Meco CHARCOAL 2010 User's Manual
Contents
1. CORPORATION MODEL 2010 CHARCOAL MODEL 2120 ELECTRIC LO G K PORTABLE GRILLS For the Ultimate amp G O Flavor Experience ASSEMBLY AND USE MANUAL NOTICE MECO STRIVES TO BE A QUALITY SUPPLIER OF CONSUMER PRODUCTS IF WE HAVE INADVERTENTLY OMITTED ANY PARTS NEEDED FOR ASSEMBLY OR YOU NEED TROUBLESHOOTING INFORMATION PLEASE CONTACT US USING OUR TOLL FREE NUMBER MECO WILL SHIP REPLACEMENT PARTS MONDAY THRU FRIDAY WITHIN 24 HOURS SATURDAY amp SUNDAY ORDERS WILL SHIP THE NEXT WORK DAY THANK YOU FOR PURCHASING A MECO PRODUCT CONSUMER SERVICE DEPARTMENT MECO CORPORATION 1500 INDUSTRIAL ROAD GREENEVILLE TN 37745 USA IMPORTANT SAFEGUARDS WARNING FAILURE TO FOLLOW THESE SAFETY RULES MAY RESULT I N SERIOUS INJURY OR PROPERTY LOSS READ AND FOLLOW INSTRUCTIONS CAREFULLY BEFORE USING GRILL CHARCOAL SAFEGUARDS A WARNING Do not use charcoal for indoor cooking or A WARNING Keep small children away from your Grill 1 800 346 3256 24 HOURS 7 DAYS A WEEK 1 423 639 1171 TELEPHONE or write heating Toxic carbon monoxide fumes may accumulate and cause death A CAUTION Do not use gasoline kerosene or alcohol for igniting charcoal A CAUTION Do not use instant lighting charcoal to avoid burns A CAUTION Open the Hood carefully when cooking The hot air and steam trapped inside can burn A CAUTION Use a drip pan under the Charcoal Grill when using on a wood dec2. on a smooth clean surface Assembly Diagrams on back page Step 2 Model 2010 Attach Leg 1 to Bowl 2 by hooking in 2 slots under oval hole and rotating it til top hole in Leg aligns with side hole in Bowl At same time install Lock Bracket 3 against inside of Bowl Make sure the Bracket lip fits into the wide slot of the Bowl Put Bolt 4 through hole in Leg Bowl and Lock Bracket Attach Lock Nut 5 and tighten Repeat for other 2 Legs Set Bowl up on Legs Model 2120 Put Bolt 6 through inside bottom of Bowl 7 and through top of Base 8 Attach Lock Nut 5 from under Base Repeat for other three Nuts and Bolts and tighten Turn Bowl upside down Press Rubber Base Edging 9 around bottom edge of Base Set Bowl up on Base Put Bolt 6 through Bowl and through Lock Bracket 3 Make sure the Bracket lip fits into the wide slot of the Bowl Attach Lock Nut 5 and tighten Repeat for other two Lock Brackets Step 3 Model 2010 amp 2120 Put Bolt 4 or 6 through hole next to rectangular opening in Bowl 2 amp 7 and through oval hole in Cover Plate 10 Attach Acorn Nut 11 but only tighten so Cover Plate can slide within oval hole Cover Plate is standard on all models When Element is removed and grill used for Charcoal Cover Plate covers rectangular opening by sliding to left and hooking lip inside Bowl Step 4 Model 2010 Install Charcoal Pan 12 in Bowl 2 by sliding under Lock Bracket Bolts and dropp
3. about 2 turns at Element shield tab Lift Element remove Reflector Pan and Grease Catcher Wash them out wipe out bottom of Bowl and Element coils Wipe off the Control Replace the clean parts Re tighten Bolt and Acorn Nut Dispose of charcoal or wood ashes only after they are completely out
4. ing to bottom with Pan straight edge clearing the Bolt opposite Cover PARTS LIST DESCRIPTION PART Leg 17168600 Bowl Model 2010 175487 Lock Bracket 17168900 Bolt 10 24 x 5 8 03020103 Lock Nut 10 24 03039000 Bolt 10 24 x 1 2 03020102 Bowl Model 2120 175498 Base Table Top 175439 Edging Base 02033600 Cover Plate 17547100 Acorn Nut 03500055 Charcoal Pan 17541100 Cooking Grid 03522300 Grease Cup 03074501 Reflector Pan 17541000 Electric Element 03072701 Element Control 03072300 Bolt 10 24 x 1 03574900 Hood 175472 Vent Damper 171672 Handle Bracket 17165300 Wood Handle 03090000 Screw 8AB x 5 8 03042400 Owners Manual 03517504 anjaam MaM Plate side Install Cooking Grid 13 in Bowl on Lock Bracket Bolts and within Lock Brackets Model 2120 Place Grease Cup 14 in bottom of Bowl Install Reflector Pan 15 in Bowl same way as for Model 2010 Reflector Pan Step 4 Install Electric Element 16 by inserting box shield through rectangular opening from inside Bowl 7 and letting Element rest on Reflector Pan Put Bolt 6 from inside through round hole in Element shield tab and hole in Bowl Attach Acorn Nut 11 Turn Bolt til it just begins to tighten in the Acorn Nut Plug Element Control 17 into Element Install Cooking Grid 13 in Bowl resting on Lock Bracket Bolts and within Lock Brackets Step 5 Hood As
5. k ELECTRIC SAFEGUARDS 1 Read all instructions 2 Do not touch hot surfaces Use handles knobs or wear proper gloves Open Hood carefully when cooking to avoid burns from the hot air and steam trapped inside 3 To protect against electric shock do not immerse cord plug or Electric Element in water or any other liquid 4 Do not leave element on without cooking 5 Unplug Grill from outlet when not in use and before cleaning Allow to cool before cleaning or putting on or taking off parts Do not clean this product with water spray or the like 6 Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner Return to the nearest authorized service facility for examinations repairs or adjustment 7 The use of accessory attachments not recommended by the manufacturer may cause injuries 8 Do not let cord hang over the edge of table or counter or touch hot surfaces 9 Do not place cord on or near a hot glass or electric burner or in a heated oven 10 Extreme caution must be used when moving an appliance containing hot oil or other liquids 11 To disconnect appliance remove plug from outlet 12 Do not use appliance for other than intended use 13 Fuel such as charcoal briquettes is not to be used when Electric Element is in place 14 Do not use gasoline kerosene or alcohol for lighting charcoal 15 Use only properly grounded 110 120 V
6. lifting and carrying Grill To unlock turn N counter clockwise ALWAYS MAKE SURE GRILL IS PROPERLY LOCKED BEFORE LIFTING IT LOCK BRACKET BOLT USE AND CARE BREAK IN the element to remove the new appliance smell before cooking the first time Plug in the element set the control on High and burn it for about 5 10 minutes with the Hood off COOKING with electric is simple and similar to cooking with charcoal Cooking time varies slightly but no lighter fluid or charcoal clean up is needed For best results cook with Hood covered to preserve natural food juices and enhance smoke flavor Cook your faster hamburger hot dog steak favorites on High and small cornish hens or the like on Low or Medium Use a meat thermometer on whole meats when you can DAMPER VENTS control amount of smoke Open Vents halfway to full for Charcoal and just slightly for Electric For extra smoke flavor use hickory or mesquite chips sprinkled around Element coils Small wood chunks may be put on or touching the Element coils Soak wood chips or chunks in water 30 60 minutes before cooking Amount of chips or chunks vary to degree of smoke flavor you want and amount of food CLEAN UP is made easy by spraying Grid and Reflector Pan with cooking spray before cooking For added protection line bottom of Bowl with aluminum foil When Grill has cooled down wash Grid and outside of Hood and Bowl with warm soapy water NEVER USE OVEN CLEANER Loosen Bolt and Acorn Nut
7. olt outlet Always attach plug to appliance first then plug cord into the wall outlet To disconnect turn control to off then remove plug from wall outlet 16 Do not use longer detachable power supply cord or extension cord unless absolutely necessary However they are available and if you must use one the following care should be exercised in their use Use only a grounding type 3 wire 14 Ga cord with a marked electrical rating at least as great as the electrical rating of this appliance The cord should be surface marked with the suffix letters W A and bare a tag stating Suitable For Use with Outdoor Appliances Any plug connection to an extension cord should be arranged so that it will not drape over a countertop or tabletop where it can be pulled on or tripped over accidently Keep the length as short as possible 17 Use a protective weatherproof cover for outdoor storage or store indoors out of the reach of children 18 The Model 1512 5 Electric Cooking Elements are for use ONLY with MECO Models 5022 5024 5025 Water Smokers 19 Close supervision is necessary when any appliance is used by or near children 20 WARNING DO NOT USE CHARCOAL FOR INDOOR COOKING OR HEATING TOXIC CARBON MONOXIDE FUMES MAY ACCUMULATE AND CAUSE DEATH SAVE THESE INSTRUCTIONS MODEL 2010 2120 ASSEMBLY INSTRUCTIONS TOOLS NEEDED gt Phillips screwdriver 3 8 open end wrench or pliers Step 1 Take all parts out of box and lay them
8. sembly See 2010 Illustration Put Hood Lock Bolt 18 through side of Hood 19 With finger against Bolt Head attach Lock Nut 5 and tighten with wrench Make sure Bolt and Nut are very tight Note Smooth Bolt Head does not need screwdriver When Lock Nut snugs up Nut and Bolt tighten at same time Repeat for other two Bolts and Nuts around Hood Step 6 Put Bolt 4 or 6 through hole in Vent Damper 20 and through small hole in Hood 19 Attach Acorn Nut 11 from inside Hood Tighten Bolt and Nut so Vent Damper fits snug against Hood but can still rotate over large vent hole Repeat for Vent Damper Bolt and Acorn Nut on opposite side of Hood Step 7 Put Bolt 4 or 6 through one bottom hole in Handle Bracket 21 and through Hood 19 Attach Lock Nut 5 snug up Bolt and Nut Repeat for other Bolt and Nut on Handle Bracket and Hood Tighten both Bolts and Nuts Place Wood Handle 22 within Handle Bracket so holes line up Put Wood Screw 23 through Handle Bracket into hole in Wood Handle and tighten Screw Repeat for other side Place Hood on Bowl Grill is now ready for use but FIRST READ IMPORTANT SAFEGUARDS PAGE 2 REFERENCE MAIN ASSEMBLY FOR LARGE ITEMS MODEL 2010 CHARCOAL MODEL 2120 ELECTRIC Uy A A fs Y 8 a N 9 NOTE TO CARRY PORTABLE GRILL lock Hood to Bowl by HOOD LOCK BOLT turning Clockwise Line up Hood Lock Bolts with Bowl Lock Bracket Bolts This is proper position for
Download Pdf Manuals
Related Search