INSTALLATION MANUAL:
Contents
1. Horse INSTALLATION MANUAL HPI UNIVERSAL IGNITION 068K292 l oa HPI Kuilenstraat 97 3960 Bree Belgium gnition TEL 0032 089 46 74 39 FAX 0032 089 47 33 28 GSM 0032 0495 53 90 21 Email hpi hpi be Website www hpi be This part of the manual will explain how to get the stator cable through the opening in the carter First use a screwdriver or any other tool with a sharp tip to remove the red cap from the 3 pole connector of the stator Then pull off the yellow rubber seal Now slide the 3 pole connector through the opening in the carter The connector will only go through if positioned exactly like shown in the pictures to the right Is it through yet No Just wiggle it a bit Maybe use a little muscle Push Push But wait don t break it Is it through now Well congratiolations then You ve reached LEVEL 2 Scroll down to continue Please follow the guidelines in our normal installation manual on how to align and install the innerrotor system on your engine see next page Horse INSTALLATION MANUAL HPI UNIVERSAL IGNITION 068K292 l oa HPI Kuilenstraat 97 3960 Bree Belgium gnition TEL 0032 089 46 74 39 FAX 0032 089 47 33 28 GSM 0032 0495 53 90 21 Email hpi hpi be Website www hpi be 1 Place the piston at 2 to 4 mm before its most upper position OT see image 1 2 Fit the rotor and the stator so that both markings are aligned gt for rig2. ht rotating oe large marking from the left see image 2 gt for left rotating ie large marking from the right see image 3 Attention also mind the position of the HPI Logo on the rotor Don t tighten the screws yet 2 Make sure that the piston is in position and the markings are aligned If necessary make adjustments by rotating the base plate of the stator 4 Tighten all the screws 5 Connections the 3 pole connector of the stator to the 3 pole connector of the CDI the orange cable from the CDI to the HT coil the HT coil must be attached to the frame for mass together with the black cable the black white cable to the on off switch the optional yellow and yellow blue cables are for selecting a curve e cables loose curve 1 e cables connected curve 2 VvVvvVVY OT 2 4mm Image 3 left rotating REMARKS gt to gain performance you can try to vary between the 2 to 4 mm setting gt HPI can deliver a switch to put between the optional yellow and yellow blue cables making curve selecting easy gt the optional yellow and yellow blue cables may never come in contact with the frame mass
Download Pdf Manuals
Related Search