User Manual
Contents
1. Light Sound Status Indicator Indicator Plugged in Charging Blinking Red Plugged in Fully Steady _ charged Green Ready for treatment Off rane Steady Beginning of treatment Gain 1 beep R Steady During treatment Green End of treatment Red 2 beeps 14 Seconds automatic pause the device is Red disabled Ready for next treatment Off 1 beep Treatment protocol Use no no GLOW once a day on the areas you want to improve 2 sessions on each area Set up Charging no no GLOW e Charge nolno GLOW for 5 hours before using it for the first time e Recharge nolno GLOW after each use until the red light on the On Off button stops blinking and the green light appears e While charging the On Off button will be red and blinking When the device is fully charged the On Off button will be steady green e For safety reasons your no no GLOW will not operate while plugged into the charger Before beginning treatment unplug the charger from the electrical outlet and disconnect no no GLOW Before you start e Because no no GLOW uses advanced Light amp Heat Energy technology you should feel a heat sensation during treatment On rare occasions it may become too uncomfortable In that case stop treatment and allow your skin to cool for several minutes before continuing e Use a mirror to make sure you accurately treat the desired area Operation Step 1 Remove the cover S2. Manufacturer STH Model No P6 084050 This device delivers an average of 12 000 treatments Standards safety and specifications Design and technical specifications are subject to change without notice International standards no no GLOW complies with the following international standards and directives Electrical safety Medical Electrical Equipment Part 1 General Requirements for Basic Safety and Essential Performance 3rd Ed IEC60601 1 2005 EN60601 1 2006 Electromagnetic compatibility IEC 60601 1 2 2007 EU directive The CE mark represents the compliance to the European Low Voltage Directive 2006 95 EC and the Electromagnetic Compatibility Directive 2004 108 EC nolno GLOW requires special precautions regarding EMC and needs to be installed and put into service according to the EMC information provided in the accompanying documents Service centers You are allowed to perform only the servicing listed in this user guide ANY OTHER SERVICING SHOULD BE PERFORMED BY AN AUTHORIZED SERVICE REPRESENTATIVE Radiancy Inc 40 Ramland Road South Suite 200 Orangeburg NY 10962 USA Tel 1 888 661 2220 1 845 398 1647 Fax 1 845 398 1648 Email info radiancy com Radiancy Israel Ltd 5 Hanagar street 45240 Hod Hasharon Israel Tel 972 9 775 7500 Fax 972 9 7757511 2008 2013 Radiancy Inc All rights reserved nolno GLOW User Manual Revision A00 May 2013 Part Number LIT 0
3. 0042 Note The information in this document is confidential and proprietary It is provided to customers and authorized representatives of Radiancy only The content of this manual is furnished for informational use only is subject to change without notice and should not be construed as a commitment by Radiancy Inc LHE is a registered trademark and Radiancy and no no are trademarks of Radiancy in the United States and in other countries The Quality Management System of Radiancy complies with the Quality Management Standard EN ISO13485 2012 Manufacturer Radiancy Israel Ltd peal 5 Hanagar street 45240 Hod Hasharon Israel Tel 972 9 775 7500 Fax 972 9 7757511 www radiancy com European Representative Obelis S A Av de Tervuren 34 Bte 44 B 1040 Brussels Belgium Tel 32 0 2 732 5954 Fax 32 0 2 732 6003 GSM 07545 4660 e mail mail obelis net C CE mark represents the compliance to the European Low Voltage Directive 2006 95 EC and the Electromagnetic Compatibility Directive 2004 108 EC Www howtonono com no no GLOW LIT 00042 Rev A00 May 2013
4. User Manual Instructions for Use amp Technical Description Index What is no no GLOW 4 Who should use nolno GLOW 4 How does it work oooooronnonnnm 5 Know your nolno GLOW 5 Comntraindications 0 6 WAMMINGS kauen nennen 6 PRECAUTIONS is unserem 7 Side effeets ara 8 How to use nolno GLOW 8 nolno GLOW indicators 9 Treatment protocol ou 9 SH Uhse 10 Before you Start eeeeeneeeneeeeeeeenenn 10 Operation cennin 11 Treatment summary 14 Cleaning instructions 14 Troubleshooting amp FAQ eee 15 Product labels u 17 Technical specifications 19 Standards safety and SPECIFICATIONS eeeeeeeeeteeeeeees 20 Service CONTELS cccceeseesseeeeeeeeeees 21 What is nolno GLOW nolno GLOW is a beauty tool that improves the skin s smoothness for a fresher looking appearance It is based on the same LHE Phototherapy technology used by dermatologists and skincare professionals around the world All you need to do is push a button and nolno GLOW will do the rest Use nolno GLOW anywhere you want on your face around the eyes between the eyebrows around the los on the forehead cheeks chin and jawline no no GLOW is your personal beauty secret for better looking skin Who should use nolno GLOW nolno GLOW helps your skin look smoother and fresher Anyone
5. ay on and the On Off button will be disabled e When you have finished your treatment i s recommended to use a moisturizer or serum such as NEOVA DNA Total Repair Remember Sometimes a slight redness appears on the treatment area This is an indication that the nolno GLOW treatment is working and will fade completely after a short while Keep these operating instructions for future reference Cleaning instructions In order to prevent infection thoroughly clean the nolno GLOW treatment head before and after each use Dip a clean piece of gauze or cloth into rubbing alcohol and gently wipe the treatment head Be sure the treatment head is completely dry before the next use Troubleshooting amp FAQ What do I do if My no no GLOW does not emit a pulse Check the power indicator to make sure your no no GLOW has been fully charged Recharge the unit ve charged my no no GLOW but it won t emit a pulse Check the charger s power cord and plugs for damage Try another outlet the one you were using may not be working properly Remember there is a 14 second pause after each pulse session If a problems persists or one that is not mentioned occurs contact nolno GLOW service center I feel a heat sensation during treatment nolno GLOW uses advanced Light amp Heat Energy technology therefore feeling heat sensation during treatment is normal If the heat sensation becomes too uncomfo
6. not use nolno GLOW if bathing or standing in water e Always unplug no no GLOW from its charger before use and during cleaning or maintenance e Do not use no no GLOW or the charger if their cases are damaged in any way e Use nolno GLOW only with its original charger e Keep away from flammable environments and hot surfaces such as stoves and radiators e Do not open the outer casing of no no GLOW This will void your warranty and may damage the unit e Do not drop or bump no no GLOW as this may cause internal damage to the unit Precautions e If at any time during the treatment the treatment head feels too hot remove the device from the skin and press the On Off button to end the treatment e Keep nolno GLOW and the charging unit away from water Side effects Clinical studies have shown that in rare cases users may feel skin irritation or an excessive heat sensation If you feel either of these remove the unit from your face and stop treatment How to use nolno GLOW Get ready to use no no GLOW Before using nolno GLOW there are a few things that will help make the treatment more comfortable and effective We advise you to test nolno GLOW on vour inner arm first to become familiar with the cool and heat sensations Make sure your skin is clean and dry before using nolno GLOW Use a mirror to make sure you accurately treat the desired area nolno GLOW indicators
7. rtable stop the treatment remove the device from the skin and allow your skin to cool for several minutes before continuing The treated area is red after treatment This is an indication that the nolno GLOW treatment is working The redness will fade completely after a short while My no no GLOW unit feels warm after a few uses why Because nolno GLOW uses heat it may become warm to the touch after a few treatments If this happens let it rest until it cools off and then begin again Will the light pulses hurt my eyes No the light pulses will not hurt your eyes However do not flash directly into your eyes It may cause a brief uncomfortable sensation Product labels This section describes the labels affixed to nolno GLOW and found in the user manual It is recommended that users review the meaning of these labels for everyday usage and in case any details are needed for service The table below briefly reviews a number of the internationally recognized symbols that are found on no no GLOW main unit and its external package Meaning Rasing ngli ad Located at the bottom Barcons of the device This label MUMMINI includes manufacturer Cer2 AlOX details Standard nternational Symbols and he systems Lot number ndicates the device manufacturer ndicates the need to consult instructions for use ee rer ndicates the Authorized Representative in the European Communit
8. tep 2 Place on the area you would like to treat and make sure the device is in full contact with your skin Step 3 Push the button until you hear a beep and the green light on the On Off button appears Step 4 Hold the device in place while it pulses Keep no no GLOW in full contact with the skin for the entire treatment During the 14 seconds pulse session you will feel a warming and cooling sensation If at any time your skin is uncomfortable turn the device off remove it from the skin and wait for several minutes before you continue the treatment Step 5 Remove the device after you hear 2 beeps and the green light changes to red Step 6 There is an automatic 14 second pause after each pulse session nolno GLOW is ready to perform another treatment when the red light goes off and you hear one beep Step 7 Place no no GLOW on the next area you would like to treat Continue until you have completed treating all desired areas of the face Step 8 When you finish treating all desired areas of the face for the first time repeat the treatments in the same areas Treatment summary e A single beep will sound 8 a green light will appear to signal the beginning of the treatment e A double beep will sound and the green light will turn red to signal the end of treatment e There is an automatic 14 second pause after each pulse session During that time the red light will st
9. woman or man over the age of 18 may use no no GLOW to improve their skin appearance How does it work nolno GLOW uses Light amp Heat Energy technology LHE proven to improve the skin s texture and tone as well as a cooling technology that soothes the skin during treatment You will love the unigue combination of refreshing cooling and soothing warming sensations on the skin Know your no no GLOW Main unit Treatment head On Off Button amp LED indicator Charger F Mo Charger connection Contraindications Do not use no no GLOW e If you are under the age of 18 e If you have epilepsy e If you are pregnant or nursing e If your skin is sensitive to heat or ight e On lesions such as moles warts infected areas open sores or wounds Warnings e Use no no GLOW for its intended use as described in this manual e Keep out of reach of small children e Strangulation may result from baby or child entanglement in the power cord e Choking may result from a child swallowing a small part that has become detached from the unit e Do not use no no GLOW if you are taking prescription medication for acne treatment Please consult a medical professional if you are on prescription medication e If you have an unexpected reaction please stop using no no GLOW and contact your medical professional e Do not use no no GLOW if it has fallen into water e Do
10. y ndicates the temperature imits to which the medical device can be safely exposed e Degree of protection against electric shock Type BF applied part CE mark represents the compliance to the European Low Voltage Directive 2006 95 EC and the Electromagnetic Compatibility Directive 2004 108 EC gt lt Protect the environment by not disposing of this product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only 22151 The C Tick mark represents compliance to Australian EMC Regulations Catalogue Number Indicates the manufacturer s catalogue number so that the medical device can be identified 2 A Serial Number Indicates he manufacturer s serial number so that a specific medical device can be identified Ge The package may be t 9 recycled IP22 IP22 according to IEC60529 Degrees of Protection Provided by Enclosures IP Code Bene Spectiications Light s source Halogen lamp with light a heat energy LHE D Wavelength range 480 2000 nm 6 J cm 0 36 Treatment time 14 seconds 10 4 seconds of cooling Classification Internally powered equipment type BF Mode of operation Short time operation Operating conditions Ambient temperature 40 Electrical requirements For battery charger Electrical input voltage 100 240VAC at 50 60Hz Power cord 2m
Download Pdf Manuals
Related Search