is opened after disarming the EXP 52 will automatically rearm in 60 seconds and the LED will continue to flash See Section G AUTOMATIC RE ARMING for details C AUDIBLE AND VISUAL ALARM STATUS INDICATOR 1 1 CHIRP WITH LIGHT FLASH Alarm is armed 2 2 CHIRPS WITH LIGHT FLASH Alarm is disarmed 3 4 CHIRPS WITH LIGHT FLASH amp LED FLASHING IN A 2 FLASH HOLD SEQUENCE Alarm is disarmed and has been breached in your absence D BREACH WARNING The EXP 52 is equipped with BREACH WARNING to tell you upon disarming if the alarm has been triggered in your
Download Pdf Manuals
Related Search