Lindy 20694 Computer Drive User Manual
Contents
1. Schliessen Sie die IDE Stromversorgungs und Audio Sound Kabel Ihres Laufwerkes an Entfernen Sie die Frontblende wenn Sie ein CD CD R W oder DVD Laufwerk einsetzen wollen Legen Sie das Laufwerk vorsichtig in die untere Geh useh lfte und schrauben Sie es mit 4 Schrauben fest Connectez le c ble IDE et l alimentation votre disque dur CD ROM CDRW ou lecteur DVD Connectez galement le c ble audio votre lecteur CD ou DVD Fixez ensuite le p riph rique l aide des 4 vis fournies Connettete il cavo IDE e l alimentazione al vostro HDD CD ROM CD R W o DVD drive e il cavo audio solo per drive CD CD RW e DVD Nel caso stiate installando un drive CD ROM CD R W o DVD collegate anche il cavo audio e rimuovete il pannello frontale Fissate poi il drive con le 4 viti incluse 3 Add the top cover to the base taking care for not to clamp the cables Attach the fixing rails starting at the front and working towards the back by pressing the clips into the holes Finally stick on the bottom labels Setzen Sie die Gehausehalften wieder zusammen und haken Sie die Geh useschienen an der Frontblende ein Dr cken Sie die Geh useschienen von vorne nach hinten vorsichtig in die vorgesehenen Aussparungen bis Sie an der R ckseite einrasten Befestigen Sie abschliessend die Produktaufkleber an der Unterseite des Geh uses Lorsque vous aurez install correctement la totalit des composants refermez les couvercle2. EIND Ye COMPUTER CONNECTION TECHNOLOGY USB 2 0 External Drive Box Firewire External Drive Box Installation Guide English Installationsanleitung Deutsch Manuel Utilisateur Francais Manuale d uso Italiano For Driver Installation please refer to the Software Installation Manual LINDY No 20694 20695 20698 42913 CC www LINDY com LINDY ELECTRONICS LIMITED amp LINDY ELEKTRONIK GMBH THIRD EDITION JUL 2003 Carefully prise the two fixing rails from the backside of the housing using a screwdriver Strip the rails off carefully from back to front Separate the top cover from the base Heben Sie die seitlichen Geh useschienen an der R ckseite des Geh uses mit einem Schraubenzieher vorsichtig an Heben Sie die Verschlussschienen vorsichtig von hinten nach vorne ab ffnen Sie dann die beiden Geh useh lften Retirez les s curit s des rails l aide d un tournevis plat Pousser les rails de logement lat raux en tirant vers l arri re Sfilare le rotaie facendo delicatamente pressione sulla parte posteriore del Box con un cacciavite Sganciate il guscio superiore dalla base IDE BUS Cable IDE BUS Cable Connect the IDE and Power Cable to your HDD CD ROM CDR W or DVD drive and the Audio Cable to your CD ROM CD R W or DVD drive If you use a CD ROM CD RW or DVD drive remove the front panel from the Housing Mount the drive carefully on to the base and secure using the 4 screws supplied
3. n the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced technician for help You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment Canadian Department of Communications RFI statement This equipment does not exceed the class B limits for radio noise emissions from digital apparatus set out in the radio interference regulations of the Canadian Department of Communications Le pr sent appareil num rique n met pas de bruits radio lectriques d passant les limites applicables aux appareils num riques de la classe A prescrites dans le r glement sur le brouillage radio lectriques publi par le minist re des Communications du Canada For Home and Office Use Tested to Comply with FCC Standards LINDY ELECTRONICS LIMITED amp LINDY ELEKTRONIK GMBH THIRD EDITION JUL 2003 LINDY No 20694 20695 20698 42913
4. ote USB 2 0 et il sera mis jour automatiquement Si le disque dur externe est reconnu correctement en tant que p riph rique USB 2 0 n essayez pas de r installer le pilote Pour les autres systemes d exploitation connectez le boitier externe et suivez les instructions Veuillez galement vous r f rer au manuel fourni pour l installation des pilotes sous diff rents syst mes Radio Frequency Energy Certifications European EMC Directive CE statement This equipment complies with the requirement for CE mentioned in the European Directive and Standards EN55022 and EN55024 FCC Warning This equipment has been tested and found to comply with the limits for a Class B Digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation betwee
5. s puis les rails lat raux Riposizionate il guscio superiore facendo attenzione ai cavi e reinserite le due rotaie di fissaggio e bloccatele facendo scattare le clips nelle loro sedi Per concludere attaccate l udesivo sul fondo del box OPERATION ENGLISH Driver Installation USB 2 0 Modern operating systems like Windows XP already include the necessary drivers provided your USB 2 0 Card is installed correctly and drivers are up to date If the external Drive is recognized correctly as a USB 2 0 device please do not install drivers again For other operating systems please plug in the External Drive Box and follow the instructions Please also refer to the enclosed Software Installation Manual and Installation CD of the chipset supplier Treiberinstallation DEUTSCH USB Moderne Betriebssysteme wie Windows XP mit installierter USB 2 0 Karte und aktuellen Treibern haben bereits alle notwendigen Treiber an Board Sollte das externe Laufwerk hier bereits als USB 2 0 Device erkannt werden und funktionieren so sollte keine erneute Treiberinstallation vorgenommen werden F r andere Betriebssysteme Schlie en Sie das Laufwerks geh use an und folgen Sie den Bildschirmanweisungen Orientieren Si sich gegebenenfalls am beiliegenden Software Installation Manual des Chipsatzherstellers sowie der Installations CD Installation du pilote FRANCAIS Les syst mes d exploitation actuels comme Windows XP incluent directement le pil
Download Pdf Manuals
Related Search